From the turbine the heat loss per kg of steam flow rate is 5 kW. Find the power developed in kW by the steam turbine per kg of steam flow rate? . Specific enthalpy and velocity of steam at inletand exit of a steam turbine, running understeady state, are as given belowSteam ConditionInlet steam conditionExit steam conditionSpecific Enthalpy (kJ/kg) Velocity (m/s)325023601805

Given:Heat loss, Q=-5 kWFor inlet steam, h1=3250 kJ/kgvelocity, v1=180 m/sFor exit steam,h2=2360…

Answered: rom the turbine the heat loss per kg of…

rom the turbine the heat loss per kg of steam flow rate is 5 kW. Find the power developed in kW by the steam turbine per kg of steam flow rate?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 0.02 kg / s entering a radial flow compressor at 100 kPa and 280 K air is compressed to a pressure…

A: Given:Power required, P=2.732 kWmass flow rate of sir, m˙=0.02 kg/sP1=100 kPaT1=280 KP2=600…

Q: What physical reasons why reducing grain size is an effective alternative for increasing the…

A: Smaller grains have greater ratios of surface area to volume, which means a greater ratio of grain…

Q: The thermal efficiency of a heat engine is 30%, the heat rejected from the engine is 30kJ, evaluate…

A: The thermal efficiency of a heat engine is defined as the ratio of the total work output by the heat…

Q: pipe diameter 0.35 m. Assume no friction or heat transfer in the pipe and find the pressure OPint…

A: Given: P1=150 kPa mass flow rate=2000 kg/s h=15 m d1=0.5 m d2=0.35 m To determine: Pressure at the…

Q: Find the kinetic energy stored in car of 30 kg moving with velocity 24 m/s

A: Given data : Mass of car=m Velocity of car=V To find : Kinetic energy

Q: Find the kinetic energy stored in body of mass 1 kg moving with velocity 2.3 m/s

A: Given data : Mass of body=m Velocity=V Required : Kinetic energy

Q: During a flow process 5000 W paddle wheel work is supplied while the internal energy of the system…

Q: A steam turbine has an inlet of 2 kg/s water at 1000 kPa, 350°C and velocity of 15 m/s. The exit is…

Q: For Carnot Cycle: Thermal efficiency= 1

A: Draw the T-s diagram of the Carnot cycle.

Q: From 300 kPa abs and 0.9 m3, air is being compressed isentropically to 0.4 m3. Find the change of…

Q: A solar collector absorbed 40W/m2 heat from the atmosphere. This is equal to the convection brought…

A: Given data: Q=40 W/m2T1=40°CT2=80°C Need to determine the convective heat transfer coefficient.

Q: A device, including a heat engine and a heat pump, will be designed to deliver energy to a Heat…

Q: A 2-kW electric resistance heater in a room is turned on and kept on for 30 min. Find the amount of…

A: Write the given data in the problem. P=2 kW t=30 min Here, P is the power consumed by the heater,…

Q: A pump operates between 100kPa and 10MPA. If the mass flow rate of the pump is 20.8 kg/s, and the…

Q: A closed constant volume system receives 10.5 kJ of paddle work. The system contains oxygen at 344…

Q: A single stage compressor is to compress 8.5m3/min from 98.56KPa to 985KPa. Polytropic constant is…

Q: Water vapor enters a continuous flow turbine with 6 MPa pressure, 450oC temperature and 80 m/s…

A: Steam turbine It is a device which converts the thermal energy of steam into electrical energy. High…

Q: For a power system operates with Wcycle = 810 BTU and Qout = 1769 BTU. What is the thermal…

A: Given data Work = 810 BTU Heat out = 1769 BTU Find the thermal efficiency of the system

Q: A pump with an efficiency of 15mm% is used to pump water from a tank (stationary water inside) at…

Q: A Carnot engine requires 35 kW from the hot source. The engine produces 15 kW of power and the…

A: Given Heat supplied, QS = 35 kW Power produced, W = 15 kW Find Heat rejected, QR

Q: A piston/cylinder receives (control mass system) R-134a at 300 kPa and compresses it in a process…

Q: A system is proposed to generate power from wastewater of 54C. If the ambient temperature is 23C,…

A: Highest thermal efficiency is given by ηmax = Work outputHeat input = Q1-Q2Q1 =…

Q: ternal energy increases

A: given:W=150kj∆U=95kj

Q: A steam is expanded through a nozzle and the enthalphy drop per kg of steam from the initial…

Q: Refrigerant R-410a inters a refrigerator compressor at a pressure of 150 kPa, -10 C and leaves at…

A: The enthalpy of the refrigerant at 150 kPa and -10 degrees Celsius from the standard table is The…

Q: maximum COP of the machine b. The minimum power in watts required of the machine

Q: Q4: A 600 MW heat engine, which is cooled by water, the thermal efficiency of engine is 0.15 heat…

A: Given Data Thermal efficiency, 0.15 Net work done, wnet=600MW 0.15=600/Qadd Qadd=4000MW

Q: 5. During the flight, the air speed of a turbojet engine is 250 m/s. The ambient air temperature is…

Q: A system produces 10 BTU of work upon addition of 50 kj of heat. Find the heat rejected in ft-lbf.

Q: What is the velocity leaving a jet engine (air) when its temperature decreases by 220C use constant…

Q: Steam enters a continuous flow turbine at a pressure of 8 MPa and a temperature of 450 ℃ and reaches…

A: Certainly! Here are the given data from the question:Given Data:Inlet conditions:Pressure at inlet…

Q: Find the kinetic energy stored in body of mass 1 kg moving with velocity 2.3 m/s

A: Mass of a body, m=1 kgVelocity of a body, V=2.3 m/s

Q: : A Steam enters turbine at nate of 20X10 K/ hr and at F00 Kpa & 450 C. At the turbine exhaust, the…

A: This question is based on the steady flow energy equation applied to the turbines. Assumption taken…

Q: A storage battery is considered as the system. It has the terminal potential of 12 V and draws a…

A: Given that, V=12 V ; I=6 ampTime t=1.5 hr=1.5×3600=5400 sec△U=-750 kJ Decrease in stored energy

Q: From 400 kPa abs and 0.8 m3, air is being compressed isentropically to 0.5 m3. Find the change of…

Q: A car engine releases 325J of heat and pushing the piston doing 400J of work. Does the sytem gained…

A: The heat releases by car engine is calculated as,Q=325 J The work done by piston is calculated…

Q: The air conditioner in a house or a car has a cooler that brings atmospheric air from 30 degree…

A: Given data: Initial air temperature, T1 = 30°C. The final temperature of the air, T2 = 10°C. Mass…

Q: Water vapor enters a turbine at 6 MPa pressure and 800 ° C temperature and leaves at 20 kPa…

A: according to the steam table at pressure 6 MPa h1 = 3178.3 kJ/kg s1 = 6.5432 kJ/kgK at pressure 120…

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

From the turbine the heat loss per kg of steam flow rate is 5 kW. Find the power developed in kW by the steam turbine per kg of steam flow rate?

. Specific enthalpy and velocity of steam at inlet
and exit of a steam turbine, running under
steady state, are as given below
Steam Condition
Inlet steam condition
Exit steam condition
Specific Enthalpy (kJ/kg) Velocity (m/s)
3250
2360
180
5

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A steam turbine has an inlet of 4 kg/s water at 1000 kPa, 400 oC and velocity of 77 m/s. The exit is at 100 kPa, 150 oC and very low velocity. Find the specific work and the power produced.
Steam to a turbine at a mass flow rate of 1.4 kg/s, 700 kPa pressure and 400 °C enters the temperature. Steam at 100 kPa pressure and 1.4 m3/kg specific volume exits the turbine. Heat transfer from turbine to environment 50 kW, with turbine Since the boundary temperature between the environment is 70 °C, a) Find the power produced by the turbine, entropy produced in the turbine and isentropic efficiency of the turbine. Note: The changes in kinetic and potential energies will be neglected and T (K) = 273 + °C will be taken.
A cooling machine draws 500 kJ / min of heat from the environment in order to keep the cooled environment at -18oC. If the environment where the cooling machine gives heat is at a temperature of 18oC, calculate the minimum power required to run the machine as kW.
A windmill produces 5 kW and is connected to a battery to charge it. The batterydue to resistive heating loses heat at a constant rate of 2 kW. Find the stored energyin the battery after 2 hours?
Find these 5 things
11. A 4.67 kg substance enters at steady flow in a pipe. After 2 minutes, it leaves the pipe with 5.5 m³ discharged. Find the mass at the exit in lb. 11
Find the efficiency of carnot engine whose source and sink are at 927° C and 27 C.
A engine at full load delivers 100 kW brake power. It requires 25 kW to rotate it without fuel at the same speed. The mechanical efficiency at half load is ?
steam having enthalpy 2930.8 KJ/ kg, enters a nozzle with a velocity of 60 m/s. find the velocity of steam at the exist of the nozzle, if its enthalpy is reduced to 2721.4 kj/kg
Q4 a- The pressure inlet for air compressor is 14 psi ,60 F and the output of 140 psi at 1080 R .This output passes through a cooler of constant pressure .if the exit air out of cooler is 540R find the specific work and specific heat of this compressor .use the table below in case.