Synchronous Motor Power Correction The synchronous motor using 150-kilowatt real power so we have to find these three conditions. 1. If synchronous motor operating at 0.85 lagging power factor then what the value of transmission line? 100 kW 0.78 PF Ind. motor lagging 200 kW 0.8 PF lagging 2. If synchronous motor operating at 0.85 leading power factor then the value of current will be? lnd. Infinite bus Transmission line motor 3. If the power loss of transmission line is given. PL =31,R. Synchr. 150 KW PF=? motor Plant What will be effect of these losses on first two conditions? st 1s et ts et ts

Synchronous Motor Power Correction The synchronous motor using 150-kilowatt real power so we have to find these three conditions. 1. If synchronous motor operating at 0.85 lagging power factor then what the value of transmission line? 100 kW 0.78 PF Ind. motor lagging 200 kW 0.8 PF lagging 2. If synchronous motor operating at 0.85 leading power factor then the value of current will be? lnd. Infinite bus Transmission line motor 3. If the power loss of transmission line is given. PL =31,R. Synchr. 150 KW PF=? motor Plant What will be effect of these losses on first two conditions? st 1s et ts et ts

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The core losses in the transformer are also called O Variable losses O Winding losses O Constant…

A: Core losses in the transformer is called?

Q: A synchronous generator having no-load frequency of 51HZ and droop constant of 0.5Hz/MW is…

Q: A three phase Y connected synchronous motor, 6600 V L-L , delivers 500 KW to the full load . Its…

A: Given data, Line Voltage, VL = 6600 V. Output power, Pout = 500 kW. Efficiency, η = 83% = 0.83.…

Q: Vith aid of diagram, derive and proof that the internal generated voltage of a synchronous generator…

Q: Kindly send solution. An inductance of 1 henry and a resistance of 2 ohms are connected in series…

A: The inductance,L=1 H The value of the resistor, R=2 Ω The battery voltage, VB=6e-0.0001 V

Q: /During the test of shunt excited generator the voltage initially must be adjusted to 220V . then…

A: When the test of the shunt excited generator, the voltage initially must be adjusted to 220 v. then…

Q: Q.2: A 3-phase 500V, 50 Hz star-connected synchronous machine has asynchronous impedance of (…

A: Given: V=500V Z=0.4+j4 ohm Ra=0.4 ohm Xs=4 ohm From the given data we cannot find Ia, load angle and…

Q: determine (a) bus frequency (b) load on each machine.

Q: 4.1Two synchronous generators need to be connected in parallel to supply a load of 10 MW. The first…

A: The solution is given below

Q: A 1000-kVA, 3300-V, three-phase, Y-connected, synchronous generator is operated at rated speed to…

Q: I already solved for the 0.8pf lagging. My question is for voltage regulation with 0.8pf leading!…

Q: The power factor of a load of 500 kW is 0.6 lagging. It is desired to improve this power factor to…

Q: A: A synchronous generator of supplies a motor of 50 MVA, 22 kV, and 0.2 pu transient reactance. The…

A: A synchronous generator of 100 MVA, 22 kV, and 0.25 pu transient reactance supplies a motor of 50…

Q: hronous motor draws 250 A at a line to line voltage of 4000 V and 1.0 power factor from a large…

A: The voltage equation in case of synchronous motor in case of unity power factor:…

Q: Q/ During the test of separately excited generator the speed of rotation must be held constant and…

A: During the test of separately excited generator the speed of rotation must be held constant and the…

Q: A 50HZ, synchronous generator is connected to infinite bus through a transmission line. The pu…

Q: A three-phase A-connected synchronous generator is rated at 130 MVA, 12.8 kV, 0.9 PF lagging, and 50…

A: a) TorqueTshaft=PinputFull loadωsTshaft=S×cosϕ4πfPTshaft=130M×0.94π×504Tshaft=0.745N-m b) Load…

Q: Explain the working principle of the asynchronous generator. please write the answer with…

A: Asynchronous Generator: A single induction machine can be used as an induction…

Q: A load of 500 kW has a power factor of 0.6 lagging. Combined power factor is to be 0.9 using over…

A: We got an 500 KW load with, Load power (P1) = 500 KW Load power factor (Cos ϕ1) = 0.6 Synchronous…

Q: Problem- A single phase induction motor draws 12 MW power at 0.6 lagging power factor. A capacitor…

A: Given, The induction motor draws power, P=12 MW The operating power factor without the capacitor,…

Q: A 50HZ, synchronous generator is connected to infinite bus through a transmission line. The pu…

A: Given internal voltage = 1.2 P.u. Terminal voltage = 1p.u. Total reactance = 0.6 p.u.

Q: Synchronous generator can operate at any speed since the number of poles and the frequency is fixed…

Q: you show how we solve the equations 1,2 and 3 to get the step 3?

A: v1=52i0,2v1+v3=130i0,11v3=480+126i0.

Q: For two parallel synchronous generators of the same size and same droop in frequency-Active Power…

A: for two parallel synchronous generators of the same size and same droop in frequency active power…

Q: Q8) Consider a source with three symbols of probabilities 0.5, 0.4 and 0.1. Obtain the Fano code and…

A: We need to find code words and efficiency for given probability .

Q: A load of 500 kW has a power factor of 0.6 lagging. Combined power factor is to be 0.9 using over…

Q: A three-phase asynchronous motor operating at 960 Hz frequency was measured at 890 rpm at no-load…

Q: for the Steady-State Operation of Buck DC-DC Converter Describe the nature of the current through…

A: The output structure of the Buck DC-DC converter is shown below:

Q: A power system consists of 4 synchronous generators of 200 MVA, 10 kV in parallel, each with a power…

A: The rating of each generator is given as 200MVA, 60 Hz, Drop of 8Hz from No load to full load. Now…

Q: A 1200 KW,60 Hz synchronous alternator A is in parallel with a 400 kW,60 Hz alternator B.Both…

A: The load supplied by the alternator A is three-fourth of the 1000 kW bus, the load supplied is,…

Q: Example: A 10 MVA, 3-phase, Y-connected, two-pole, 60 Hz, 13.8 KV, line to line turbo generator has…

A: Turbo Generator Turbogenerator is a set of turbine and generator which converts mechanical energy…

Q: For a turbine that is connected to 50 Hz alternator, rated speed is 600 rpm. For an alternator poles…

A: Given data:Required information:

Q: A 50 kVA, 500 V, single phase alternator gives 700 V on open circuit at the field current of 15 A.…

Q: A three-phase synchronous generator is driven by a gas turbine. The synchronous reactance is X=4 2.…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Demonstrate over compound flat compound and under compound DC generator with the help of circuit…

Q: Q.5 Explain why are some parts of electrical machines laminated? [CO-1; CO-3]

A: Electrical machines can be either generator or motors. They can be either Ac machines or DC…

Concept explainers

Synchronous Motor

The synchronous motor is an AC electric type motor where at a steady-state the shaft rotation is synchronized with the supply current variable-frequency. To an integral number of AC cycles, the rotation period is exactly equal. The stator of the motor in the synchronous motor contains multi-phase AC electromagnets due to which a magnetic field is created that rotates in time with the oscillation of the line current. The rotor contains a permanent magnet and the rotor rotates in synchronization with the stator field at the same rate and provides the second synchronized magnetic field which is rotating in nature as a result. When the synchronous motor is supplied with independently excited multi-phase AC electromagnets on both the rotor and the stator, it is termed as a doubly-fed machine. The most widely used AC-type motors are the synchronous AC motor and the induction AC motors.

Question

100%

Synchronous Motor Power Correction
The synchronous motor using 150-kilowatt real
power so we have to find these three conditions.
1. If synchronous motor operating at 0.85 lagging
power factor then what the value of transmission
Ind.
motor
100 kW
0.78 PF
line?
lagging
200 kW
0.8 PF
lagging
2. If synchronous motor operating at 0.85 leading
power factor then the value of current will be?
Ind.
Infinite bus
Transmission line
motor
3. If the power loss of transmission line is given.
Synchr.
150 kW
PF=?
Pu =312 R
motor
Plant
What will be effect of these losses on first two
conditions?
<t ts et ts et ts
1 13

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step by step

Solved in 7 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 300 MVA, Synchronous generator has a moment of inertia 49000 Kg-m2 and Kinetic Energy 2300 MJ. The synchronous speed of generator is
3. I need help with this practice problem
Help fast
A 150 MVA, Synchronous generator has a moment of inertia 47000 Kg-m2 and Kinetic Energy 1600 MJ. The synchronous speed of generator is
The power factor of a load of 400kW is 0.4 lagging. It is desired to improve this power factor to 0.7 lagging by using the over excited synchronous motor. If the synchronous motor takes 70 kW,find, 1.Power factor of synchronous motor 2.Leading kVAr of synchronous motor 3.kVA of synchronous motor.
A 300 MVA, Synchronous generator has a moment of inertia 49000 Kg-m2 and Kinetic Energy 2300 MJ. The synchronous speed of generator is
Synchronous Motor Power Correction The synchronous motor using 150-kilowatt real power so we have to find these three conditions. Assume 1. If synchronous motor operating at 0.85 lagging power factor then what the value of transmission line? VL = 480 V 100 kW Ind. 0.78 PF motor lagging 200 kW 0.8 PF lagging 2. If synchronous motor operating at 0.85 leading power factor then the value of current will be? Ind. Infinite bus Transmission line motor 3. If the power loss of transmission line is given. Synchr. 150 kW PF=? Pu =312 RL motor Plant What will be effect of these losses on first two conditions?
Attached are the examples mentioned in the question below. These are examples from a textbook, not a graded exam or assignment so please do not reject. Question: The synchronous machine of Examples 5.1 and 5.2 is to be operated as a synchronous generator.For operation at 60 Hz with a terminal voltage of 460 V line-to-line, calculate the field currentrequired to supply a load of 85 kW, 0.95 power-factor leading. given Solution:46.3 A Can someone explain how to reach this answer? I've tried to figure it out in several ways but the closest answer I got was 54.6 A. Thank you!
Show that an alternator running in parallel on constant-voltage and frequency bus-bars has a natural time period of oscillation. Deduce a formula for the time of one complete oscillation and calculate its value for a 5000-kVA, 3-phase, 10,000-V machine running at 1500 r.p.m. on constant 50-Hz bus-bars. The moment of inertia of the whole moving system is 14,112 kg-m2 and the steady short-circuit is five times the normal full-load value. ANSWER IS [1.33 second]
A synchronous generator is connected to an infinite bus with excitation voltage Ef = 1.3 pu. The generator has a synchronous reactance of 1.1 pu and is delivering real power (P) of 0.6 pu to the bus. Assume the infinite bus voltage to be 1.0 pu. Neglect stator resistance. The reactive power (Q) in pu supplied by the generator to the bus under this condition is
Two Generators rated 200 MW and 400 MW are operating in parallel. The droop characteristics of their governor are 4 % and 5% respectively fro no load to full load. The speed changers are so set the governor operate at 50 Hz sharing the full load of 600 MW, in the ratio of their ratings. If the load reduces to 400 MW, how will it be shared among the generators and what will the system frequency be? Assume free governor system. The speed changers of the governors are reset so that the load of 400 MW is shared among the generators at 50 Hz in the ratio of their ratings. What are the no-load frequencies of the generators ?
Two balanced three-phase motors in parallel, an induction motor drawing 400 kW at 0.8 pf lagging and a synchronous motor drawing 150 KVA at 0.9 pf leading, are supplied by a balanced, three-phase, 4.16-kV source. Line impedances between the source and the load are neglected. a) Determine the power factor of the combined motor-load. b) Determine the magnitude of the line current in each motor. c) Determine the magnitude of the line current delivered by the source.