QUESTION 4 What are the advantages of sourcing output cards? O Easier to interface to because one power supply is needed O Easier to interface to because less wires are required O Easier to interface to due to ease of hookup O Both A & B QUESTION 5 Sinking output cards are commonly called OPNP cards O NPN cards OPPN cards Onone of the above QUESTION 6 The disadvantage of NPN cards are they typically require 2 power supplies O True O False

Q: An RTD forms one arm of a Wheatstone bridge, as shown in the figure below and the RTD is used to…

A:

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

A:

Q: Short answer. In testing a diode, if the red probe of an analog ohmmeter is tapped at the cathode…

A: Given, In testing a diode, the red probe of an analog ohmmeter is tapped at the cathode while the…

Q: State five (5) application of PN Junction, and explain the property of the PN junction that make…

A: Following are five applications of diodes P-N junctions are used in Rectifiers. P-N junctions are…

Q: what does c3 equal

A: Initial conditions are not given so take, initial conditions = 0.

Q: VOUT-V, (R,/R₂) FlexiForce V, -Sv POWER GND GND MCP 6001 货 Determine Rf in the circuit in order to…

A: …

Q: 19. Compare the brightness of 2 light bulbs wired in parallel relative to the brightness of 3 light…

A: Note: Since you have not specified any question to be answered, as per our honor code, we are…

Q: 5) (e) A temperature measurement is made by placing the RTD in the measuring environment and…

A: For the given circuit, at the balanced condition:…

Q: Objective In this activity, you will compare closed-loop and open-loop control systems.…

A: Systems Open/closed   Light switch to turn on the light Open system The light is…

Q: A certain population consists of N=1000 people. 500 of them support party A; 300 of them support…

A: Given N= 1000, K =4   Supporting A is 500.  Supporting B is 300. Supporting C is 200.

Q: R2 = 236 Q R3 = 244 Q Ez = E, = 3 = R = 30 Q = 1 E, = R= 160 Q E = ET = 240 V 4 = RT = IT =

A: In the circuit shown in question, the resistor R2 is in series with resistor R3 and series…

Q: 5. Given a variable input voltage in the circuit shown, a Zener diode is used to regulate the output…

A: Given:a zener diode circuit, with, we need to find:a) minimumb) maximumvalue of Vin for sustained…

Q: ii) Draw the cross-section of this p-n junction and show the depletion region and the corresponding…

A:

Q: Calculate the value of V1 and V2?

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.