Refrigerant-134a enters a compressor at 180 kPa as a saturated vapor with a flow rate of 0.35 m³/min and leaves at 900 kPa. The power supplied to the refrigerant during the compression process is 2.2 kW. What is the temperature of R-134a at the exit of the compressor?

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: . Two steady flows of air enter a control volume, as shown in Fig. One is a 0.035 kg/s flow at…

A: Consider a control volume steady state device with two inlets and one exit flow. Neglecting kinetic…

Q: A piston-cylinder device initially contain 0.4 m3 of 1.8-kg saturated liquid water and steam mixture…

A:

Q: 2 A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120°C and 5…

A: Mass flow rate of cooling water and the heat exchanger efficiency is asked to calculate. Given:Mass…

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. The steam enters…

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you…

Q: Argon enters an adiabatic turbine at 800 kPa and 600C and exits at 100 kPa and 50 C. The rate of…

A:

Q: 8. Problem 2-33 (modified), Davis and Cornwell, Introduction to Environmental Engineering, 6th Ed.:…

A:

Q: Water (T = 20°C) from a reservoir is pumped up at 5 kg/s through a 3-in Sch. 40 pipe connected to a…

A: Given :Fluid Flow and Pumping:Water is being pumped from a reservoir through a The flow rate is Pump…

Q: Q4\ gas enters a frictionless adiabatic nozzle steadily at 1 MPa, 500 C with a mass flow rate of…

A: At Inlet Pressure=1MPa, Temperature=500oC=773K, Mass flow rate=6000kg/hr Inflow area=40cm2 At Exit…

Q: In a Rankine cycle, steam enters the turbine at 8400 kPa and 350°C. The total condenser (i.e. exit…

A:

Q: Air enters an electric furnace at 100 kPa and 28°C with a volume flow rate of 22 m/min. At the exit…

A: Given that :At entering P1  =100KPaT1   =28 C  =28+273.15 = 301.15 KQ = 22 m3minAt exit P2  = 100…

Q: 3) Steam is produced in a boiler using liquid water as the feed. The boiler operates at 100 kPa. The…

A: Given: Inlet Water Temperature  = T1  = 40 oC  = (40+273) K  = 313 K  Outlet Steam Temperature  = T2…

Q: Water is the working fluid in a Rankine cycle. Steam enters the turbine at 10 MPa and 550°C. The…

A: Note: We are supposed to answer only three subparts of a problem as per our guidelines. Kindly send…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: Steam enters a turbine at steady state with a mass flow rate of 1.28 kg/s. The turbine develops a…

A: Step 1:from steam table find h1 and h2  Step 2: open system by first law of thermodynamics has an…

Q: information er a 210-MW steam power plant that o ple non-ideal Rankine cycle. Steam e ine at 10 MPa…

A:

Q: At the commencement of compression in the reciprocating compressor of a refrigeration plant the…

A: Given:The compressor follows  at To find the work done, Internal energy and heat transfer through…

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: An air compressor, as shown in the figure, compresses air from atmospheric pressure (100 kPa) and…

A: P(1) = 100 kPa T(1) = 280K P(2) = 600 kPa T(2) = 400K Mass Flowrate = 1 kg/s

Q: Power for Pumping in a Flow System. Water is being pumped from an open water reservoir at the rate…

A: Water is pumped from an water reservoir to a storage tank place 20 m above the reservoir. Both…