Please show a your work when sliding this physical applications question to help me better understand. Thank you The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the regionabove the curve y = 0.1² and below the line y = 280. (Here, distances are measured in meters.) Thewater level is 24 meters below the top of the dam. Find the force (in Newtons) exerted on the dam bykgmwater pressure. (Water has a density of 1000-and the acceleration of gravity is 9.8- (:)$₁2sec²m³

Answered: Image /qna-images/answer/839928c0-2dee-4b95-b1c9-782209a139f0.jpg

The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the region above the curve y = 0.12² and below the line y = 280. (Here, distances are measured in meters.) The water level is 24 meters below the top of the dam. Find-the force (in Newtons) exerted on the dam by kg water pressure. (Water has a density of 1000- m sec² m³ and the acceleration of gravity is 9.8- A.

The Deligne Dam on the Cayley River is built so that the wall facing the water is shaped like the region above the curve y = 0.12² and below the line y = 280. (Here, distances are measured in meters.) The water level is 24 meters below the top of the dam. Find-the force (in Newtons) exerted on the dam by kg water pressure. (Water has a density of 1000- m sec² m³ and the acceleration of gravity is 9.8- A.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

I need the answer as soon as possible
1) What does the specification "8.8" in the standard designation of a bolt mean? Specify values including units. 2) Name two groups of standards in addition to national, industry-wide standards and where they are valid. 3) Which three options exist for defining dimensional tolerances in a technical drawing?
need detailed and own language answer
Hello Sir,Good Evening. I have a question in my homework realated geometry tolerance lesson. The following below is my question. Please advice thank you. "What is the difference between position tolerance and orientation tolerance?"
3. What is the rule of thumb for discrimination in choosing the correct measurement tool?
Calculate the maximum limit if the tolerance is 0.004 cm and the minimum limit is 0.985 cm.
A pipe of diameter 400 mm carries water at a velocity of 25 m/s. The pressures at the points A and B are given as 29.43 N/cm2 and 22.563 N/cm2 respectively while the datum head at A and B are 28m and 30 m. Find the loss of head between A and B. Sketch the arrangement.
To which of the following geometric tolerance families does perpendicularly belong? Form Tolerance. Location tolerance. Profile tolerance. Orientation tolerance
Please fast answer
need detail and own language answer
-How many holes require drilling? -What is the center to center distance of the 6mm tapped holes? -What tap drill is used for holes marked Z? -How many surfaces are machine finished? -What are the dimensions of the face marked F & C? -What are the dimensions have symbols A, E &, B -In what dihedral angle is the drawing made? -What is the max and min dimensions of D -What is the tolerance of measurement D?
a) Name two groups of standards in addition to national, industry-wide standards and where they are valid. b) Which three options exist for defining dimensional tolerances in a technical drawing?