Reaction of a drug with oxidation is minimized by: i. proper selection of packaging material, ii. proper selection of polymer used for film coating over the tablet, iii. removal of oxygen over the surface of the drug in a package. Reaction of a drug with oxidation is minimized by: i. proper selection of packaging material, ii. proper selection of polymer used for film coating over the tablet, iii. removal of oxygen over the surface of the drug in a package. a) Only iii is correct b) Only ii is correct c) All are correct d) Only i is correct

Reaction of a drug with oxidation is minimized by: i. proper selection of packaging material, ii. proper selection of polymer used for film coating over the tablet, iii. removal of oxygen over the surface of the drug in a package. Reaction of a drug with oxidation is minimized by: i. proper selection of packaging material, ii. proper selection of polymer used for film coating over the tablet, iii. removal of oxygen over the surface of the drug in a package. a) Only iii is correct b) Only ii is correct c) All are correct d) Only i is correct

Holt Mcdougal Larson Pre-algebra: Student Edition 2012

1st Edition

ISBN:9780547587776

Author:HOLT MCDOUGAL

Publisher:HOLT MCDOUGAL

Chapter1: Variables, Expressions, And Integers

Section1.5: Adding Integers

Problem 45E

See similar textbooks

Similar questions

Three different corrosion-resistant coatings are being considered for use on iron pipes. Ten pieces of pipe are marked off in six equal segments. For each pipe, two segments received coating A, two received coating B, and the remaining two received coating C. The pipes were placed in a corrosive environment for a period of time; then the depth of the deepest pit (in mm) caused by corrosion was measured for each segment on each pipe. The effect of interest is the coating; the pipe is a blocking factor, and there were two replications on each pipe. The following sums of squares were calculated: sum of squares for blocks = 11.2, sum of squares for treatments = 4.8, sum of squares for interactions = 18.4, total sum of squares = 44.7. a) Construct an ANOVA table. You may give ranges for the P-values. b) Are the assumptions for a randomized complete block design satisfied? Explain. c) Does the ANOVA table provide evidence that mean pit depth differs among coatings? Explain.
3) An inventor has developed a new spray coating that is designed to improve the wear of bicycle tires. To test the new coating, the inventor randomly selects one of the two tires on each of 50 bicycles to be coated with the new spray. The bicycle is then driven for 100 miles and the amount of the depth of the tread left on the two bicycle tires is measured (in millimeters). It is desired to determine whether the new spray coating improves the wear of the bicycle tires. The data and summary information is shown below: Bicycle | Coated Tire (C) | Non-Coated Tire (N) 0.785 1.452 1.634 0.844 50 1.211 0.954 Coated Non-Coated Difference Мean 1.38 0.85 0.53 Std. Dev. 0.12 0.11 0.06 Sample Size 50 50 50 Use the summary data to calculate the test statistic to determine if the new spray coating improves the mean wear of the bicycle tires. A) z = 62.46 В) — 34.25 C) z = 55.26 D) z = 23.02
Solar energy generation along highways. The potential of using solar panels constructed above national highways to generate energy was explored in the International Journal of Energy and Environmental Engineering (December 2013). Two-layer solar panels (with 1 meter separating the panels) were constructed above sections of both east-west and north-south highways in India. The amount of (kilowatt-hours) supplied to the country's grid by the solar panels above the two types of highways was determined each month. The data for several randomly selected months are provided in the table. The researchers concluded that the "two-layer solar panel energy generation is more viable for the north-south oriented highways as compared to east- west oriented roadways." Compare the mean solar energy amounts generated for the two types of highways using a 95% confidence interval. Does the interval support the re- energy searchers' conclusion? Month East-West North-South February April July September…
Q2) Researchers at a paint manufacturer are trying to develop a new type of gloss paint with a shorter drying time than the current product. In order to test whether the drying time has been reduced, the researchers paint a square metre of each of the new and old paints on each of 10 different surfaces. The time, in hours, that each square metre takes to dry is recorded in the table below: Surface 1 2 3 4 5 6 7 8 9 10 Old paint 17.1 17.3 16.9 17.4 17.5 17.3 16.6 17.5 18.0 17.6 New paint 16.6 17.2 17.0 17.1 17.6 16.5 16.9 17.3 17.3 16.9 (a) Test, at the 0.05 level of significance, whether there is any reduction in the mean drying time. (b) State the assumption required to carry out the test in (a). (c) Find the p-value of the test in (a). (?? Marks)
1. A wet free-milling gold ore sample weighing 150 kg was delivered to an assayer to determine the grade of gold in the ore. The moisture content of four replicate samples from the bulk material were determined (Table 1). The team also took triplicate samples weighing 50 g (dry weight) each for fire assaying, and the average gold content per sample was 0.35 mg. a) Find the average percent moisture of the bulk material. b) Estimate the quantity (in mg) of gold in the sample. One Samples Wet weight (g) Two Three Four 105 95 90 100 Dry weight (g) 85.6 76.5 85.5 84 31 31
Plz do (i) for me
1. Order: Colace Syrup 20 mL Label: Colace Syrup (docusate sodium) 20 mg per tsp (teaspoon) Use dimensional analysis to determine how many tsp will the patient need based on this order. 2. The order is for Zosyn 1.3 g to be infused in 100 mL D5W (dextrose 5 % in water) over a period of 30 minutes (the drop factor is 60 gtt/mL). Use dimensional analysis to determine the flow rate for this infusion in mg per min (mg/min).
7. In the manufacturing of a chemical adhesive, 3% of all batches have raw materials from two different lots. This occurs when holding tanks are replenished and the remaining portion of a lot is insufficient to fill the tanks. Only 5% of batches with material from a single lot require reprocessing. However, the viscosity of batches consisting of two or more lots of material is more difficult to control, and 40% of such batches require additional processing to achieve the required viscosity. Let A denote the event that a batch is formed from two different lots, and let B denote the event that a lot requires additional processing. Determine the following probabilities: а. Р(А) b. P(A') c. P(B|A) d. P(B|A') e. P(ANB) f. P(ANB') д. P(B)
How wellmaterials conduct heat matters when designing houses, forexample. Conductivity is measured in terms of watts of heatpower transmitted per square meter of surface per degree Celsius of temperature difference on the two sides of the material.The National Institute of Standards and Technology (NIST)provides data on properties of materials. Here are 9 NISTmeasurements of the heat conductivity of a particular type offibrous-glass board: 0.0339 0.0337 0.0334 0.0334 0.03330.0333 0.0333 0.0332 0.0330 (a) We can consider this an SRS of all specimens of fibrousglass board of this type. Make a stemplot. Is there any sign ofmajor deviation from Normality? (b) Give a 95% confidence interval for the mean conductivity. (c) Is there significant evidence at the 5% level that themean conductivity of this type of fibrous-glass board is not0.0330?
1. Solve for a when x = and z = = 3.19, 8.1 and σ = 4.7. 2. Claim: More than 3.8% of homes have only a landline telephone and no wireless phone. Sample data: A survey by the National Center for Health Statistics showed that among 14,424 homes 5.76% had landline phones without wireless phones. Complete parts (a) and (b). (a) Express the original claim in symbolic form. Let the parameter represent a value with respect to homes that have only a landline telephone and no wireless phone. (b) Identify the null and alternative hypotheses. 3. In a test of a sex-selection technique, results consisted of 228 female babies and 10 male babies. Based on this result, what is the probability of a female being born to a couple using this technique?
Wild irises are beautiful flowers found throughout the United States, Canada, and northern Europe. This problem concerns the length of the sepal (leaf-like part covering the flower) of different species of wild iris. Data are based on information taken from an article by R. A. Fisher in Annals of Eugenics (Vol. 7, part 2, pp. 179 -188). Measurements of sepal length in centimeters from random samples of Iris setosa (I), Iris versicolor (II), and Iris virginica (III) are as follows below. I II III 5.7 5.4 6.8 4.1 6.3 5.4 5.0 6.7 4.4 5.4 4.3 7.3 4.6 5.5 5.3 5.7 6.5 6.7 5.2 5.3 6.8 Shall we reject or not reject the claim that there are no differences among the population means of sepal length for the different species of iris? Use a 5% level of significance. (a) What is the level of significance?State the null and alternate hypotheses. Ho: ?1 = ?2 = ?3; H1: All three means are different.Ho: ?1 = ?2 = ?3; H1: Not all the means are equal. Ho: ?1 = ?2 = ?3;…
Wild irises are beautiful flowers found throughout the United States, Canada, and northern Europe. This problem concerns the length of the sepal (leaf-like part covering the flower) of different species of wild iris. Data are based on information taken from an article by R. A. Fisher in Annals of Eugenics (Vol. 7, part 2, pp. 179 -188). Measurements of sepal length in centimeters from random samples of Iris setosa (I), Iris versicolor (II), and Iris virginica (III) are as follows below. I II III 5.7 5.1 6.5 4.7 6.2 5.1 4.7 6.6 4.7 5.8 4.9 7.5 4.6 5.2 5.3 5.3 6.2 6.2 5.4 5.8 6.4 (b) Find SSTOT, SSBET, and SSW and check that SSTOT = SSBET + SSW. (Use 3 decimal places.) SSTOT = SSBET = SSW = Find d.f.BET, d.f.W, MSBET, and MSW. (Use 4 decimal places for MSBET, and MSW.) dfBET = dfW = MSBET = MSW = Find the value of the sample F statistic. (Use 2 decimal places.)What are the degrees of freedom? (numerator) (denominator)