A C-clamp whose screw has a mean radius of 8 mm, lead of 5 mm, and coefficient of static friction of 0.20 is loaded by the forces shown. For F = 120 N and a = 32 mm, the clamping fe holding the workpiece is best given by a. 1.57 kN b. 6.28 kN c. 5.44 kN d. 3.14 F a- VIEW A-A

Q: An elevator type lift is being designed to raise a load up to 5,000pounds between floors.…

A: Data given- Raise a Load = 5000 pounds  Elevator weight =  800 pound Two square-thread lead screws D…

Q: A 120-lb cabinet is mounted on casters that can be locked to prevent their rotation. The coefficient…

A:

Q: 2. Determine the clamping force on the bolt and reactions at pin A for the pliers shown.

A: It is required to determine the force on the bolt and reactions at pin A, given that the applied…

Q: A 60 kg spy is trapped in an underground bunker and the only way she can get out is by climbing up a…

A:

Q: The length AB for the lug wrench shown below is 12 inches. What is the maximum force (F) that one…

A: Given data:find:The maximum force

Q: A horizontal load Pis applied to an assembly consisting of two inclined bars, as shown in the…

A:

Q: If a block is stationary, then the friction force acting on it is Select one: O a. = Ms.N O b. 2…

A:

Q: A device for lifting rectangular objects such as . Deter- mine the minimum coefficient of static…

A: Taking Free body diagram of the right lever, f = frictional force N = normal force VO = Vertical…

Q: A conveyor belt is driven with the 200-mm-diame- Couples CA and Cg are applied to the system at…

A: Let T' be the tension in the middle belt. The Tension ratio for pulley A is written as,…

Q: An axial load of 160 lb is applied to the end bear- Fig. ses place over an annular ring of radius 4…

A: Given that, Axial load applied, P=160 lb,Inner radius of ring, r=4 in,Outer radius of ring, R=7…

Q: The wheel shown supports a load of 500 lb. The hub fits loosely over an axle of diameter 1.3 in and…

A: Given :To find:

Q: 26. Load on member FE OA. 9.05 KN (C) OB. 9.50 KN (T) O C. 10.2 kN (T) OD. 11.3 kN (C)

A:

Q: For nos. 24-37, satisfy the conditions of the g below: The truss is loaded as shown in figure of…

A: Ans: 25. Option D is correct. 11.2 kN compression

Q: The three bars have a weight of WA = 20 lb, WB = 40 lb, and W. = 60 lb, respectively. If the…

A:

Q: A leather-faced cone clutch has a contact surface with a mean diameter of 15 in. and transinits 20…

A: Given: Mean diameter, dm = 15 in or 1.25 ft Power transmitted, P = 20 hp or 11000 lb.ft/s Rotational…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.