Sketch the spectrum. -at Use the convolution theorem to find Fe="Cosutu()}. sketch the spectrum. of the signal. to the tabl 16 F{è

Q: R, Rz Rg Ry

A: According to the question we have show how we can solve the given term.

Q: can you resubimt with better pics of k-map and circuit

A: The values of D=∑(1,4,5,6) taken from step 2 of previous solution.

Q: F= B'D + BC+ A'D implement F using the ICs: 74LS04, 74LS08,74LS32 Draw the pin map of each IC and do…

A:

Q: In the figure 8 = 9.22 V. R₁ = 12400, R₂ = 30500, and R3 = 3020 02. What are the potential…

A: We are givenwhere

Q: QUESTION 4 What are the advantages of sourcing output cards? O Easier to interface to because one…

A: Concept- Sinking and Sourcing- PLCs use input/output module cards called Sinking and Sourcing.…

Q: current of 1 mA and a reverse bi Ans. Rp=9.3 k2; R.=6 kM

A:

Q: 1. If this were a real circuit, what would be the sources of experimental error? (Remember…

A: In any examination including flows there are numerous potential wellsprings of mistake, here are a…

Q: f(t) M fricfionless surfaće X = 0 f(t) M frictionless surfaće С. x = 0 f(t) M frictionless surfaće…

A:

Q: But how did you get the values for V1, V2 and V3? What did you plug in?

A:

Q: With the negative probe connected to ground, measure and record the following voltages, in reference…

A: Given data, Applying kVL in the circuit, Voltage across diode 1,

Q: B)- Observe what happens when the buttons are pushed‍ PB1 M1 O PB2 M2 M2 HH M1 * Fill in the table:…

A: PB1 and PB2: Push buttons.M1: Relay or motor, with normally open contact.M2: Relay or motor, with…

Q: Use the given graph. B A E D Find the Euler circuit starting with A. If it is not possible, say "not…

A: Given:A graph,To find:We have to find the Euler circuit starting with A. If it is not possible then…

Q: 2. Discuss the following circuits by directly stating their circuit diagrams, waveforms, principle…

A: Introduction:It is also known as a free-running multivibrator which is nothing but  an electronic…

Q: In a balanced three-phase system, the source is a balanced Y with an abc phase sequence and a line…

A:

Q: 4.19 Find the closed-loop transfer function of the control system shown in figure H2 G2 G3…

A:

Q: Problem 3: is a review of your understanding of an OPAMP's basics: Assume ideal an OPAMP and find…

A: Given  Vin  =   2 volt  Rf.  =  10 k ohm  Rin =  1 k ohm  To find Vout

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.