For Broad crested weir, the discharge - V /29 EL passing over the weir of 3.55m in width was found to be 12.48 m/s, and the height of the weir(P) is 2.0 m. What would be the specific Energy (E), the depth (H), the critical depth( y), and the brink depth (y) ?. Taking into account that the approach velocity (V1) is not neglected. H.

For Broad crested weir, the discharge - V /29 EL passing over the weir of 3.55m in width was found to be 12.48 m/s, and the height of the weir(P) is 2.0 m. What would be the specific Energy (E), the depth (H), the critical depth( y), and the brink depth (y) ?. Taking into account that the approach velocity (V1) is not neglected. H.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A rapid stream has a depth of flow 1 m and velocity of flow 3.7 m/sec. Find the height of suppressed…

Q: A rectangular channel of 2.5 m width is carring a discharge of 4m³/s. considering that acceleration…

Q: What bottom width and detph would you recommend?

A: ###Calculation of Maximum width and depth of trapezoidal Channel section ####

Q: A trapezoidal weir having side slope of 1Horizontal to 2Vertical discharges 50 m3/s under a constant…

A: Given data- A trapezoidal weir. side slope of 1Horizontal to 2Vertical discharge (Q) 50 m3/s…

Q: Determine the discharge, in L/s, over the weir having a head of 0.30 m if a a contracted rectangular…

Q: A singly-contracted weir 1.5m high is located in a 5m wide rectangular channel with a measured…

A: Height of weir,H=1.5 m Width of channel,B= 5m Discharge, Q=2.3 m3/s

Q: Situation 2: A reservoir with vertical sides has a plan area of 560 x 106 sq.cm. If the discharge…

A: Given : Plan area of reservoir with vertical sides, A = 56000 m2Crest length of the trapezoidal…

Q: 563..After setting a 31.2 cm wide broad crested weir at a section of Padma River, got the discharge…

A: Given: Actual discharge = 600LPM Theoretical discharge = 0.0107 m3/s

Q: A Cipolletti weir discharges water with the head of water over the crest being 250 mm. If the head…

A: The Cipolletti weir is a trapezoidal weir, having side slopes 1 horizontal to 4 vertical. The…

Q: 9. In discharge of water over narrow crested weir, discharge is directly proportional to the second…

A: formula for discharge over narrow crested weir Q=23Cd2gLH32

Q: 1.W: Design ogee spillway for a concrete gravity dam and find the maximum flo lischarge could be…

A: Design ogee spillwayQ =?d/s slope = 0.85H:1v height of crest of spillway = 310 m Avg. river bed…

Q: A V-notch weir is located (or cut) at one end of a tank having a horizontal square section 1 Sm (L)…

Q: A dam has a sloping apron stilling basin with a slope of 0.077. If the depth for a flood flow of…

A: Data is as shown

Q: Q7: A suppressed rectangular weir is to be built across a 4.5 m channel width to measure a flow rate…

A: width of channel =4.5mflow=1.2maximum water depth=1.2mFINDthe

Q: By placing a broad-crested weir, why we are able to measure discharge in the channel? O All the…

A: Broad Crested weird are used to get discharge in open channel and it also controls depth.

Q: A trapezoidal weir has a side slope of 1 horizontal to 4 vertical. The head over the weir is 2.5 ft…

Q: A singly-contracted weir 2.5m high is located in a 10m wide rectangular channel with a measured…

A: Given Data:z=2.5mL=10mQ=2.3m3/s

Q: In a rectangular open channel, 2.0 m wide, water flows at a depth of 0.8 m. It discharges over an…

A: given- width B=2 mdepth y=0.8 mCc=0.612g=4.43H=0.25 m

Q: End View Water Flow H B H= head or height of water the weir P= height of weir from bottom of channel…

Q: A suppressed weir 7.5m long is to discharge 10.125 m/s of water onto an open channel. The weir…

Q: A rectangular, sharp-crested suppressed weir 2.6 m long is 1.0 m high. Determine the discharge when…

A: Find the discharge for the rectangular, sharp-crested weir Length, L= 2.6m Head, H= 1.0m He= 180mm=…

Q: s to discharge 10.125 m3 /s of water onto an open channel. The weir factor Cw = 1.88. To what…

A: L=7.5mQ=10.125m3sCw=1.88d=1.8

Q: Q5/ Prove that the theoretical discharge over a sharp crested rectangle weir is: 2 2 theoretical -…

Q: In a wastewater treatment plant, primary sedimentation tank (PST) designed at an m’/day/m² is y 3…

Q: rectangular weir having a length of 1 m is constructed at one end of a tank having a horizontal…

A: Given Area = 10*20 = 200m^2 Volume 20*10*10 = 2000m^3 Discharge volume 72 m^3 Depth of discharge =…

Q: The pump-turbine system in the figure draws water from the upper reservoir in the daytime to produce…

A: Answer (21) We know that Power in Horsepower extracted by the turbine can be calculated using W˙t =…

Q: eir 1.5m high is located in a 5m wide rectangular channel v velocity of approach.

A: WE KNOW THE FORMULA Q=1.84(L)(H+ha32-ha32)ha=va22gva=QB(H+Z)Z=Weir height H=Height upstream…

Q: A 3.5m wide basin at a water treatment plant discharges flow through a 2.5m long singly contracted…

A: Data given Length of weir, L = 2.5 m number of contractions, n = 1 Weir discharge coefficient, Cw =…

Q: If there will be a heavy rain and 5m of rain will be poured over the weir, determine the time the…

A: Given, V = 1500,000 m3 H = 5 m

Q: Determine the discharge, in L/s, over the weir having a head of 0.30 m if a a contracted rectangular…

A: Given Data:Weir head = 0.30mLength = 2m It is required to calculate the discharge in L/S over the…

Q: he outlet from a reservoir is through a broad-crested weir in which the crest is at 5 m MSL. Which…

A: Given, Weir coefficient (C) = 0.183 Width (b) = 10 m

Q: Find the width (meter) of a suppressed weir using the following data: H = 25.8 cm; D = 2.485 m; Q =…

A: H=25.8cm Q=0.84m3/s

Q: A doubly-contracted weir, 1.25 m high, is to be installed in a channel 2.5 m wide. The maximum flow…

Q: 3. A weir with one end contracted has a length of 3'4". The constant head of water at the weir is…

Q: the crest if the sides are inclined 75'57'50" with the horizontal. The discharge over a trapezoidal…

A: Given: Q= 1.315 m3/s, L = 2m, Inclination = 75 deg 57 min 50 sec

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

V 29
For Broad crested weir, the discharge
passing over the weir of 3.55m in width was
found to be 12.48 m'/s, and the height of the
weir(P) is 2.0 m. What would be the
specific Energy (E), the depth (H), the
critical depth( y), and the brink depth (y)
?.Taking into account that the approach
velocity (V1) is not neglected.
EL

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Step 9

Step 10

Step by step

Solved in 10 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An unsymmetrical triangular weir with a vertex angle equal to a=51deg(left half) + b=40deg(right half). What is the flow rate through the weir (L/s) if the head over the crest is 3.8m? c=0.68 4.
I need the answer as soon as possible
a rectangulsr suppressed weir is placed on the side of a reservoir whose plan area is a constant 1038m2. when the weir is opened, the flow rate reaches elev 5.28m. eventually it reaches 4.77m. if the crest is situated at 4.43 when the weir is opened, how long it take to lower the depth flow to 4.77m? the weir is 1.3m long and has c=0.62
handwritten and fast
A 119-degree V-notch-weir was installed to measure the flow in an artificial channel. The crest of the weir is located 2.25m high relative to the channel bed. Depth of overflow above the crest is 0.41m. Determine the discharge in L/s. Neglect velocity of approach. c = 0.58.
32
A circular settling basin is anticipated to receive a flow of 3.5 MGD. The tank is to be designed to have an overflow rate of 800 gpd/ft2. The depth is to be 11 ft. Determine the diameter of the basin (in feet). ? What length of weir (ft) is required to achieve a weir loading of 15,000 gpd/ft show all work
In 28.5 secs, 35,579 L of water is collected. The length of the rectangular weir is 2.15 m, the crest is 450 mm high from the channel bed and it should maintain a constant head of 275 mm. Determine the velocity of approach. Assume there is head loss.
2. A hydraulic jump 15 OCCuring In a roctangulav channel with 2m width Flowrate and depth of water at the upstream of jump are given as S.o m/s and O.25 m-Estimote a) depth of water at the downstream of jump (y2). b) Enerqy loss