Spur gear train is used to transmit the power of 2kW from input gear A rotating at 120 rpm to output gear D through a compound gear BC. The number of teeth on the gear A, B, C and D are 16, 32, 12 and 18 respectively. Given: Module = 4mm, pressure angle= 20° %3D The tangential force acting on the gear B is A

Q: The figure below shows the power transmitted through a gear drive to multiple output shafts. Gear A…

A:

Q: In the figure below, Gears B and C represent a compound gear and have the following details. The…

A: number of teeth t A=100 tB=40 tc=80 tD=20 input torque  Ti=42 Nm speed of gear A NA=2400 rev/min…

Q: Gear 2 (pinion) runs at 1800 rpm ccw and transmits 3.5 kW to frictionless, idler gear 3. The…

A:

Q: in the an:iclo-kwise di

A:

Q: Below is the arrangement for a gear train. A motor delivers 200-hp at 540-RPM to the input gear A.…

A: The speed of gear A, NA = 540 rpmThe power delivers by motor, P = 200 hp

Q: (Pinion) Gear 2 Idler N2 = 75 teeth Gear 3 Output N3 = 25 teeth O teeth he following: 1. Pinion…

A:

Q: Two equal involute gear wheels of 40 teeth each, 3 mm module and 20° pressures angle are in mesh.…

A: According to the given data Number of teeth (T)=40 Module (m)=3mm Pressure angle ϕ=20° Speed…

Q: The shaft from a DC motor is connected to gear A which rotates at 45rps in clockwise direction.…

A:

Q: The lathe machine in the Central University of Technology mechanical workshop uses epicyclic gear…

A:

Q: The figure shows a pair of shaft-mounted spur gears having a diametral pitch of 5 teeth/in with an…

A: The force acting on bearing .

Q: Problem 2. A compound gear train as shown in the following figure, Gear 1 has 24 teeth and Gear…

A:

Q: 2-2 The sun gear-2 and -5 are integral with the input shaft of the compound epicyclic gear…

A: givensun gear 2 and 5 are integral part with the input shaft of the compound epicyclic gearannular…

Q: Determine the minimum shaft diameter at locations A, B, C, D, & E for an enclosed industrial…

A: The power transmitted by gear B, P1 = 25 hpThe number of teeth on gear B, Z1 = 24The diametral pitch…

Q: The gear ratio shown must transmit 10 horsepower (66000 lb in/s) from its input, which is rotating…

A: For the solution refer below images.

Q: number of pe f the pinion

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.