Calculate the maximum limit if the tolerance is 0.004 cm and the minimum limit is 0.985 cm

Q: On the toleranced rectangle below, what is the tolerance within which the to be parallel to the…

A: Parallel symbol describes a parallel orientation of one reference feature to a datum surface or the…

Q: Using the above drawing, apply an H7/g6 Sliding clearance fit to the Ø20 hole and shaft. Apply a…

A:

Q: Specify a cylindricity tolerance of .0004 for the largest cylindrical surface on the part in the…

A:

Q: There are two different indicated drawings in Fig.1. (1) Judge the tolerance principle they used…

A:

Q: I need these 2 parts answered pertaining to the print provided. If you can not answer all 2 parts,…

A: AP-001The diameter of the hole that is inclined 15 is ϕ0.25. It can be viewed in the section A…

Q: Determine the relative roughness of cast iron pipe with inner diameter 3.1 inches. Your answer…

A: Given Internal Diameter (D) = 3.1 inches                                    = 3.1 * 25.4 mm…

Q: In the following figure, add the tolerance zone and limits of size for both parts.

A:

Q: Using the 10% rule–of–thumb for determining gagemaker’s tolerance for a plug gage, determinethe GO…

A: Given data: Calculate the maximum hole dimension as follows: Calculate the minimum hole dimension…

Q: If the tolerance in the figure below is for a pin .525 in diameter, what is the total positional…

A:

Q: (USCS UNITS) A GO/NO GO PLUG GAUGE WILL BE DESIGNED TO INSPECT A 2.000 +/- 0.002mm DIAMETER HOLE. A…

A: Given data,

Q: I need help with question number 15 that is pertaining to the print provided.

A: 15.The unidirectional system is used here for the dimension placing. The unidirectional system is…

Q: 2. The cross-sectional shape of this feature must be round within a radial tolerance zone of .002"

A: To find:  sketch a feature control frame that matches the description given.: 2. The cross-sectional…

Q: Apply the necessary symbology to establish the required tolerance and datum features to control the…

A:

Q: Calculate the tolerances and allowances for a shaft with a diameter of 40 mm with a tolerance area k…

A:

Q: Identify which is the GO plug and which is the NO GO.   Please explain

A: As per ISO standard design of go-no go gauge will follow as below.for solution refer below images.

Q: For the following part sizes and geometric tolerances, determine the appropriate geometric tolerance…

A: A.    Geometric tolerance = 0.005 + 0.007                                     = 0.007…

Q: -0.0025 1. The dimensions for the shaft size are o50-0.0037 mm and the hole size are +0.000 mm. Find…

A: We are suppose to solve only one question. Please post other question as a separate question.

Q: If the pin in the drawing below is produced at Ø.498, what is its total positional tolerance? C…

A: Given data as per the question Pin diameter =0.498

Q: dimension the distance between the holes

A: Bilateral tolerance B = 1.625T = 0.006Bilateral tolerance means that the dimension can vary in both…

Q: Refer to the Ø.750 dimension. A) Where is the tolerance specified ?…

A: 1—position 2 – the shape of the tolerance zone