th a rate of 64 ft^3 /min. A pressure gauge placed on a section of the pipe where the diameter is 4 inches reads 16 lb/in^2 . Determine the pressure in a section of the pipe where the diameter is constricted to 2 inches. Show the Figure/FBD, Give

th a rate of 64 ft^3 /min. A pressure gauge placed on a section of the pipe where the diameter is 4 inches reads 16 lb/in^2 . Determine the pressure in a section of the pipe where the diameter is constricted to 2 inches. Show the Figure/FBD, Give

Related questions

Q: What is the flow-rate for a circular pipe that has a radius of 2.2 cm and carries water at a flow…

Q: A large truck tire is inflated to a gauge pressure of 62 psi. The total area of one sidewall of the…

Q: The figure belows shows a closed tank holding air and oil to which is connected a U-tube mercury…

A: L1 = 2 ftL2 = 0.5 ftL3 =1.25 ftThe density of oil, ρoil =55 lb/ft3 The density of mercury, ρmercury…

Q: Water flows steadily through a pipe with a rate of 64 ft3 /min. A pressure gauge placed on a section…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

Q: A horizontal water pipe goes from a large diameter to a small diameter and then back to the first…

Q: A continuous pipe has a reduction in area; that is from 45 cm2 to 20 cm2. What is the speed of water…

Q: sure sensor is used to measure the water level in a tank. The water density is 1000 kg/m3. What…

Q: The figure belows shows a closed tank holding air and oil to which is connected a U-tube mercury…

A: Given, L1=4ftL2=0.5ftL3=1.75ft Oil density, ρoil=55lb/ft3 Mercury density, ρmercury=845lb/ft3 For…

Q: A non-viscous fluid with density ρ = 0.810 g/cm3 is flowing in a horizontal direction as shown in…

A: Write a given values of this question. ρ=0.810g/cm3=0.810×10-310-6kg/m3=0.810×103…

Q: Mercury is poured into a U-tube as shown in Figure a. The left arm of the tube has cross-sectional…

A: Given: Area A1=10.6 cm2 Area A2 =4.90 cm2 amount of water poured in right arm m…

Q: The vertical cross-section of a pipe with flowing water is shown in the diagram. The gauge pressure…

Q: A hydraulic press can be used to compact material as shown in the figure. Both pistons have a…

A: Let F1 be the force on the smaller piston, F2 be the force on the larger piston, Īd1 be the diameter…

Q: A person who weighs 671 N is riding a 85-N mountain bike. Suppose the entire weight of the rider…

A: Given data: Weight of person = 671 N Weight of mountain bike = 85 N Pressure in each tire (P) =…

Q: 1.6 A manometer connects an oil pipeline and a water pipeline, as shown. Determine the difference in…

A: Pressure due a column of fluid is given by P = ρgh, where ρ = the density of the fluid, g =…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

Q: What is the minimum weight (in lbs) a bowling ball with diameter of 8.5 inches would need to have in…

A: For any object to sink density of body ≥density of water extreme case :(just start to sink density…

Q: What is the pressure gradient in this narrower portion of the tube in kPa/m

Q: Water travels through a pipe at 7.50 m/s. The pipe expands from a crossectional area of 2.2 m2 to an…

Q: Oil is flowing through a pipeline at a speed of 1.4 m/s. If the diameter of the pipe is 0.12 m, what…

A: Given Speed = 1.4 m/s Diameter of the pipe = 0.12 m Radius of pipe = 0.06 m = 6 x 10-2 m

Q: At the bottom of a large cylindrical tank filled with fresh water the gauge pressure is 14.6 psi.…

Q: n the figure below, non-viscous fluid is flowing through a pipe. At point 1 and 2, the cross…

A: Given that the value of cross section area at point 1 and cross section area at point 2 and also…

Q: The intake in Figure below has cross-sectional area of 0.74 m2and water flow at 0.40 m/s. At the…

A: Given : cross-sectional area = 0.74 m2 water flow rate, v1 = 0.40 m/s v2 = 9.5 m2 At the outlet,…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

Q: The figure belows shows a closed tank holding air and oil to which is connected a U-tube mercury…

Q: Find the gauge and absolute pressures in the balloon and peanut jar shown in the figure below,…

A: Guage pressure is pressure above or below atmospheric pressure

Q: Part B: A pressure gauge reads 50 kPa as water flows at 11.0 m/s through a 16.8-cm-diameter…

Q: Pressure in the spinal fluid is measured as shown in the figure, by connecting a small tube between…

A: a) Convert the reading of the water manometer in cm H2O. P=9.5 mm HgP=(9.5 mm Hg)(133.322 N/m21 mm…

Q: A diver is diving to a depth of 20 m below the surface of the sea. Assume the relative density of…

A: Given: The depth of the diver is 20 m. The relative density of the seawater is 1.02. The density of…

Q: 40.0 cm2 10.0 cm² h k-

A: Venturimeter is used to find the the flow or discharge through any pipe with the help of pressure…

Q: Estimate the average blood pressure in a person’s foot if the foot is 1.23 m below the aorta, where…

Q: For the tank in Figure 1, a. Calculate the depth of the oil if the depth of the water is 2.80 m and…

Q: A cylindrical tank with a large diameter is filled with water to a depth D = 0.30 m. A hole of…

Q: At the bottom of a large cylindrical tank filled with fresh water the gauge pressure is 12.5 psi.…

A: Gauge pressure at the bottom of cylindrical tank filled with water = 12.5 psi Let the height of…

Q: The figure below shows a horizontal pipe with a varying cross section. A liquid with a density of…

A: Given: The density of liquid, ρ=1.65 gcm3=1.65 gcm3×10-3 kg1 g×1 cm3 10-6 m3=1650 kgm3 The…

Q: if a pound of seawater has a depth of 15.3 feet, what is the gauge pressure at 4.3 feet from the…

Q: Use g = 10 m/s2 density of water is 1,000kg/m3 air pressure at sea level = 105 Pascal Consider…

Q: Water flows steadily through a pipe with a rate of 64 ft3 /min. A pressure gauge placed on a section…

A: Bernoulli's theorem states that for an ideal, incompressible fluid flowing through a cross-section…

Q: Pressure = weight density × depth The depth of water behind the Hoover Dam is 220 m. Find the water…

A: write the expression for pressure.

Q: Hi, I only need help with PART B of this problem. The pressure at the bottom of a cylindrical…

A: Given cross-sectional area = A = 47.5 cm2 = 47.5 x 10-4 m2 density of fluid = ρ = 460 kg/m3…

Question

100%

Water flows steadily through a pipe with a rate of 64 ft^3 /min. A pressure gauge placed on a section of the pipe where the diameter is 4 inches reads 16 lb/in^2 . Determine the pressure in a section of the pipe where the diameter is constricted to 2 inches. Show the Figure/FBD, Given and Formula used.

Expert Solution