QUESTION 6 What mass of ethane, C2H6, contains the same number of molecules as 3.00 g of trichlorofluoromethane, CCl3F? 13.7 g O 0.655 g 1.52 g 0.0727 g QUESTION 7 How many oxygen atoms are there in 7.00 g of sodium dichromate, Na2Cr207? 0.187 oxygen atoms 22 1.60 x 10 oxygen atoms oxygen atoms 21 2.30 x 10 oxygen atoms 1.13 x 10 23

Q: K Maya Paniagua - RC Ch 10 HW.p X E The State of Nature & the Social The School District of Palm…

A:

Q: a student reacted 14.6 kg of aluminium metal with excess platinum(IV) bromide solution. After the…

A:

Q: Please answer the last three question (c, d and e). The answers are: (c) 3.63 × 10^9 events (d)…

A:

Q: What is chromatography, and how does it work?

A: Chromatography is a scientific method for extracting constituents of a mixture. The mixture is…

Q: Determine the pH of each of the following solutions.

A:

Q: An electric current of 26.30 A transports 350. µC of charge. Calculate the time this toc Be sure…

A:

Q: Prepare a solution of NaCl by accurately weighing approximately 1.45g of NaCl into a 100 mL beaker /…

A: Molality (m)=Moles of soluteMass of solvent in kg mol/kg Mass of NaCl added=1.45gMolar mass of…

Q: : Calculate the increase factor in the fraction of surface atoms when macro sphere 1 m in diameter…

A:

Q: The mass of magnesium used in this experiment is critical to determining the moles of hydrogen gas…

A: The reaction considered is the formation of H2 gas by the reaction of Mg with HCl. The balanced…

Q: (optional) Blue turquoise is an example of a hydrate mineral containing copper; the chemical formula…

A: Mass percentage of any component may be calculated as, Mass percentage = mass of the component total…

Q: Perform the following calculations and record your final answer with the correct number of…

A: The significant figure refers to particular digits in a number. According to the measurement rule,…

Q: Straight-chain, saturated carboxylic acids, a class of hydrocarbons, has the general formula…

A: We need to calculate %C by mass for n=12 in the formula CnH2n+1COOH  Atomic weights C = 12.01 g H =…

Q: Questions: 1. Write the transition metals that you tested in order from 2. Find copper, iron, and…

A: 1) Osmium is most dense transition metal with density of approx 22.59g/cm³c Whereas scandium has the…

Q: If you do not heat your crucible strongly enough to remove all volatile impurities when you heat the…

A: The loss of water happening during the inital heating or during the second heating is not relevant.

Q: 1. During the set-up of a distillation or a boiling point apparatus, the position of the bulb of the…

A: Solution - The process of distillation totally depends on temperature of liquids . That’s why…

Q: tion of the following Sodium sulfate Express your answer as a chemical equation. Identify all of the…

A: The objective of the question is to write the chemical equations for Sodium sulfate and…

Q: (b) Potassium nitrate was synthesized in an experiment using 10 mL of nitric acid and excess…

A: From the given weight of the product pottasium nitrate and the percentage yield, we can easily…

Q: List two (2) chemical grade and its purity

A:

Q: An electric current of 30.10 A transports 120. µC of charge. Calculate the time this took. Be sure…

A: The charge transport in a unit of time is known as electric current.. The current is calculated by…

Q: A cvg.cengagenow.com/ilrn/takeAssignment/takeCXPCompliantActivity.do?locator%3Dassignment-take…

A: The aluminum in a package containing 77 ft2 of kitchen foil weighs approximately 19 ounces.  Density…

Q: In a 1.1M aqueous solution of acetic acid (CH,CO,H), what is the percentage of acetic acid that is…

A:

Q: Suppose that in a random selection of 100 colored candies, 25% of them are blue. The candy company…

A: Number of colored candies = 100 Percent of blue candies = 25 % Company claims that the percentage of…

Q: Suppose a student measured the mass of a sample that has a known mass of 40.5809 g using an…

A:

Q: Two scales were being used in the whole scenario, the first one is a truck scale and the second one…

A: Both the truck scale balance and the analytical balance are used to measure the mass or say the…

Q: What are the name of the apparatus, description and uses. NOTE: please answer it in handwritten.…

A: We have to tell the name of the apparatus, description and uses.

Q: An electric current of 26.20 A flows for 246. milliseconds. Calculate the amount of electric charge…

A: Given Current (i) = 26.20 A Time (t) = 246 milliseconds              t = 246× 10-3 seconds Amount of…

Q: Fill in the blanks Choose below the correct coefficients of the substances, respectively. NH3 (g) +…

A: A balanced chemical equation contains equal number of atoms of each elements on both the reactant…

Q: 62.6×13

A: Given that : We have to perform the following calculation : 62.6×13

Q: An electric current of 25.80 A transports 0.30 kC of charge. Calculate the time this took. Be sure…

A:

Q: how did you get a negative answer for part a the correct answer should be 31.508

A: The given data 2 NO(g) + O2(g) --> 2NO2(g)  ∆Horxn = -12kJ and ∆Sorxn = -146J/K The standard…

Q: Four research teams measured the density of a new alloy, and what each team wrote in its team…

A:

Q: Fill in the blanks Choose below the correct coefficients of the substances, respectively. NH3 (g) +…

A: Given the reaction is, NH3 +O2---‐>N2 +H2O we have to balance this reaction.

Q: Consider the reaction below: Pt(NO3)4 (aq) + 4 NaClag) ----> PtCl4(s) + 4 NaNO3{aq) The sum of the…

A: given balanced reaction, Pt(NO3)4 (aq) + 4NaCl(aq) → PtCl4(s) + 4NaNO3(aq)

Q: the density of silver is 10.5 g/cm what is the density in kg/m3

A: 1 Kg = 103 g 1 g = 10-3 Kg 1 L = 103 mL 1 L = 103 cm3 1 L = 10-3 m3 10-3 m3 = 103 cm3 10-6 m3 = 1…

Q: A method of analysis yields masses of gold that are lower by 0.40 mg. Calculate the percent relative…

A: The percentage relative error is percentage discrepancy in finding out the exact value of a…

Q: 234TH 226 8Ra + -> 90

A: we know , number of emitted alpha perticles=final mass -initial mass 4 number of emitted beta…

Q: A) Impurity was an acid B) Impurity were not acids C) Sample was wet

A: Sampling is an important step in analysis.  Sample is a small portion of the large quantity of the…

Q: 2) For a separate job, you are asked to assemble a number of tricycles by attaching wheels to the…

A: No. Of complete frames=70 No.of rear wheels=123 No. Of front wheels=74 For 1 complete tricycle, no.…

Q: Calculate range of volumes representing 0.1% tolerance of a 25.00 mL volumetric pipette assuming…

A:

Q: Question 17/17 ميز هذا السؤال What mass of K,Fe(CN)6 is needed to prepare 900 mL of 0.0740 M K…

A: given, volume of K+ solution = 900 mL = 0.9L molarity of K+ solution = 0.0740M K3Fe(CN)6 → 3K+ +…

Q: The absorbance of a cationic iron(II) sample solution was measured in a spectrophotometer, but the…

A: The volume of concentrated solution is 100.0µL Concentration of the diluted solution = 6.21×10-6 M…

Q: A sample of freshly precipitated and filtered silver chloride weighs 459.0 mg. If 1.00% of the…

A:

Q: student reacts 1.53 kg of magnesium metal with excess titanium(III) chloride solution. After the…

A:

Mole Concept

Mole concept is a method to determine the amount of any substance that consists of some elemental particles using a grouping unit called ‘mole’. The mole concept enables one to handle the large amount of small elementary particles. The mole concept can be used in many calculations related to mole calculation, molar amount, mole ratio, and so on, which are significant in chemistry.