Q4 Steam at 500 C and 40 bar passes through two turbines arranged in parallel, and their exit streams are combined into one stream. Turbine 1 has 100% efficiency, while the efficiency of turbine 2 is 75%. Both turbines exhaust at 1 bar. The stream that is formed by combining the exhausts of the two turbines is saturated vapor. Determine the fraction of the total flow rate that passes through each turbine. thermodynamic. Chapter 8

Q: A refrigeration system with a capacity of 10 tons of refrigeration operates at 210 kPa in the…

A: Given data: Capacity of refrigeration = 10 ton Temperature in evaporator = 210 kPa Temperature in…

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: Q1) A steam with a quality of 69%, enters an adiabatic nozzle at 3.5 MPa and leaves at 0.4 MPa and…

A:

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: • 200 kg/min superheated steam at 40 bar and 350C enters a turbine through a 7.5cm ID pipe. It exits…

A: Superheated heated is expanded through a turbine.

Q: Question 2: Saturated liquid water at 20kPa enters an adiabatic pump and discharges at 5 MPa with…

A:

Q: Problem 1.29 (modified), Masters and Ela, Introduction to Environmental Engineering and Science, 3rd…

A: Note: Since you have posted multiple questions with multiple sub parts, we will provide the solution…

Q: 1. Sketch the regenerative cycle indicating the known quantities and states of the streams. 2.…

A: Given that Condenser pressure,P1 =20 KPa Steam is extracted from turbine at P2 =1500 kPa Boiler…

Q: 1. At the Shell oil refinery, the lubricating oil, at a velocity of 6 feet per second, is passed…

A: The film temperature of the oil is, Tf = Ti+To2Tf = 105+902Tf = 97.5oF At this film temperature, the…

Q: . Two steady flows of air enter a control volume, as shown in Fig. One is a 0.035 kg/s flow at…

A: Consider a control volume steady state device with two inlets and one exit flow. Neglecting kinetic…

Q: 2 A co-current (same direction) heat exchanger has one line with 5 kg/s of n-butane at 120°C and 5…

A: Mass flow rate of cooling water and the heat exchanger efficiency is asked to calculate. Given:Mass…

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The…

A:

Q: Kerosene is pumped into a tank at rate between 0 and 1000 Litres per minute. The inlet temperature…

A: Given that- Kerosene is pumped into tank at rate between 0 to 1000 L. Hence, inlet flow rate= Fi…

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. The steam enters…

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you…

Q: Argon enters an adiabatic turbine at 800 kPa and 600C and exits at 100 kPa and 50 C. The rate of…

A:

Q: Refrigerant 134a flows through a horizontal tube with an inside diameter of 5 cm. The refrigerant…

A: Given: The inside diameter of the horizontal tube=5 cm quality at which the refrigerant enters=0.1…

Q: 2.

A: Using the steam table, State 1 at P1= 0.8 MPa T1= Tsaturated= 31.31oC H1 =Hf= 95.47 KJ/Kg and State…

Q: A steam power plant operating in a Rankine cycle has saturated vapor at 4.0 MPa leaving the boiler.…

A: The initial pressure is obtained from the steam table. The enthalpy and entropy of the initial…

Q: In a Rankine cycle, steam enters the turbine at 8400 kPa and 350°C. The total condenser (i.e. exit…

A:

Q: Air enters an electric furnace at 100 kPa and 28°C with a volume flow rate of 22 m/min. At the exit…

A: Given that :At entering P1  =100KPaT1   =28 C  =28+273.15 = 301.15 KQ = 22 m3minAt exit P2  = 100…

Q: Steam flows at steady state through a converging, insulated nozzle, 25 cm long and with an inlet…

A: Given thatl =25 cm =0.25 m d = 5 cm =0.05 mP1 = 700 KPaT1  = 325 CV1 = 30 m/sP2 = 350 KPaT1  =240 C

Q: 3) Steam is produced in a boiler using liquid water as the feed. The boiler operates at 100 kPa. The…

A: Given: Inlet Water Temperature  = T1  = 40 oC  = (40+273) K  = 313 K  Outlet Steam Temperature  = T2…

Q: .0- A (165 MW) Electric power is generated in a Reheat-Regenerative steam power plant. The outlet…

A: Given  Electric Power Q=165 MW Outside steam rate  sT=3.95 kg/(kW⋅hr) at 40bar and 350°C Feed water…

Q: Water is the working fluid in a Rankine cycle. Steam enters the turbine at 10 MPa and 550°C. The…

A: Note: We are supposed to answer only three subparts of a problem as per our guidelines. Kindly send…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: Q5/ A stream of hot water at 150 °F flowing at a rate of 409 Ib/min is to be produced by mixing…

A: The mass going into the system is equal to the mass going out of the system and the mass stored in…

Q: Steam enters a turbine at steady state with a mass flow rate of 1.28 kg/s. The turbine develops a…

A: Step 1:from steam table find h1 and h2  Step 2: open system by first law of thermodynamics has an…

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: The temperatures of the 12 °C water at inlet 13 °C 15 °C 30 °C The temperatures of the 20 °C water…

A:

Q: Compare the COPs for an R-404a vapor-compression cycle, assuming Tcond = 45°C, Tevap = -5°C, Q =…

A:

Q: At the commencement of compression in the reciprocating compressor of a refrigeration plant the…

A: Given:The compressor follows  at To find the work done, Internal energy and heat transfer through…

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: How much work (in kJ/hour) is generated by the first turbine, which is 80% efficient? b. How much…

A:

Q: 1. A pressurized water reactor of a nuclear power plant supplies pressurized hot water at 330C and…

A:

Q: Power for Pumping in a Flow System. Water is being pumped from an open water reservoir at the rate…

A: Water is pumped from an water reservoir to a storage tank place 20 m above the reservoir. Both…

Q: remaining steam expands through the third-stage turbine to the condenser pressure of 3.5 lbf/in hps…

A:

Q: ideal Rankine cycle.

A:

Q: If a 4" pipe was used throughout the system, what is the fluid velocity at T1 and at T4?

A: the given molar flow rate si converted into mass flow rate. The mass flow rate is obtained in…

Q: 4.21. The rigid vessel shown in Fig. 4.16 has a volume of 1 ft³ and contains an ideal gas. The…

A: Given data are a follows: Initial volume of vessel = 1 ft3. Initial pressure of vessel = 100 psia…