Suppose that the packet length is L= 16,000 bits, and that the linktransmission rate along the link to router on the right is R = 100 Mbps. Whatis the Transmission delay (for one particular packet only)?L: packet length (in bits)R: link transmission rates (Mbps)Queue of packetswaiting for output link

A single router is transmitting packets, each of length L bits, over a single link with transmission…

Suppose that the packet length is L= 16,000 bits, and that the link transmission rate along the link to router on the right is R = 100 Mbps. Wh is the Transmission delay (for one particular packet only)?

Suppose that the packet length is L= 16,000 bits, and that the link transmission rate along the link to router on the right is R = 100 Mbps. Wh is the Transmission delay (for one particular packet only)?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 10VE

See similar textbooks

Related questions

Q: Consider a two-link network in which Host A has a 1 Mbps connection with a 10 ms propagation delay…

A: Intro The question is about to Consider a two-link network in which Host A has a 1 Mbps connection…

Q: Consider a router that transmits bits onto a transmission medium at the rate of 2 Mbps. Let the link…

A: Given: Bandwidth = 2 Mbps => 2 *106 bits/sec Distance = 3 km Speed = 3 * 108 meter/sec…

Q: Let the two host X and Y connected via a packet switch with 107 bits per second links. Switch is…

A: Solution: Data: File size = 1000 bytes Length of packet = L = 500 bytes = 500 x 8 bit Number of…

Q: How long does it take a packet of length 1,000 bytes to propagate over a link of distance 2,500 km,…

A: Explanation: The time taken by the data packet length 1000 bytes with link distance of 2500 km,…

Q: Consider sending real-time data from Host A to Host B over a packet-switched network. Host A takes…

A: Given: Real-time data is being sent from Host A to Host B over a packet-switched network. Host A…

Q: Suppose that there are three inter-media nodes between Host 1 and Host 2, and the transmission rate…

A: Given that, Transmission rate or Band width= 4.096 Mbps End to end circuit establishment time= 0.5…

Q: How long does it take a packet of size 10 KB to travel over three links (connection) with a…

Q: A link has a transmission speed of 1010 bits/sec. It uses data packets of size 2000 bytes each. The…

A: Transmission Speed(B) = 1010 bits/second Data Packet size (L)= 2000 bytes Transmission time=…

Q: How long does it take a packet of length 1,000 bytes to propagate over a link of distance 2,500 km,…

A: Solution: (1) Given, =>Packet length(L) = 1000 bytes =>Propagation speed(s) = 2.5*10^8 m/s…

Q: Suppose that KJ sends 3596 back-to-back packets, with each packet composed of 14,000 bits, to TA…

A: To find delay

Q: Let a denote the rate of packets arriving at a link in packets/sec, and let μ denote the link’s…

A: Consider the following data:

Q: Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107…

A: Given: -> Transmission speed or bandwidth = 107 bits/sec -> Data packets size = 400 bytes…

Q: A packet switch receives a packet and determines the outbound link to which the packet should be…

A: GIVEN INFORMATION: Packet length(L)= 1,500 bytes. Transmission Rate(R)= 2 Mbps that is 2x106 bps.…

Q: Given that you are to transfer a total datagram of size 28939 bytes over a network that has an MTU…

A: In this question we have to understand about transmission of a datagram over a network with a…

Q: a. Suppose N packets arrive simultaneously to a link at which no packets are currently being…

A: Consider the following data, “N” denotes number of packets. “L” denotes the length of each packet.…

Q: We define data link layer communication efficiency as the ratio between a packet transmission time…

A: The complete answer is given below.

Q: idth of 2 Gbps. 000 bytes. The een P and Q is ance between tance between

Q: In this problem you will be doing some elementary calculations of transmission and propagation…

A: In this problem you will be doing some elementary calculations oftransmission and propagation…

Q: eter pe 10,000 Let Tt the pr

Q: Consider a router that transmits bits onto a transmission medium at the rate of 2 Mbps. Let the link…

A: Transmission delay = packet size / bandwidth Transmission delay is the total amount of time required…

Q: COMPUTING THE ONE-HOP TRANSMISSION DELAY Consider the figure below, in which a single router is…

A: The amount of time it takes for a signal or piece of data to go from source to recipient over a…

Q: Consider a two-link network where Host A is connected to the router by a 1 Mbps link with 10 ms…

A: The Answer is in given below steps

Q: Consider a client and a server connected through one router. Assume the router can start…

Q: er two hosts C & D connected by a point-to-point link with a data link rate of 10 Gb/s. The hosts…

Q: A packet switch receives a packet and determines the outbound link to which the packet should be…

A: Given information: Packet length (L) = 1200 bytes Transmission rate (R) = 2 Mbps that is 2*106 bps.…

Concept explainers

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.

Question

Suppose that the packet length is L= 16,000 bits, and that the link
transmission rate along the link to router on the right is R = 100 Mbps. What
is the Transmission delay (for one particular packet only)?
L: packet length (in bits)
R: link transmission rates (Mbps)
Queue of packets
waiting for output link

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: given

VIEW

Step 2: explanation

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

Multi-hop network: Given two hosts A and B, and one router between them. Packet size is L bits and the link bandwidth is R bps for both links.Suppose A has two packet to send to B.How long does it take starting from A sending the first bit of first packettill B receives the last bit of the last packet?
Consider a router buffer preceding an outbound link. In this problem, you will use Little’s formula, a famous formula from queuing theory. Let N denote the average number of packets in the buffer plus the packet being transmitted. Let a denote the rate of packets arriving at the link. Let d denote the average total delay (i.e., the queuing delay plus the transmission delay) experienced by a packet. Little’s formula is N=a⋅d . Suppose that on average, the buffer contains 10 packets, and the average packet queuing delay is 10 msec. The link’s transmission rate is 100 packets/sec. Using Little’s formula, what is the average packet arrival rate, assuming there is no packet loss?
Given a single link of length 800 Km and transmission speed of 49 Mbps between a client and a web server. Assume the client web browser sends a small Http request (packet) of 40 bytes to the web server at the other end. Data travels through the links at the speed of (2 x 108 meters/sec) and Queuing delay = processing delay =0. The propagation delay in microseconds is The transmission delay in microseconds of the packet of size 40 bytes is Calculate the Round-trip time (RTT) in microseconds if a upon receiving the packet the web server sends a response packet with the same size.
Don't try to copy others. Send unique answer only.
Router R1 is connected to another router R2 with link of L1 with a transmission rate of 67 packets/second. The link buffer at router R1 contains on an average 15 packets. There is one packet being currently transmitted. Average packet queuing delay is 15 milliseconds. Assuming no packet loss, what is the average packet arrival rate at R1?
Question 1 Suppose P packets arrive simultaneously to a link at which three packets are currently queued and one just started transmission. All packets are of length L and the link has transmission rate R. What is the average queuing delay for the P packets? Full explain this question and text typing work only thanks