rectangular deck scow 35.0 m long, 5.60 m wide, and 3.50 m high has a draft of 1.30 m when light ad a draft of 2.95 m when loaded. The bottom length of the scow is 24.0 m. The waterline is 30.0 m long when the scow is loaded with rocks and 25.50m long when light. If sea water weighs 1026 kg/cum and the loaded dredged material weighs 3208 kg/cum, determine the following: a. volume of water displaced when unloaded of light b. displacement loaded c. weight of the water displaced by the load d. volume of the loaded rock

Q: A weir across an alluvial river has a horizontal floor length of 54 m and retains 6 m of water under…

A: Given: Length of the horizontal floor, b = 54 m Depth of sheet pile, d = 6 m Head length, H = 6 m

Q: At a hydraulic jump, the depths at its two sides are 0.3 m and 1.2m. The head loss in the jump is B…

A: Given- depths-y1=0.3 m,y2=1.2 m, It is needed to find the head loss in the jump.

Q: Q2: A six-story building of area (30 m x 50 m) is proposed to be constructed in Baghdad. The net…

A:

Q: (Ans.: Si(Total) = 5.75 mm). 1200 kN G.S. 1.0m 3m x 4m 2.0m 9c = 8000.kN /m²,..y = 20.kN /m³ %3D…

A: The initial pressure acting at the level of the base of the footing is equal to,  Po=γ×Df    =20×1…

Q: Topographic and bathymetric survey showed that the effective fetch of a reservoir is 1.6 km and that…

A: Question is based on the topographic and bathymetric survey . Effective fetch of reservoir, average…

Q: Q4/ The Fig. 4 shows a smooth curved vane attached to a rigid foundation. The jet of water,…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: An open channel having a slope of 0.0063 Is to carry 10 m3 /s. The channel material has an n value…

A: For most efficient triangular channel with given data it has been asked to find hydraulic mean…

Q: a hydraulic jump, the depths on the two sides e 0.4 m and 1.4 m. The head loss in the jump is early?

A: Depth,  y1 = 0.4 m  and y2 = 1.4 m

Q: length of sharp-crested rectangular weir (w/ end contractions) = 2 m Q = 0.89 m^3/s   What is the…

A: Given :  Rectangular sharp crested weir with end contractions. Length of weir, L = 2 m Discharge,…

Q: In a river 45ft wide, having an average depth of 3.5ft and a mean velocity of 2 fps, a contracted…

A:

Q: A launching apron is to be designed at downstream of a weir for discharge intensity of 6.5 m³/s/ For…

A: Discharge per unit width-silt factor f=1,tailwater depth d=4.4 m,It is needed to find the length of…

Q: using virchinl work Mthed EL= (0 KN, R= 1800 KN/M 4Krm Drad BM.D 600

A:

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A:

Q: ANSWER ASAP CALCULATE THE VERTICAL REACTION AT J

A:

Q: A triangular dam 3 m wide at the base and 5.6m high weighs 23.5 kN/m3. Take A = last digit of your…

A:

Q: 1.) The hull of seaQuest Deep Submergence Vehicle (DSV) can descend to a depth of 8.75km before…

A:

Q: For a depth of water of 0.5 m and Froude No. = 3 , the depth after the jump equals: 2 m, and the…

A:

Q: 7.8 10 m 24 m For the flow net drawn in Problem 7.7, calculate the uplift force at the base of the…

A: Given Data: Pressure head at the left end of the weir = 13 meter Difference in pressure in upstream…

Q: Calculate

A:

Q: Q3- A ) The dam shown below is 500 m in width (shore to shore )and including steel sheet pile , the…

A: Given data in question  Coefficient of permeability  Head difference  Width of dam Number of flow…

Q: Datum 8 m 2 m 12 m Ysar=17 kN/m² Permeable Layer hmpervious Laver

A: Consider the free body diagram; (a). Total head loss (h)=(8-2)                                 h…

Q: An office building is to be supported on a series of 1.8-m diameter, 18.0-m long solid pipe pile…

A: Given: D = 1.8 m L = 18 m F.O.S = 2.5 To find: The allowable downward capacity of the driven pile.

Q: A launching apron is to be designed at downstream of a weir for discharge intensity of 6.5 m³/s/m.…

A: Given- Discharge per unit width- q=6.5 m3/s/m, silt factor f=1, tail water depth d=4.4 m, Length of…

Q: 7.7 7.8 Draw a flow net for the weir shown in Figure 7.22. Calculate the rate of seep- age under the…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: Problem 2 For the completed flow net of Fig. 1, compute the flow under the dam per meter of dam if…

A:

Q: A line of sheet piling is driven 4 m into a firm clay and retains, on one side, 3 m depth od fill on…

A: Given values: Height upto which the pile is driven, h2= 4m Depth of fill on top of clay, h1= 3m Unit…

Q: Calculate: i. The wavelength and determine the water depth criterion in which the platform operates.…

A:

Q: Q4) A clay layer of 4m thickness is consolidated in the field under the load of temporary embankment…

A: Given:- The thickness of the clay layer = 4 m  The degree of consolidation (U) = 95% The liquid…

Q: sluice gate q = 5.5 m2/s y2 = 0.45 m V2 = 12.2 m/s EGL E 6. у + 2 gy 4. E= 8 m 3. vena contracta 0 1…

A: The step of solving the above equation  We have to put the given value in the governing equation…

Q: 2. In the design of a borehole, the radius of influence R cannot be established precisely and,…

A: Given data: Assumed radius of influence = 200 m radius of well = 250 mm Transitivity = 0.0208 s-1.…

Q: 3.) Using a f (allowable) of 200 MPa determine the most economical channel (lightest) that can be…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.