The normal and shear stresses acting on one plane passing through a point in a soil mass are 120 psi compression and 25 psi, respectively. On an orthogonal plane the stresses are 40 psi compression and 25 psi. (a) Draw the Mohr's circle for this stress condition. (b) What are the principal stresses?

The normal and shear stresses acting on one plane passing through a point in a soil mass are 120 psi compression and 25 psi, respectively. On an orthogonal plane the stresses are 40 psi compression and 25 psi. (a) Draw the Mohr's circle for this stress condition. (b) What are the principal stresses?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rod consisting of two cylindrical portions AB and BC is restrained at both ends. Portion AB is made of steel (E, =29x106 psi, as =6.5x106/F) and portion BC is made of aluminum (E, =10.4x10° psi, d a =13.33x10-6/F). Knowing that the rod is initially unstressed, determine the normal stresses induced in portions AB by a temperature rise of 110F. Answer in ksi. + 24 in. - -32 in.- A В 2--in. diameter 1-in. diameter
0.12
I need the answer as soon as possible
Problem 1 39 ft (): Given: A steel railroad track which was installed at 30° F. Let E = 29 x 10 ^6 psi & a = 6.5 x 10^-6 / ° F Find: If the temperature reaches 125 ° F, determine a) The normal stress in the rails which are welded together to form a continuous track. b) The normal stress in the rails assuming the rails are 39 ft. Iong with 1/4" gap between them.
The question is in the picture. Thanks
Situation #4: Steel railroad rails 12 m long are laid with a clearance 4 mm at a temperature of 8°C. At what temperature will the rails just touch? What stress would be induced in the rails at that temperature if there were no initial clearance? Assume a =11.7 um/m°C and E = 200 GPa. %3D
0.10
Given data: Maximum principal stress-38 MPa Minimum principal stress=32.5 Mpa Find maximum shear stress
The grain of a wooden member forms an angle of 15° with the vertical. Determine the in-plane shearing stress parallel to the grain using Mohr’s circle, assuming that τxy = 251 psi.Answer: 217 psi.
Someone can help me on this one. Thanks
A rectangular column of sides 0.4 m × 0.35 m , made of concrete, is used to support a compressive load of 2800 kN. Four steel rods of each 24 mm diameter are passing through the concrete as shown in figure. If the length of the column is 3 m, Esteel=200 GPaEconcreate=29 GPa a)determine the normal stress in the concrete b)determine the normal stress in the steel.
Show complete solution, include necessary figures. The major and minor principal stresses acting at a point are 80 psi compression and 20 psi tension.A. Draw the Mohr's circle for this stress combination.B. What is the maximum shear stress acting at the point and what value of normal stress acts on the plane?C. Determine the value of the normal and shear stress acting on a plane that is 30 degrees from the minor principal plane.