Q5/ A gaseous mixture of CO, COz. CH4, and N2 is analyzed with a gas chromatograph. The output appears on a computer monitor, as shown in below table. M Component co CH4 No. moles 40 25 28 16 80 44 CO2 CH-20 28 N2 For each of the three species, the area under the peak is approximately proportional to the number of moles of the indicated substance in the sample. From other information, it is known that the molar ratio of methane (CH.) to nitrogen is 0.200. (a) What are the mole fractions of the four species in the gas? (b) What is the average molecular weight of the gas?

Q: Using phenolphthalein indicator, titration of 20.0 mL of 35% Barium Hydroxide required 81 mL of a…

A: The volume of Ba(OH)2 present = 0.35*20 = 7mL Density of Ba(OH)2 = 3.74 g/mL So, mass present =…

Q: A binary hydrocarbon liquid mixture of A and B (K = 1.5) containing 60 mole percent A is flash…

A:

Q: Liquid hexane (CH, (CH₂), CH₂) reacts with gaseous oxygen gas (0₂) to produce gaseous carbon dioxide…

A:

Q: Q2) Find the combustion of ethyl-alcohol (C,H;OH) in a petrol the stoichiometric A/F ratio for…

A: (1) Find A/F ratios for 0.9 & 1.2 equivalence ratio (2) Find wet and dry analyses of exhaust gas…

Q: A 5 liter flask containing nitrogen at 5 atm was connected to a 4 liter flask containing helium at 4…

A: Given that, The volume of nitrogen V1 = 5 liter The pressure of nitrogen P1 = 5 atm The volume of…

Q: Example 4.2. HNO, and 8 wt% water, by mixing You are asked to make 1,000 kg of the mixed acid…

A:

Q: Calculate the volume of aqueous solution (density = 980 g/L) produced after treating 100 moles of…

A:

Q: Question 1 A vapour stream flows into an absorber at a flow of 100 mol/s. The composition of the…

A: Given:The flow rate of the vapor stream Component Mol%Water1diethyl ether4n-butanol2n-butane93The…

Q: Calorimetry can be used to measure enthalpy of a reaction and Hess's Law involves adding equations…

A: Using HESS law: Complete combustion of CH4 is given as CH4+2O2→CO2+2H2O Enthalpy for this reaction…

Q: Aqueous sulfuric acid (H,SO,) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A:

Q: Gaseous ethane  CH3CH3  will react with gaseous oxygen  O2  to produce gaseous carbon dioxide…

A:

Q: Gaseous ethane (CH,CH,) will react with gaseous oxygen (0,) to produce gaseous carbon dioxide (CO,)…

A: Write the reaction between CH3CH3 and O2 as follows: CH3CH3 + 72O2 → 2CO2 + 3H2O  1 mole of CH3CH3…

Q: Calculate the bubble point temperature for a liquid hydrocarbon mix of 30% n-pentane and 70%…

A: The temperature at which a liquid-vapor mixture's first bubble of vapor appears when the temperature…

Q: Aqueous hydrobromic acid (HBr) reacts with solid sodium hydroxide (NaOH) to produce aqueous sodium…

A: The balanced reaction between HBr and NaOH to produce NaBr and H2O is written as, HBr (aq) + NaOH…

Q: A binary mixture of benzene bottom product contains 91.8 Type your answer in mol/h, 2

A: Given that- The binary feed (F) has- (supposing mol of benzene =X and mole of toluene=Y) Benzene,…

Q: E.81 wA fuel gas produced by gasifying coal is to be burned with 20% excess air. The gas contains…

A: Coal gasification is the process of producing syngas that contains carbon monoxide, carbon dioxide,…

Q: Consider a mixture of methanol (55%), formaldehyde (23%) and a variety of other solvents. If the…

A: a) Given data: Methanol (55%) Formaldehyde (23%) and 22 % are a variety of other solvents. Let the…

Q: Relative  volatility  is  a  measure  of  the  difference  between  the  vapour  pressure  of  the…

A: The term volatility is generally used when handling liquids. Volatility is a measure of vaporizing…

Q: You have a 1 g sample of an alloy containing Al and Mg dissolved and treated to prevent…

A: Given: Weight of Alloy = 1 g Weight of all precipitates = Al(C9H6NO)3(g)+ Mg(C9H6NO)2(g) = 7.98 g…

Q: A mixed brine by electrolysing, a gaseous mixture is obtained at the cathode having the following…

A:

Q: 1. A petroleum refinery has run out of chromium sulfate that would convert the alkenes to alkanes.…

A:

Q: Many crude oils contain dissolved hydrogen sulphide  H2S  and carbon dioxide  CO2  that are referred…

A: To describe three methods or processes used to remove H2S and CO2 from fuel gases. We have described…

Q: It is desired to fractionate a given mixture of a binary volatile liquid with an initial composition…

A: Given Data : Initial composition of feed (Xf) = 0.40 Distillate composition (XD) = 0.96 Bottom…

Q: Coal fired in a furnace analyzes 16.6% CM,16% ash, 61.4% 6% M, 1.2%N and 1.8%S with a calorific…

A: The coal's combustion gives residue and stack gas. The combustion occurs due to air. The combustion…

Q: lodic acid is added to 29.4 mL of calcium sium hydroxide is required to reach neutra original…

A: Given that  The volume of the hydrochloric acid V1 = 36.7 mL. Molarity of the hydrochloric acid M1 =…

Q: A vapor-liquid equilibrium system of benzene and toluene has a bubble point equal to 100 degC at 750…

A:

Q: A binary mixture of benzene and toluene containing 34.81 mol% benzene is continuously distilled. The…

A: Given Feed rate,F= 62.68 mol/h F=34.81 mol% benzene+ Toluene Distillate =5.72mol% Toluene Bottom…

Q: A distillation column is being used to separate a mixture of benzene, toluene, and cumene. The feed…

A: The composition of feed is The mole fraction of benzene, z1 = 0.4 The mole fraction of toluene, z2 =…

Q: A mixture of dichloromethane (1) and ethyl acetate (2) and is separated in a flash drum at 1 bar. a)…

A:

Q: Benzene (i), toluene (ii), acetonitrile(iii), and methane(iv) are among the chemical wastes…

A: Given: 4 chemical waste given. (Benzene, toluene, acetonitrile, methane) Give the permitted exposure…

Q: A solution containing 50 weight % methanol and remaining water at 300 K is admitted to a…

A:

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Given data: Composition of ternary mixture is, B = 20 % C = 80 %

Q: 5. A ChE student aiming to lose weight for health reasons decided to purchase 15 tablets of a…

A: Given that: Number of dietary supplement tablets = 15 The tablet is expressed as grams of ferrous…

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Ternary phase diagrams represent the equilibrium of the mixture containing three components. The…

Q: A feed stream containing 15% wt solids and 85% wt water is introduced in a certain process where the…

A: Here it is given that feed having 15 %wt solid and 85  % wt water residue has 13 water by mass

Q: 20 mL of a monoprotic acid solution with a pH of 2.7 is neutralized by the same volume of KOH…

A: Given, Volume of monoprotic acid solution = 20 ml pH of monoprotic acid= 2.7 Ka=4×10-5

Q: A fuel gas produced by gasifying coal is to be burned with 20% excess air. The gas contains 50.0…

A: Coal gasification is a process of producing syngas a mixture containing carbon monoxide, carbon…

Q: Lithium reacts with nitrogen gas to product lithium nitride. 6Li) + N2®) →2LigN) What mass of…

A:

Q: 1.How many oxygen atoms, how many moles of oxygen are found in a sample that contains 4x10'4 H;PO,…

A: Given:  4*1014 molecules of H₃PO4             Molecular weight of H₃PO4 = MH3PO4 = 98 g/mol…

Q: 200 moles of ethane C2H6 are burned in a furnace with air that contains 945 moles of O2. The flue…

A: According to question, here is simple diagram is Find Excess component amount Orsat analysis Heat…

Q: The natural gas has the following composition in mole percent.CH-82.5%, C,H613.5; N2-4%. Calculate…

A: Question: Answer: given that; The natural gas the compositions like methane yCH4 is 82.5…

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Any point within the curve represents mixture of two phases (Raffinate and extract phases) Any point…

Q: Q4/ A liquid mixture is prepared by combining N different liquids with densities pi: pz...; PN. The…

A:

Q: A geochemist measures the concentration of salt dissolved in Lake Parsons and finds a concentration…

A: Given: Initial concentration(C1) =6.82g/L final concentration(C2) =21.6g/L Let initial volume(V1 )…

Q: Using the ternary phase diagram below, determine if the following mixture falls on the single-phase…

A: Given data: Composition of ternary mixture is, A = 30 % B = 34 % C = 36 %

Hazard Analysis and Design in Chemical Engineering

Hazard is the intrinsic property of a material or process which harms the people, buildings, or environment. Health, safety, hazard, risk assessment, loss prevention, and environmental consideration play an important role while designing a chemical processing plant. Hazard is often confused with risk. Risk measures the magnitude of loss and injury of likelihood incidents or the consequence and frequency of incidents.