Static VLAN 44 Dynamic VLAN F Voice VLAN #

C language is recomended

In C language! Write a code that makes the MSP430 blinks the red LED, the Blue LED  and the Green LED at the same time.

H4

using emulator8086 provide he code follow the instruction below

*timescale Ins / lps module mux (input I0, Il, slct, output out); wire slct n; wire out_l; wire out_2; not (slct_n, slct); and (out_1, IO, slct_n); and (out_2, Il, slct); or (out, out_1, out_2); endmodule 'timescale Ins / lps module testbench (); reg 10, I1, slct; wire out; integer i; mux dt (.10 (I0), .Il (Il), .slct (slct), .out (out)); initial begin 10=0; Il=0; slct=0; Smonitor ("slct=%0b 10=$0b Il=%0b out=30b",slct,I0, I1, out); for (i=0; i<8; i=i+l)begin {slct, 10, I1}=i; #10; end end initial #80 $finish; endmodule Which of the following is true for the above 2 verilog codes? I. Gate design level is used in the code. II. 2x1 Multiplexer is designed in the code. II. All nets in the codes must be defined in the "testbench" section.

c++ stdio.h only please example  input : 417 -17 12 -12 output :  0  (there is no suspicious) example the suspicious: input : 4-100 -200 200 100 output : 2 should the positive first than the negative

If the integer sent into it is odd, it returns 1 if it is not 1 its returning 0 to backside. With c programming language

MIPS Assembly Write a program for RISC MIPS 32bits that challenges a person to guess a number of up to 3 digits before and 3 digits after the comma, that is, a value between 000,000 and 999,999. The program user will try to guess the number with multiple attempts, where the program will indicate at each attempt if the informed number is bigger, smaller, or if the user guessed correctly. When this happens, the program ends, showing a SUCCESS message and a total count of the number of attempts taken to get it right. The program must have a SUBROUTINE as described below. SUBROUTINE:- Input Parameters: user guess, expected value- Output: message on screen (bigger, smaller, SUCCESS)- Returns: value 1 if correct, 0 if incorrect

Q1\ 1- Write a program in assembly language for the 8085 microprocessor to send 10 bytes of data located at the memory address (3000h) using SOD at a baud rate of 1200. Information: The 8085 processor operates at a frequency of 3.072 MHz. And two high pulses must be sent before each byte (start bits) and one low pulse after each byte (end bits). You can use this flowchart, but you should notice that this flowchart deals with one byte, and you are required to deal with 10 bytes Transmit No Set up Character Bit Counter Send Start Bit Wait Bit Time Get Character in Accumulator Output Bit Using Do Wait Bit Time Rotate Next Bit in Do Decrement Bit Counter Is It Last Bit? Yes Add Parity if Necessary • Send Two Stop Bits Return (a)