rpm. contact between the belt and pulley is 144°, the coefficient of friction between belt and pulley is 0.15 and the safe working stress of the belt is 2.1 Mpa. Determine the belt tension ratio, neglecting the effect of centrifugal force. A. 2.41 В. 2.44 С. 1.458 D. 4.12

Q: H.W (1): A single dry plate clutch transmits 7.5 kW at 900 r.p.m. The axial pressure is limited to…

A:

Q: Don't use chatgpt will upvote

A:

Q: As shown in the figure below, three boxes are placed on an incline. The boxes are initially in…

A: Given data as per the question Mass of block A =20 lb Mass of block B= 40 lb Mass of block C = 30 lb…

Q: A C-clamp whose screw has a mean radius of 8 mm, lead of 5 mm, and coefficient of static friction of…

A: Given data:mean radius (r) = 8mmlead (l) = 5mma=32mm, F=120N

Q: H.W (3): A multi-disc clutch has three discs on the driving shaft and two on the driven shaft. The…

A:

Q: The pulley of Fig. wheel that fits loosely over a t in.-diameter shaft. A rope passes over the…

A: Given: The diameter of the wheel, D = 4 in The diameter of the shaft, d = ½ in The magnitude of…

Q: A multi-plate clutch has four pairs of frictional surfaces, each of internal diameter 120 mm and…

A: Clutch is defined as a machine element which is used to engage and disengage driver and driven shaft…

Q: Q3 / A multi – plate clutch is to transmit 12 kW at 1500 r.p.m. The inner and outer radii for the…

A:

Q: Power is transmitted between two shafts by a V-belt whose mass is 0.9 kg/m length. The maximum…

A: Given, Mass of V-belt = m = 0.9 kg/m Maximum tension = T = 2.2 kN = 2200 N Angle of lap = θ = 170o =…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.