The burner gas from a sulfur burner analyzes 9.2% SO2, 7.13% O2 and 83.67% N2. The raw sulfur charged contains 90% pure sulfur and analysis of the cinder shows 15% unburned S.  What is the percent excess air based on conversion to SO3? a) 65% b) 276.25%    c) 12.84%     d)  65.93%

Q: Please trace this process on the given psychrometric chart. A crystalline solid is to be dried from…

A: Given :1. Stream A: 2. Stream B: 3. Stream C: 4. Stream D: %Humidity = 30%, constant-wet bulb

Q: 1. air at 90 ° c and 5% RH is passed over the cooling coil so that the dry ball air temperature…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: A combustion efficiency test done on a gas-fired boiler indicated that the stack temperature is…

A: Boiler is gas fired type.Stack temperature = 7500FCO2 content in flue gas = 7%Part a) Excess…

Q: 3. A ternary blend of gasoline (90% octane no), alcohol (75% ethanol, 25% methanol) anc benzole (75%…

A:

Q: What is the percent purity of the obtained crystal after one recrystallization?

A: For solubility of A, the amount recovered in grams is estimated. For solubility of B, the amount…

Q: If (15.95g) of copper sulfate CuSO4 is dissolved in (1L) of water, and the heat given off from the…

A: When copper sulfate is dissolved in 1L of water, the reaction is:

Q: 7. A liquid fuel composed of C 86%, H 12%, S 2% is combusted. After 100 kg of its combustion,…

A: Basis: 100 kg of liquid fuel and complete combustion It contains 86 kg C , 12 kg H and 2 kg of S…

Q: Air at a dry ball temperature of 75 ° C and RH 4% is passed over the cooling coil until the air ball…

A:

Q: Iron can react with oxygen to give iron (iii) oxide. If 5.58 g of Fe is heated in pure oxygen to…

A:

Q: A flue gas from a certain furnace burning a fuel of negligible nitrogen content is found by analysis…

A:

Q: Propane gas at room temperature is burned with enough air so that combustion is complete and gases…

A: We have to find the no. of moles of gas are available for drying per mole of propane burned. Given…

Q: A liquid mixture containing 50 mole % each of benzene and toluene at 40 degrees Celsius is to be…

A: Flash vaporization is a process in which a liquid mixture is rapidly vaporized by decreasing its…

Q: In the air conditioning process in the humidifier, air at a dry bulb temperature of 20 ℃ and RH of…

A: Air conditioning process in the humidifier: Given Data  Dry bulb temperature (DBT) =  20 ℃ RH1 =…

Q: The air conditioning process in the humidifier, air at a dry bulb temperature of 40 ° C and RH of…

A: Initial dry bulb temperature of the air, Tdb1 = 40°C Initial relative humidity of the air, RH1 = 40%…

Q: A hydrocarbon is burnt with excess air. The Orsat analysis of the flue gas shows 10.81% CO2, 3.78%…

A: When a hydrocarbon, which is composed of carbon (C) and hydrogen (H), is burned in air, it reacts…

Q: Air at 35 'C and RH 45% is flown into the heating coil so that the temperature of the dry balls is…

A: Given that, The initial temperature of air T1 =35oC Relative humidity of air RH = 45% Dry bulb…

Q: 3B.1(b) Calculate AStot when two iron blocks, each of mass 1 5 °C, are placed in contact in an…

A:

Q: An important raw material for the industrial production of sulphuric acid is pyrite, FeS 2 .…

A: Amount of the pyrite = 1000 kg Yield of the process = 97 % Concentration of sulfuric acid = 98 % by…

Q: The same amount of heat is added to each metal. Which metal reaches the lowest final temperature? --…

A: heat(q)=mc∆T∆T=qmc

Q: Equal masses of the three metals shown below are all initially at 25oC. copper (c = 0.385 J/goC)…

A: From the definition of specific heat we know, specific heat is measure of amount of heat required…

Q: The air has a dry ball temperature of 40 ° C and a wet bulb temperature of 20 ° C is initially…

A:

Q: Air having a dry ball temperature of 30°C and a wet bulb temperature of 20°C is initially heated in…

A:

Q: Estimate the thermal properties of a food with the following composition: carbohydrate 52.0%,…

A: Note: Since we are entitled to answer only three sub-parts, we’ll answer the first three as no…

Q: Flash vaporization process is used to vaporise 70mole% of feed which contains 65 mole% of benzene…

A: The Flash vaporization process is a type of distillation process in which is added to the feed…

Q: The air conditioning process in the humidifier, air at a dry bulb temperature of 25 ° C and RH of…

A: Given: Dry bulb temperature, Tdb = 25°C Initial air conditions: Relative humidity, RH1 = 35% Final…

Q: The air has a dry ball temperature of 34 °C and a wet bulb temperature of 20 °C is initially heated…

A: Intial DBT of air, T1=340CFinal DBT of air, T2=800CWB of air=200CDBT of corn kernals,…

Q: The exhaust gas from a furnace gives the following Orsat analysis: 13.6% CO2, 2.4% cO, 2.8% O2, and…

A: Basis : 100 moles of exhaust gas- hence, N2 = 81.2 moles hence O2 fed = 81.20.79×0.21 = 21.585 moles…

Q: 100 k/moles of Heptane is burned with 40% excess air. Seventy percent reacts to form CO₂ and the…

A: Given data: Number of moles of heptane = 100 kmol Heptane reacts to form CO2 = 70 % Heptane reacts…

Q: Considering the very slow cooling (i.e. equilibriumcooling) of a 1.5 wt% C alloy; a) Draw schematic…

A:

Q: For an industrial process where a large amount of heat is required, a large combustion chamber is…

A: Dear User! The question does not state the relative composition of benzene and methyl alcohol in the…

Q: Q.1 Benzene gas (C6H6) is burned with 95 percent theoretical air during a steady- flow combustion…

A:

Q: In order to increase the heating value per unit volume in a gas-fired furnace, a mixture of natural…

A: Given that, The composition (Mole%) of Natural gas: CH4 : 85% C2H6 : 10% N2 : 5% The composition…

Q: Pure sulfur is burned with 30% excess air. As a result of combustion, 7.23% SO 3, 4.06% SO 2, 7.06%…

A: Given: Pure sulfur (S) is burned with 30% excess air by the following reactions: S + 32O2  →  SO3S…

Q: The air has a dry ball temperature of 32 ° C and a wet bulb temperature of 24 ° C is initially…

A: Initial dry bulb temperature of air, T1=320CFinal dry bulb temperature of air, T2=800CInitial wet…

Q: Accetylene gas (C2H2) is often used by plumbers,welders,and glass blowers because it burns in oxygen…

A: Given data:- Acetylene gas is used by plumbers,welders,and glass blowers because it burns in oxygen…

Q: FIGURE 6.3: Phase diagram for the tin-lead alloy system. Temperature °C 300 α+L 200-4 183°C 100…

A: a) Label the liquidus and solidus lines (2 pts)Liquidus line: It is that line above which the alloy…

Q: 5. Given 2Cuo→204 +0 AH° = 314.6 kl a. Determine the heat of formation of Cuo. b. Calculate the…

A: (a): Given that 2CuO(s) →2Cu(s) + O2 (g),   and standard heat for reaction is , ∆H⁰ = 314.6 kJ This…

Q: One of the key components in the manufacture of Portland ce-ment is Ca3SiO5, a compound that is…

A: The oxidation state of each of the elements in the given compound is to be mentioned.

Q: Carbon tetra chloride is to be removed from a polymer solution by bubbling dry air through it at 297…

A: When a liquid and its vapor are in contact in a closed system, they can reach a state of balance…

Reactive Processes

Reactive processes are the processes in which any reaction occurs. The reactions can be any combination reaction, decomposition reaction, combustion reaction, oxidation reaction, reduction reaction, neutralization reaction, displacement reaction, or double displacement reaction.