A rectangular deck scow 23.50 m long, 7.10 m wide and 3.23 m high has a draft of 1.22 m when light and a draft of 3.05 m when loaded. The bottom length of the scow is 13.15 m. The waterline is 21.26 m long when the scow is loaded with rocks and 18.69 m long when light. If sea water weighs 1026kg/cubic meters and the loaded dredged material weighs 3208kg/cubic meters, determine the volume of the loaded rock."

Q: Q2: A six-story building of area (30 m x 50 m) is proposed to be constructed in Baghdad. The net…

A:

Q: What bottom width and detph would you recommend?

A: ###Calculation of Maximum width and depth of trapezoidal Channel section ####

Q: 7) The floor of a weir is 20 m long with two sheet piles of 5 m at the downstream end and 4.5m at…

A: b = 20mH = 3.9mL1 = 4.5mL2 = 5m

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: jump is formed in a 2 m wide channel which is horizontal and A hydraulic rectangular frictionless.…

A:

Q: 6.12 For the same dam and the same soil conditions a 4-meter-long vertical sheet pile is added at…

A: The diagram is shown below, (a)  Draw the flow net by using, N= 3The total head loss during the…

Q: Topographic and bathymetric survey showed that the effective fetch of a reservoir is 1.6 km and that…

A: Question is based on the topographic and bathymetric survey . Effective fetch of reservoir, average…

Q: Theory of structure Drow S.F.d A.F.D B.M.D

A: Given Data  Draw axial force, Shear force and bending moment diagram.

Q: 1.5 kN A -3 m 3 kN -3 m- 3 kN E B -3 m- 3 kN -3 m 2 m 1.5 kN †² 2 m CI

A:

Q: For Broad crested weir, the discharge - V /29 EL passing over the weir of 3.55m in width was found…

A: The given figure is shown below:

Q: In a river 45ft wide, having an average depth of 3.5ft and a mean velocity of 2 fps, a contracted…

A:

Q: A launching apron is to be designed at downstream of a weir for discharge intensity of 6.5 m³/s/ For…

A: Discharge per unit width-silt factor f=1,tailwater depth d=4.4 m,It is needed to find the length of…

Q: The figure is a section of a masonry dam resting on a previous foundation and subjected to water…

A:

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: ANSWER ASAP CALCULATE THE VERTICAL REACTION AT J

A:

Q: Problem- A 50 cm diameter pipe carries water (v = 0.294 x 106 m²/s) at an average velocity of 10…

A: Given data- Diameter of the pipe d=50 cm=0.50 m, Viscosity- v=0.294×10-4 m2/s, Average velocity…

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A: Given Data: Width of fill=12m Side slope=1.5:1 Center height=20m Interval are= 3.7 m, 2.6 m, 4.0…

Q: 3. If a contracted rectangular sharp crested weir, 2m long is used. a. 587 c. 523 d. 563 b. 532

A: For contracted rectangular sharp crested weir  Q = 1.84 (L-0.2 H) H1.5 L= 2 m H = 0.3 m Q=…

Q: For an embankment dam, the longest fetch is equal to 10 km, and is normal to dam axis. Assume that…

A: Given data: Fetch of dam, F=10 km Upstream slope of dam=3H:1V Average depth of reserviour, D=25 m…

Q: Given h = 30 m, D= 40 m and the soil beneath the dam has a hydraulic conductivity of 3×103 cm/s.…

A: Given, h = 30 m D = 40 m  k = 3 x 10-3 cm/s or 3 x 10-5 m/s

Q: 1.) The hull of seaQuest Deep Submergence Vehicle (DSV) can descend to a depth of 8.75km before…

A:

Q: In a rectangular channel 3.5 m wide laid at a slope of 0.0036, uniform flow occurs at a depth of 2…

A:

Q: 7.8 10 m 24 m For the flow net drawn in Problem 7.7, calculate the uplift force at the base of the…

A: Given Data: Pressure head at the left end of the weir = 13 meter Difference in pressure in upstream…

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A: The volume of the embankment by average area method is V = ∈AnL The volume of the embankment by…

Q: Q3- A ) The dam shown below is 500 m in width (shore to shore )and including steel sheet pile , the…

A: Given data in question  Coefficient of permeability  Head difference  Width of dam Number of flow…

Q: Q:: For the flow net shown below, if the value of Ah=0.3 m, then find: 1- The pressure head of point…

A: Upto point A Pressure drop =potential drops upto ATotal potential drops ×ΔhPressure drop…

Q: A railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: 7.7 7.8 Draw a flow net for the weir shown in Figure 7.22. Calculate the rate of seep- age under the…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: 2. If a trapezoidal weir with sides inclined 14.04° with the vertical and a length of crest of 2m.…

A:

Q: Given h = 30 m, D= 40 m and the soil beneath the dam has a hydraulic conductivity of 3x10-3 cm/s.…

A: Given, h = 30 m D = 40 m  k = 3 x 10-3 cm/s or 3 x 10-5 m/s

Q: Problem 2 For the completed flow net of Fig. 1, compute the flow under the dam per meter of dam if…

A:

Q: A bar rack channel is planned for the maximum flowrate of 2.0 m^3/s. When the flow velocity in the…

A: Answer  we are given  Flow rate  Q = 2 m3/s constant flow velocity in the grit channel v = 0.3 m/s…

Q: 6 ft Shoe

A: Given:- k=10-3ft/sec To find:- seepagein permeable layer at a)x'=1ft b)x'=2ft

Q: Calculate the quantity of seepage from upstream to downstream Calculate the uplift force and its…

A: Flow net represents the flow of water underneath the soil i.e Seepage in a graphical representation.…

Q: sluice gate q = 5.5 m2/s y2 = 0.45 m V2 = 12.2 m/s EGL E 6. у + 2 gy 4. E= 8 m 3. vena contracta 0 1…

A: The step of solving the above equation  We have to put the given value in the governing equation…

Q: railway fill is 12 m wide. The ground is level in a direction transverse to the centerline. The…

A:

Q: For an embankment dam, the longest fetch is equal to 10 km, and is normal to dam axis. Assume that…

A: Given upstream slope of dam = 3H:1V average reservoir depth D =25m the longest fetch = 10 km To find…

Q: 3.) Using a f (allowable) of 200 MPa determine the most economical channel (lightest) that can be…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.