Question 12 Chapter 3 Route Aggregation Organization o 100.40.50.0/23 Aggregated Network A.B.C.D/M Organization 1 100.40.60.0/23 ISP-A Organization 2 100.40.70.0/23 Internet Organization 3 100.40.80.0/23 In the figure above, BGP is used for inter-AS routing. ISP-A is then going to advertise a single route to access all the 4 networks at the left side (i.e. networks of Organizations 0 to 3). Q1. What is the aggregated network that is advertised by ISP-A? Write down the 4 parts of the address. different input boxes. i.e. if the address is a.1.2.3.4, write down '1' in the first box, '2' in the second box, etc. • Network Address • Mask: NOTE: Use this link for decimal-to-binary & binary-to-decimal conversion: decimal <--> binary conversion

Question 12 Chapter 3 Route Aggregation Organization o 100.40.50.0/23 Aggregated Network A.B.C.D/M Organization 1 100.40.60.0/23 ISP-A Organization 2 100.40.70.0/23 Internet Organization 3 100.40.80.0/23 In the figure above, BGP is used for inter-AS routing. ISP-A is then going to advertise a single route to access all the 4 networks at the left side (i.e. networks of Organizations 0 to 3). Q1. What is the aggregated network that is advertised by ISP-A? Write down the 4 parts of the address. different input boxes. i.e. if the address is a.1.2.3.4, write down '1' in the first box, '2' in the second box, etc. • Network Address • Mask: NOTE: Use this link for decimal-to-binary & binary-to-decimal conversion: decimal <--> binary conversion

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Consider the network depicted in the below figure. Suppose that router R1 receives a packet Pktl from host PC1. The length of packet Pktl is L = 25 Mbit. Router R1 takes 0.4 msec to determine the output link of packet Pktl. Packet Pktl is to be forwarded. through the output link to router R2. Packet Pktl waits 136 ms at the output link for transmission. The transmission link of the link between router R1 and router R2 is R = 5 Mbps. The distance between router R1 and router R2 is 400 Km and the propagation speed over the link is 2*108 m/s. PC1 a. b router R2. R1 R2 R3 Find the queuing delay of packet Pktl at router R1. Find the propagation delay of packet Pktl over the link from router R1 to
Consider the following situation: Source node has packets number 1, 2, 3, 4, 5, 6, 7, and 8 to send to the destination Source starts transmitting and packet 3 is lost on its way to its destination. The rest of ACK and data packets arrive successfully Window size is 5 packets ACKs are packet number-based. Draw a diagram that illustrates what happens in the network during sender’s transmission of packets 1 – 8 when Go-Back-N protocol is used and a diagram that illustrates what happens when Selective Repeat is used. Initial diagrams have been already drawn for you. You need to complete the drawing.
Q1
Computer Science IP is a Routed Protocol, just like ICMP and IGMP: whereas RIP, OSPF, BGP are all Routing Protocols, Could you please ustrato the respective roles, interactions and co-working of P4 and TOP 4 v6) with the OSPF and BGP in case of a Router that separates and interconnects Intranet of a large campus to the Internet? You may assume that this Router is one of the multiple Layer-3 devices that the campus has and that this router has three connected LAN interfaces and three connected WAN interfaces. Does this kind of interaction require any specific protocol that is NOT explicitly listed above? If so, which one(s) and why?
cs network
Suppose a router has built up the routing table shown in Table 3.19. The router can deliver packets directly over interfaces 0 and 1, or it can forward packets to routers R2, R3, or R4. Assume the router does the longest prefix match. Describe what the router does with a packet addressed to each of the following destinations: (a) 128.96.171.92 (b) 128.96.167.151 (c) 128.96.163.151 (d) 128.96.169.192 (e) 128.96.165.121 Table 3.19 Routing Table for Exercise 56 SubnetNumber 128.96.170.0 128.96.168.0 128.96.166.0 128.96.164.0 (default) SubnetMask 255.255.254.0 255.255.254.0 255.255.254.0 255.255.252.0 NextHop Interface 0 Interface 1 R2 R3 R4
Imagine you are the network administrator of University X having 10 campuses in Towson, Maryland. You want to build a connected network of servers (each server is either a regular or a routing one), one at each campus, and want to choose some of them to be the designated routing servers. A routing server will serve regular servers who connect directly to it via high speed cables, and every regular server must connect to at least one routing server. Your goal is to minimize the total length of high speed cable that you must purchase. Given the locations of the 10 campuses, design a plan that requires (1) the shortest length of cable and (2) the least number of routing servers.
59. Consider the network in Figure 3.56, using link-state routing. Suppose the B-F link fails, and the following then occur in sequence: (a) Node H is added to the right side with a connection to G. (b) Node D is added to the left side with a connection to C. (c) A new link D-A is added. The failed B-F link is now restored. Describe what link-state packets will flood back and forth. Assume that the initial sequence number at all nodes is 1, that no packets time out, and that both ends of a link use the same sequence number in their LSP for that link, greater than any sequence number either used before. IFIGURE 3.56 Network for Exercise S9.
Which two statements about routing protocols are true (choose 2). a) OSPF elects designed routers on multi-access links. b) RIP does not support classless routing. c) EIGRP uses broadcast traffic to establish adjacencies with its neighbors. d) RIP does not advertise a route beyond a hop count of 15. e) IBGP is an internal routing protocol.
4. An ACK segment that carries data will not consume sequence number. True / False. Answer: 5. 127.0.0.0 network is used as address. Answer: 6. In static routing, the routing table configurations will be modified by Answer:
In the above network diagram, IP and MAC addresses are given for network nodes. Suppose Host1 (Shahid) sends a datagram to Host2 (Khalid). What IP and MAC addresses (source and destination) will be written in IP and Data link layer headers respectively, for the following intermediate points from Host1 to Host2?a) Host1 to Router1 (R1)b) Router1 to Router2 (R2)c) Router2 to Host2
I need help