Sir Lost-a-Lot dons his armor and sets out from the castle on his trusty steed (Fig. P12.19). Usually, the drawbridge is lowered to a horizontal position so that the end of the bridge rests on the stone ledge. Unfor- tunately, Lost-a-Lot's squire didn't lower the draw- bridge far enough and stopped it at 0 = 20.0° above the horizontal. The knight and his horse stop when their combined center of mass is d = 1.00 m from the end of the bridge. The uniform bridge is l = 8.00 m long and has mass 2 000 kg. The lift cable is attached to the bridge 5.00 m from the hinge at the castle end and to a point on the castle wall h = 12.0 m above the bridge. Lost-a-Lot's mass combined with his armor and steed is 1 000 kg. Determine (a) the tension in the cable and (b) the horizontal and -Tee

Sir Lost-a-Lot dons his armor and sets out from the castle on his trusty steed (Fig. P12.19). Usually, the drawbridge is lowered to a horizontal position so that the end of the bridge rests on the stone ledge. Unfor- tunately, Lost-a-Lot's squire didn't lower the draw- bridge far enough and stopped it at 0 = 20.0° above the horizontal. The knight and his horse stop when their combined center of mass is d = 1.00 m from the end of the bridge. The uniform bridge is l = 8.00 m long and has mass 2 000 kg. The lift cable is attached to the bridge 5.00 m from the hinge at the castle end and to a point on the castle wall h = 12.0 m above the bridge. Lost-a-Lot's mass combined with his armor and steed is 1 000 kg. Determine (a) the tension in the cable and (b) the horizontal and -Tee

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Slip. Consider the figure below. If us = 1/(2+ V3) between the surfaces, what is the smallest possible 0 such that the block does NOT slip while resting on the circular surface? O 15° O 30° O 75° O 60°
The drawing shows an A-shaped ladder. Both sides of the ladder are equal in length. This ladder is standing on a frictionless horizontal surface, and only the crossbar (which has a negligible mass) of the " A " keeps the ladder from collapsing. The ladder is uniform and has a mass of 15.2Kg. Det k mine the tension in the crossbar of the ladder.
please answer clearly.
To get up on the roof, a person (mass 82.0 kg) places a 6.60 m aluminum ladder (mass 11.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. What are the magnitudes (in N) of the forces on the ladder at the top and bottom? top N bottom N
A diver dives from a cliff when her center of gravity is 46 feet above the surface of the water. Her initial vertical velocity leaving the cliff is 9 feet per second. After how many seconds does her center of gravity enter the water?
A 10.0-kg monkey climbs a uniform ladder with weight 1.20 × 102 N and length L = 3.00 m as shown in Figure P12.14. The ladder rests against the wall and makes an angle of θ = 60.0° with the ground. The upper and lower ends of the ladder rest on frictionless surfaces. The lower end is connected to the wall by a horizontal rope that is frayed and can support a maximum tension of only 80.0 N. (a) Draw a force diagram for the ladder.(b) Find the normal force exerted on the bottom of the ladder. (c) Find the tension in the rope when the monkey is two-thirds of the way up the ladder. (d) Find the maximum distance d that the monkey can climb up the ladder before the rope breaks. (e) If the horizontal surface were rough and the rope were removed, how would your analysis of the problem change? What other information would you need to answer parts (c) and (d)?
A solid sphere, made of acrylic plastic with a density of 1.1 g/cm3,1.1 g/cm3, has a radius of 5.0 cm.5.0 cm. A very small "eyelet" is screwed into the surface of the sphere and a horizontal support rod is passed through the eyelet, allowing the sphere to pivot around this fixed axis, as shown in the figure. If the sphere is displaced slightly from equilibrium on the surface of Earth, determine the period ?T of its harmonic motion when it is released.
A student hits a board with an initial speed of 10.0 m/s. The student's hand and the board are in contact for 0.002 second and the speed of the hand decreases to 1.0 m/s during the contact between the board and the hand (the hand is alvays moving forward). The mass of the student's hand and arm is 1.0 kg, and the board has a cross-sectional area A = 10.0 cm?. Estimate the shear stress on the board.
To get up on the roof, a person (mass 87.0 kg) places a 5.60 m aluminum ladder (mass 14.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. What are the magnitudes (in N) of the forces on the ladder at the top and bottom? top N bottom N
(8c12p13) Forces F1, F2, and F3 act on the structure depicted in the figure, shown in an overhead view. We wish to put the structure in equilibrium by applying a force, at a point such as P located a distance d from F1, whose vector components are Fh and Fv. We are given that a = 1.9 m, b = 2.7 m, C = 1.05 m, F1 = 24.10 N, F2 = 12.85 N, and F3 = 4.65 N. Find Fh, find Fv, and find d.
In exercise physiology studies, it is sometimes important to determine the location of a person’s center of mass. This determination can be done with the arrangement as shown. A light plank rests on two scales, which read Fg1 = 380 N and Fg2 = 320 N. A distance of 1.65 m separates the scales. How far from the woman’s feet is her center of mass?
You're carrying a 3.4-m-long, 24 kg pole to a construction site when you decide to stop for a rest. You place one end of the pole on a fence post and hold the other end of the pole 35 cm from its tip. How much force must you exert to keep the pole motionless in a horizontal position?