Round off all your values to 3 decimal places. The 50-kg crate rests on a horizontal surface for which the coefficient of kinetic friction is 0.3. If the crate is subjected to a 400-N towing force as shown, determine the a.) normal force, b.) acceleration and c.) the velocity of the crate in 3s starting from rest. P = 400 N 30°

Round off all your values to 3 decimal places. The 50-kg crate rests on a horizontal surface for which the coefficient of kinetic friction is 0.3. If the crate is subjected to a 400-N towing force as shown, determine the a.) normal force, b.) acceleration and c.) the velocity of the crate in 3s starting from rest. P = 400 N 30°

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.4P: A compact car travels 30 mi on one gallon of gas. Determine the gas mileage of the car in km/L. Note...

See similar textbooks

Similar questions

M Whwel = 50 kg (k.) wheel =0.15 m 2) The 50-kg wheel is connected to a 10-kg block as shown. The block is moving downward with a speed of 2.4 m/S, and suddenly, friction between the wheel and 0.5 m ground was applied, and caused the block to decelerate at 10.0 m/ S. A) Draw the FBD and KD for the wheel alone, H= 0.5 and show all external and effective forces on these diagrams. B) Calculate the angular acceleration of the wheel. Mg = 10 kg +0.2 m C) Assuming the wheel has angular acceleration of 25 rad/ S find the acceleration vector of the center of mass of the wheel. (Vail = 2.4 m/S
As shown in the figure below, a rear wheel driven Mars vehicle has a total mass of 120 kg. It has four wheels each of 6.73 kgm² MMofl and 0.60 m diameter. The coefficient of friction on the Mars is 0.4, and the Mars gravitational acceleration is 4.7 m/s². a) Draw its free body diagram for the Mars vehicle. b) Write the 6 equations governing the motion of the Mars vehicle assuming it is moving with maximum acceleration. c) Determine the maximum acceleration up a slope of 12° to the horizontal. d) Making a judgement whether the Mars vehicle will overturn when it runs at its maximum acceleration derived above. CofG 1. Om 12⁰ 1.3m 2. Om front
0:00. 4 KB/S 21 Misan University - Fngineering College Petmleum Engineering Department Subject : physics. Exam Quiz Examiner :Assist Lec. Hanan Hashim Class 1d year Date 21 /2/ 2021 Time:I hr. 1) A (7 kg) block is at position (A) on the track that is (5 m) ahove the ground. as shown in figure below Section B-C is rough with coefficient of kinetic friction of 0.35 while the other surface is not .a length of B-C is 1.7 m. FIND (a) the total energy of the block at A. (b) velocity of the block at B .(d) The energy lost along path B- C, and (c) how high the hlock rise along path C-D. Assist. Lec. Hanan Hashim علي الجیزاني اليوم عند 5:54
Pushing a Block and a Wedge 0 points possible (ungraded) In the following problem, you are asked to: i) Define the system and the environment: Identify which objects - the environment - interact with the object of interest - the system. Justify your choice of system: would a different choice also work? If not, why not? If so, why is the choice you made better? ii) Describe the interactions and the resulting forces: Identify the forces exerted on the object of interest by the other objects. iii) Draw the free body diagram of the object: Make sure that each force arrow is labeled with two subscripts - who is exerting the force and on whom is the force being exerted. The length of the arrows should represent qualitatively the magnitude of the force. a) c) M m 0 a F M m 0 A block of mass m rests on a frictionless wedge which has a mass M and whose surface makes an angle to the horizontal as Calculator
The 300N block rests upon a level plane for which the fk is 0.20. A force P = 100N, directed at 30° from the horizontal pulls the block and moves 80m starting from rest. If the 100N force is then removed, how much further will it travel? a. none b. 48.803m c. 40.078m d. 47.800m 3. 40.780m
A matchbox car (mass = 8.3 kg) is left on a hill which is at an angle of 22 degrees. The toy car is at rest on the x axis. The coefficient of kinetic friction between the toy and the ground is 0.33, while the coefficient of static friction is 0.37. a) Draw the free body diagram for the matchbox toy. b) Solve for the friction force. If a parent comes along and starts pushing the toy car parallel to the direction of the hill (up the hill) with a 50 Newton force. c) What is the acceleration of the car up the hill once the parent gets the toy car moving? d) If the parent pushes it with the same constant force for 3 minutes starting from rest, how far does the toy car travel up the hill? e) How much work is done by friction? f) What is the change in gravitational Potential energy?
QUESTIONS 1. 500 kg roller starts from a point A as shown in the diagram below. If throughout its travel the average retarding force due to air friction on the wheel is 200 N. What is its speed at points B and C given that |AB| = 100 m and |BC| = 50 m. How far will it travel at the elevation of C before coming to rest? A to 20 m 5 m 2. Under a constant force, a 10 kg ball increases its speed from 2.0 ms- to 7 ms after covering 50 m. Calculate the force on the ball. 3. A stone is thrown vertically upwards fiom the top of a building 50 m tall with velocity of 20.0 ms. If the stone just misses the edge of the roof on its return, determine (a) The time taken by the stone to get to its maximum height. (b) The maximum height reached by the stone (c) The time at which the stone retum to the point where it was thrown (d) The velocity of the stone at this instance (e) The velocity and position of the stone at t= 5 s. initial 4. (a) What is the difference between inertia and momentum? (b) A…
1. A 20 kgm block is subjected to forces as shown. Determine a) its acceleration b) its velocity after 2 seconds. The block is at rest at the beginning. Walang friction. 500 N 300 N
Hi Can you please help me solve D and E? Question 2 – Go Kart Track Your go karts have a mass of 450kg and travel around a circular curve on a flat, horizontal track at a radius of 42 m. A) The maximum frictional force between the tyres and the road is equal to 20% of the weight of the car and driver. Calculate the coefficient of friction when an adult of mass 70kg is driving the kart. B) Calculate maximum angular velocity at which the car can travel round the curve at a constant radius of 42 m. C) Calculate the maximum linear velocity. D) You decide that this is not nearly fast enough and decide to create a banked track of 12O, what is the maximum linear velocity now? E) Describe qualitatively how this could change if a child were driving the kart. For A I have an answer of 0.2 For B I have 0.218 rad/sec For C I have 9.156 m/s If I have these wrong it would be useful to see where if possible.
In the following diagram, the coefficient of friction between the 1000 N body A and the surface of the table is me = 0.75. Calculate: a) The maximum friction force between block A and the table. b) The maximum weight that block B must have for the entire system to be in balance. or c) The friction force between block A and the table so that the weight of block B can be 80. P-10³ N NR
An 8-kg block E is attached to a pulley system as shown. If the end of the cable at A is pulled down at 4.5 ft/s, and the speed is decreasing at a rate of 1.2 ft/s2, determine the following: a) Speed of block Eb) Acceleration of block Ec) Tension of cable between Pulley C and D
The block shown started at rest and moves towards the right, say coefficient of friction is 0.2. Determine the following A 1000 - 3m IB 250 1.2my Match each item to a choice: B.) which of the following gives the tension of the chord. a.) which of the following gives the velocity of block B as it touches the ground