The intake in Figure below has cross-sectional area of 0.74 m2and water flow at 0.40 m/s. At  the outlet, distance D = 180 m below the intake, the cross-sectional area is smaller than at the  intake and the water flows out at 9.5 m/s into equipment. What is the pressure difference  between inlet and outlet?

Q: The pressure in the spinal fluid in the body is measured in the manner shown in the figure below. If…

A: Given, P=10 mmHg

Q: A fluid with a viscosity of 2.0 x 10-3 Pa s has a velocity of 1.48 m/s through a 12 m long pipe with…

A: Viscosity of the fluid η=2.0×10-3 Pa s Velocity of the fluid v=1.48 m/s Length of the pipe L=0.085 m…

Q: Most towns use a water tower to store water and provide pressure in the pipes that deliver water to…

A: Given data: Mass of the water, m=6.00×105 kg Height of the Smith’s house, h=7.00 m H=18.0 m Density…

Q: ater travels through a pipe at 8.22 m/s. The pipe contracts from a crossectional area of 2.5 m2 to…

A:

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A:

Q: A 6.1 cmcm diameter horizontal pipe gradually narrows to 4.4 cmcm . When water flows through this…

A: The initial diameter of the pipe is, d1=6.1 cm The final diameter of the pipe is, d2=4.4 cm The…

Q: A 5.7 cmcm diameter horizontal pipe gradually narrows to 2.9 cmcm . When water flows through this…

A:

Q: A horizontal water pipe goes from a large diameter to a small diameter and then back to the first…

A:

Q: sure sensor is used to measure the water level in a tank. The water density is 1000 kg/m3. What…

A:

Q: The vertical cross-section of a pipe with flowing water is shown in the diagram. The gauge pressure…

A:

Q: A hydraulic press can be used to compact material as shown in the figure. Both pistons have a…

A: Let F1 be the force on the smaller piston, F2 be the force on the larger piston, Īd1 be the diameter…

Q: A horizontal tube with water flowing in it at a speed of 1.50 m/s enlarges to a larger diameter…

A:

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A:

Q: Water travels through a pipe at 7.50 m/s. The pipe expands from a crossectional area of 2.2 m2 to an…

A:

Q: The water pressure at the base of the water tower shown in the figure is 4.5 bar. The water level is…

A:

Q: Water travels through a pipe at 11.0 m/s. The pipe expands from a crossectional area of 1.5 m2 to an…

A: To determine,What is the speed(v2) of the water in the second part of the pipe in ms-1and How much…

Q: A water intake at a pump storage reservoir (the gure) has a cross-sectional area of 0.717 m2. The…

A: Given data- Cross sectional area of intake A1=0.717 m2 The speed in intake V1=0.546 m/s The speed…

Q: The cross-xectional area of a small pipe at point A is 6 cm2 and at another point B is 2 cm2. If the…

A: Given, Cross-sectional Area at point "A" (AA)=6 cm2 Cross-sectional Area at point "B" (AB)=2 cm2…

Q: ter travels through a pipe at 10.5 m/s. The pipe expands from a crossectional area of 2.4 m2 to an…

A:

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A:

Q: Water travels through a pipe at 12.3 m/s. The pipe contracts from a crossectional area of 1.4 m² to…

A:

Q: Water travels through a pipe at 8.57 m/s. The pipe expands from a crossectional area of 2.8 m2 to an…

A: a) With respect to equation of continuity, the expression used to calculate speed of water in the…

Q: Choose the correct answer: 2.00 x 10-2 m 1.00 x 10-2 m Water is flowing through a horizontal…

A: When a liquid is flowing, if there is no inflow or outflow of energy, the total energy of the system…

Q: Water at a pressure of 3.85 x 105 N/m2 at street level flows into an office building at a speed of…

A:

Q: Water enters a pipe with a cross-section of 1.6 m2 and a velocity of 4.7 m/s.  What is the velocity…

A:

Q: Water is flowing in a pipe with a cross-sectional area of 8m2 with a pressure of 210 000 Pa and…

A: The situation of the pipe is shown below.

Q: Consider the figure above, taken from a Webassign HW problem on Fluids. The small piston has a…

A: Given: The cross-section area of the small piston  is 2 cm2. The area of the large piston is 800…

Q: A 5.8 cm diameter horizontal pipe gradually narrows to 2.9 cm . When water flows through this pipe…

A:

Q: A horizontal pipeline enlarges from a diameter of 6 in. at point A to a diameter of 12 in. at p B.…

A: Given that;At A:Diameter of pipe = 6 in.Water flow rate vA = 20 cu.ft per sec, 34560 cu. in. per…

Q: Water at a gauge pressure of P = 3.8 atm at street level flows into an office building at a speed of…

A: Ans:- Image-1

Q: 36. A pipe has a cross-sectional area of S, at point M, the pipe descends h = 1.6 m and %3D narrows…

A: We have the equations: PM+hρg+12ρv12=PN+12ρv22Amv1=0.2×v2ANv2t =0.2×v2×20=24⇒v2=240.2×20=6 m/s Hence…

Q: 40.0 cm2 10.0 cm² h k-

A: Venturimeter is used to find the the flow or discharge through any pipe with the help of pressure…

Q: Part A - Practice Problem: Determine the gauge pressure for a 1.0-cm-diameter faucet located next to…

A: The gauge pressure for a 1.0 cm diameter faucet is 4.27 atm or 4.27 x 10⁵ Pa

Q: A 6.6 cm diameter pipe gradually narrows to 4.0 cm. When water flows through this pipe at a certain…

A:

Q: Water flows with a constant speed through  pipe of constant cross-sectional area in the ground floor…

A: Part a: The pressure difference between top (P1) and bottom (P2) is given in terms of density of…

Q: A water intake at a pump storage reservoir (the figure) has a cross-sectional area of O.585 m2. The…

A:

Q: A pressure difference of 1.6 × 103 Pa is needed to drive water (n = 1.0 x 103 Pa-s) through a pipe…

A: Pressure difference is The viscosity is The radius of pipe is The volume flow rate is Find:The…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A: Given: The density of liquid, ρ=1.65 gcm3=1.65 gcm3×10-3 kg1 g×1 cm3 10-6 m3=1650 kgm3 The…

Q: The figure shows some sections of a pipe where fluid flows. The fluid flows through different cross…

A: Here we can apply equation of continuity.

Q: Water moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure…

A: a. write the Bernoulli’s equation at the lower section and the higher section.

Q: The pressure in a horizontal pipe is 2.02x105 Pa, and the speed of the water flowing in it is 0.40…

A:

Q: Water travels through a pipe at 12.7 m/s. The pipe contracts from a crossectional area of 2.2 m2 to…

A: Apply the continuity equation. A1V1 = A2V2 2.2*12.7 = 0.367*V2  V2 = 76.13 m/s

Q: 900gpm of water flows through a 1000ft long, 8 inch segment of unlined Class 52 ductile bron pipe…

A: Given: The velocity of water flow(v)= 900 gpm= 0.9 kgpm Length of class 52 iron (L1)=1000 ft=304.8 m…

Q: Water flows through a horizontal tube of diameter 2.7cm that is joined to a second horizontal tube…

A:

Q: rn=0.17 cm (nozzle radius)rh=0.95 cm (garden hose radius)Q=0.65 L/s (flow rate through the hose)…

A: The objective of the question is to calculate the maximum height to which water could be squirted…

Q: A pipe with a constant 5.00 cm diameter carries water flowing at 4.00 m/s down a 10.0-m hill. The…

A: