Refrigerant-134a, at 1.5 MPa, 90 °C, is to be cooled by air to a state of 1 MPa, 27 °C in a steady-flow heat exchanger. Air enters at 110 kPa, 25 °C with a volume flow rate of 820 m³/min and leaves at 95 kPa, 62 °C. Neglect any heat loss. Part A Determine the mass flow rate (m) of refrigerant. Express your answer to three significant figures. Π| ΑΣΦ ↓↑ Submit ş vec Request Answer kg/s

Q: . Determine the mass flow rate at the inlet and exits, in kg/s. I V₁ = 30 m/s P1 = 5 bar T₁ = 360°C…

A:

Q: Air at 15 degree Celsius and 95 kpa enters the diffuser of a jet engine and steadily with a velocity…

A: The given values are- T1=288 K , P1=95 kPa , v1=250ms , A1=0.5 m2, v2≈0Assuming it as a steady flow…

Q: (a) Answer these questions: ii. iii. i. State three (3) variables or parameters which remain…

A: (i) In a steady flow system, the following parameters remain unchanged over time:Flow Rate (Mass or…

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: Steam flows through a nozzle at mass flow rate of m = 0.1 The enthalpies at inlet and exit are 2500…

A:

Q: The power output of an adiabatic steam turbine is 4.5 MW, and the inlet and outlet conditions of the…

A:

Q: In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine…

A:

Q: water at 100 kPa, 30 °C, enters a pump with a flow rate (m) of 18 kg/s with a velocity of 2 m/s. At…

A:

Q: 200Kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits at…

A:

Q: Argon gas flows through a well-insulated nozzle at steady state. The temperature and velocity at the…

A:

Q: rom the turbine the heat loss per kg of steam flow rate is 5 kW. Find the power developed in kW by…

A: Given:Heat loss, Q=-5 kWFor inlet steam, h1=3250 kJ/kgvelocity, v1=180 m/sFor exit steam,h2=2360…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.