A 5 liter flask containing nitrogen at 5 atm was connected to a 4 liter flask containing helium at 4 atm and the gases were allowed to mix isothermally. Calculate the total pressure for the resulting mixture. Select the correct response: O 4.56 atm O 3.78 atm O 6.93 atm O 5.46 atm

Q: 2310 g/min of Yogurt will be transported from a tank that is 60 cm below the surface of the earth to…

A: Given: The mass flow rate of yogurt stream is m* = 2310 g/min or, m* = 2310×10-360kgsm* =0.0385 kg/s…

Q: The design fluid (typically water and antifreeze) flow rate through a solar hotwater heater system…

A: The flow rate of the fluid = 0.025 gpmft2or gallonsmin.ft2 Dimension of each solar panel = 4ft×8ft…

Q: To determine the calorimeter constant of a coffee-cup calorimeter, 28 g of cold water was placed in…

A:

Q: Extracted cane juice from a sugar mill flows through a 75 mm ID pipeline. Extracted cane juice is at…

A: The ratio of the throat of venturi diameter and pipe diameter is obtained. The area of the venturi…

Q: 4-The average speed of an ideal gas molecule at 27°C is 0.3 m/s. The average speed at 927°C will be…

A: The average speed of the ideal gas at the given temperature is to be calculated.

Q: Calculate the log mean temperature difference using cooling water utility for the following: Thi =…

A:

Q: A liquid N2 (LN2) dewar typically has a pressure regulator that helps prevent it from rupturing when…

A: It is given that liquid N2 is stored in spherical dewar. Given data are as follows: Radius of dewar…

Q: Ratio of compression

A:

Q: Equilibrium vapor and liquid streams leaving a flash drum supplied by a partial condenser are as…

A: First calculate the kinetic energy ratio for the given drum specifications as:

Q: A 5 ft' tank is initially evacuated (total vacuum). A leak develops and air enters the tank at a…

A: Initially, there is vacuum in the tank and then air start to enter into the tank, pressure at the…

Q: What is the gas formation volume factor if z is 0.646, pressure is 4778.4 psia and temperature is…

A: To relate the volume of gas at certain temperature and pressure conditions to the standard volume…

Q: 2. Consider a large tank holding 1000 L of pure water into which a brine solution of salt begins to…

A:

Q: 3. Why are two different differential pressure gauges used to measure the pressure drop of the…

A: 3) Differential pressure gauges are widely used and have vast applications, particularly in the…

Q: A simple atmospheric distillation tower as shown in the Figure below have a capacity of 1200…

A: It is given that, the distillation tower has a capacity of  Flow rate of steam vapor  at…

Q: 250 oC geothermal fluid flowing at 40 kg/s from an offshore well. The average ocean temperature in…

A: Steam is used in geothermal power plants to create energy. The hot water reservoirs that produce the…

Q: Q:/ Derive the system of two simultaneous ordinary differential equations governing the pumping…

A: It is given that each tank A and tank B initially contains 100 liters of pure water. To derive the…

Q: Suppose somebody in the laboratory doesn’t quite turn off the current in an electrolysis cell so…

A: Introduction to the nature of problemThe amount of charge( electrons) flowing through a point in…

Q: A plastic bag, made of a fictional material that resists all temperature changes, is filled with…

A: as we know,  pressure = ρghpressure ∝ g so, in out airlock system plastic bag will be in zero…

Q: Use Prandtl and Nusselt numbers and the Dittus-Boelter Equation

A: The objective of the question is to estimate the value of the heat transfer coefficient (h) on the…

Q: In a chemical production facility, a mixture containing 80% acetone and 20% water by mol will be…

A: Detailed explanation:Hope you will get your solution!Do rate me if it helps you!

Q: 56 grams of nitrogen is placed in a three liter tank at -150.8 degrees Celsius. Estimate the tank…

A: Given data: The weight of the nitrogen = 56 g The volume of the tank = 3 L Temperature = ­- 150.8 0C

Q: A steam of gas at 70oF, 14.3 psia and 50% saturated water vapor is passes through a drying tower…

A: Temperature of the gas steam, T=70 °F Pressure, P=14.3 psia=(14.3×6.89476) kPa=98.59 kPa (%)…

Q: A mercury thermometer, which has been on a table for some time, is registering the room temperature,…

A: Given that Ti=50 FTf =176 F at t=10 second

Q: Problem 1 An aqueous solution of methanol containing 20% by weight methanol is fed to a distillation…

A:

Q: A steam of gas at 700 F, 14.3 psia and 50% saturated water vapor is passes through a drying tower…

A:

Q: An open test tube at 293 K is filled at the bottom with 12.1 cm of Hg, and 5.6 cm of water is placed…

A: Given that, The height of the mercury hm = 12.1 cm The height of water hw = 5.6 cm Atmospheric…

Q: Problem 1: Reynold's number a rotating brush uses a device similar to the device shown in HD Figure…

A:

Q: Determine the units of the rate constants of (a) Zero-Order and (b) Second-Order chemical reactions.…

A: Given data of item 2, Unit of concentration of A = M (mol/L) Unit of time = sec

Q: A sample of gas occupies 75.0 ml at 725 mmHg and 18 °C. Calculate its volume at 800 mmHg and 25 °C.…

A: Given data: Initial volume of gas = 75 mL Initial pressure = 750 mmHg Initial temperature = 18 0C…

Q: A steam of gas at 70oF, 14.3 psia and 50% saturated water vapor is passes through a drying tower…

A: Given: T = 70oF in Kelvin = 294K Pressure = 14.3psi in kPa = 14.3*6.89 = 98.57kPa Volume = 1000ft3 =…

Q: Air flows at a rate of 0.4 kg/s through an air compressor entering at 6 m/s, 1 bar and 0.85 m^3/kg…

A: The flow rate of the fluid is measured in either the volumetric flow rate or the mass flow rate. The…

Q: Calculate the flow of the liquid and vapor phases.

A: Two phases coexist in a mixture when the flash temperature lies between the bubble point of mixture…

Q: 4) For workers in closed spaces, it is a great danger to consuming the breathable air (oxygen) and…

A: The height of the rectangular tank, h = 10 ft The area of the square base, A = 5 ft×5 ft = 25 ft2…

Q: O He 1.0 L 0.50 atm O Ne 1.0 L 0.40 atm All gases at T = 0°C Ar 2.0 L 0.20 atm Which gas has highest…

A: Given data is for three gases at T=00 C=273.15 K (constant temperature)- Helium (He) at, P=0.50 atm,…

Q: A dry natural gas reservoir has the following given data: Component Componenemole fraction Methane…

A: In fluid mechanics, Pipe flow is a type of liquid flow within a closed conduit. The other type of…

Q: Q 2. Air at 400°C and 1.7 bar flows through a horizontal 8.2-cm ID pipe at a velocity of 50.0 m/s.…

A: Given: Air temperature and pressure initially T1 = 400oC = 673 K and; P1 = 1.7 bar = 1.7×105 Pa…

Q: The stopcock connecting a 1.91L bulb containing carbon dioxide gas at a pressure of 9.07 atm, and a…

A:

Q: A nearly flat tire becomes noticeable warmer after it has been pumped up. Approximate this process…

A:

Q: When we drive at higher speeds for an extended period, the tire warms, and the air within expands…

A: Given In the tire(initial and final position) Pi=107psig of air Pf=117 psig Vi=Vf=V=0.017 ft3…

Q: A marine biologist is preparing a deep-sea submersible for a dive. The sub stores breathing air…

A: