Q3A/ Classic Errors are classified into three types, mention and explain them.Q3B/ Define the following1. Electronic Distance Measurement (EDM)46912. Height of instrument (HI)3. Change point (C.P.)4. Rise and fall method (R and F method)

Answered: Image /qna-images/answer/d5107bf9-a231-4165-bb0b-38034a83c49f.jpg

Q3A/ Classic Errors are classified into three types, mention and explain them. Q3B/ Define the following 4:691 1. Electronic Distance Measurement (EDM) 2. Height of instrument (HI) 3. Change point (C.P.)

Q3A/ Classic Errors are classified into three types, mention and explain them. Q3B/ Define the following 4:691 1. Electronic Distance Measurement (EDM) 2. Height of instrument (HI) 3. Change point (C.P.)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Rain gauge X was out of operation for a month during which there was a storm. The rainfall amounts…

Q: 3. Situation: You are driving when suddenly you saw a cat crossing across the street You applied the…

A: Given, Deacceleration of car, a = 8fps2 Distance covered, s= 456 ft final velocity of car, v=0

Q: .1:(a)- A road actually 1380 m long was found when measured by a defective 30 m chain to be 1376 m…

A: Given Original length(L)=1380m True length of chain=30m Measured length of road by defective…

Q: At the pedestrian crossings there are fluctuations in the noise level and stability at * the…

Q: Bias (a) (b) (c) FIGURE 1.20 Exactness of measurements: (a) precise but not accurate, (b) accurate…

A: Accuracy is the condition which shows that calculated or observed value is close to true value or…

Q: Q1/ Find speed percentages (by drawing) depending on the data shown in the table below. (Hint:…

A: speed Km/hr frequency cumulative frequency % cumulative frequency 19 2 2…

Q: If the signal phase designation shown below follows the NEMA convention, the value of “a" " and “e"…

A: Brief concept introduction- Signal phase- It is defined as the right-of-way, yellow change, and red…

Q: A PERT network is shown below in the diagram with to - t - tp durations. The ratio of probable range…

A: Given data,

Q: table and network find the activity with maximum cost slope Activity Normal Crash Normal Crash Cost…

Q: What is PIEV analysis in Highway engineering?

Q: The average bay turnover is approximately ……………….. .

Q: 32. An industrial park consists of 16 buildings. The corporations in the park are sharing the cost…

A: Given: An industrial park consists of 16 buildings. The corporations in the park are sharing the…

Q: 3. A moving vehicle come up to a danger and traveled a distance of 48 meters during the perception…

A: Stopping Sight Distance (SSD) is given by : SSD=0.278 V Tr + V2254(f±s%) Given SSD = 48m Tr = 2.67…

Q: 3. Evaluate the equation and express the answer in an appropriate SI unit. 183397 Pa (1260…

A: 183397 Pa(1260 Kgm3)(9.81 ms2)

Q: Situation 5: For the first three items, consider the following: A 20 km stretch of a highway had the…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: Compute for the following: 1.area of A2,A3 and A4 2.Total volume using average end area method

A: Take use of end average method.

Q: 3. Compute the Time Mean Speed and Space Mean Speed Vehicle Time (s) Speed (km/hr) A 15 100 25 150…

Q: 50 一Rined lim (x'tzX+リ 100 cosx dx J4+ sinx Pinel Domain fr ye 14-x? + Pind e for y= cot t-zt,…

Q: Individual assignment 50 oads having a deviation angle of 45°8' are to be joined by a 180 m radius…

A: As per the policy, the first question will be solved from the given multiple questions. Since ID…

Q: A photograph is to be obtained at a scale of 1:12,500 by aerial photogrammetry. If the focal length…

Q: For the given speed information in the table below, find the standard deviation ?and the 85th…

A: For the traffic speed data given it is required t find the standard deviation of speed and then the…

Q: Visual interpretation of a satellite image Select one: a. is through manual intervention b. is…

A: Satellite images are the images taken by satellites. The satellite images are mostly used to…

Q: a. Analyse the hazard curve in find out the probability of exceedance of a PGA 0.1g in 30years.…

A: Time period(n)=30 yrs PGA, p=0.1g

Q: QUESTION 6 How is the critical headway determined from field observation data? O The smallest…

A: Critical headway is the minimal interval of time in the circulating flow that allows an approaching…

Q: A witness with 20/60 vision supplied to the investigating officer the license plate number of a…

Q: * Reconnaissance is an optional stage for a new road construction. True False

A: Explanation: One of the most important stages of a road construction survey is called a…

Q: What

Q: During formative evaluation, the human factors team collected some reaction time data in…

A: As per American Association of state highways and transportation official in their study of reaction…

Q: What does the approach velocity signify in the Rose equation and the Carmen Kozney equation used to…

A: Rose equation uses approach velocity as an input parameter to estimate the headloss due to inertial…

Q: Explain that how the ultrasonic sensor HC-SR04 can be used to measure distances. Also, draw the…

A: An ultrasonic sensor is a device that uses ultrasonic sound waves to calculate a distance to an…

Q: QUESTION 3 Fill in the following blanks for different signal components: • The collection of…

A: Here we are provided with four fill in the blanks question.The topic is related to different signal…

Q: Gap (sec) Аcсepted or Rejected? Event Time (sec) major street vehicle on the near side of the street…

A: Solution is based on experimental data provided by the analysts. It may vary with standard results.

Q: What is the intersection sight distance (m) needed at a stop controlled intersection for a passenger…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q7. A 25 miles of gravel road require reshaping and leveling. You estimate that a motor grader will…

A: Graders are multipurpose machine used for finishing of surfaces. It is operated for:- Smoothing the…

Q: The following count was observed on a way, compute the following rate: Time 2:00-2:05 2:05-2:10…

Q: What is the calculated stopping sight distance (ft) when the design speed is 60 mph, assuming the…

A: Given:- The design speed is 60 mph To determine:- A) The stopping sight distance B) The height of…

Q: QNO5: Draw AON network for the given data. Compare all the available paths. Calculate expected…

A: Given Activity IPA Optimistic Realistic Pessimistic A - 2 8 19 B A 5 6 12 C A 10 12 19 D…

Q: Explain how will you prove experimentally that Cc = (Cd/Cv)

Q: what is the minimum rating of SC disconnecting means for a residential single-family…

A: According to NEC 230.79(C), the minimum-size service required for a one family dwelling is 100…

Concept explainers

Highway Safety

Proper highway safety refers to the methods or rules that prevent highway travelers from being killed or severely injured. Proper highway safety measures help to protect motorists, cyclists, pedestrians, passengers on public transport, and so on.

Question

100%

Q3A/ Classic Errors are classified into three types, mention and explain them.
Q3B/ Define the following
1. Electronic Distance Measurement (EDM)
4691
2. Height of instrument (HI)
3. Change point (C.P.)
4. Rise and fall method (R and F method)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

count peiod. n, 5, A 24-hour count using a road tube at a rural highway location produces a count of I1,250 actuations. A repre- sentative sample count to classify vehicles resulted in the data shown here: 2. en Data for Problem 2 Number of Axles Per Vehicle Number Observed 157 55 50 33 8. ---n 1EK 8 TRAFFIC DATA C Based on this sample classification count, how many vehicles were observed during the 24-hour study? 2344 6
Ontario Building Code 2012 (Div. B-Part 9): Determine the dimensions of a 'landing' required of a ramp that turns 45° in a shopping mall, assuming the occupant load of upper level as 200. O a. 1100mm wide and 900mm long Ob.1600mm wide and 1600mm long Oc 900mm wide and 900mm long Od. 1600mm wide and 900mm long
List the possible errors that can occur when measuring a distance with an EDM.
A driver traveling at 70 mph sees a hazard at a certain distance ahead. The driver theapplies the brakes immediately time is 4 seconds and begins slowing the vehicle at 15the distance from the stopping point to avoid hitting the boulder is 12. 30 meters. Calculatethe distance from the boulder upon perception. ID NUMBER 143
25 - A distance with an actual (most probable) value of 882 has been measured 8 times. Which of the following measurements is an acceptable measurement value for 10% tolerance?A) 793B) 792C) 972D) 794E) 971
Please give the right answer
Transportation Engineering PCU Factors are attached in a separate Image
Q1: If directed to a point away from the desired target 5 cm vertical distance on the line of sight, what amount of error in the direction if the target is far the device 200, 20m ?
An accidental or compensating error can be eliminated by proper procedures. True False
and report the A driver with 20/20 vision can read a given sign at a distance of 100 ft from the sign. At what distance would another driver read the same sign with 20/30 vision ● 20/40 vision 20/X vision (Give your answer with respect to X)
What are some examples of peripheral equipment that has an impact on instrument accuracy?
kindly answer immediatelyy, thankyousomuch -Problem ABCDE6. A student counted 50, 52, 53, 51, 53, and 51 paces in walking along a 45-m course laid out on a concrete pavement. The student took 768, 771, 770, 769, and 770 paces in walking an unknown distance AB. What is the the average pace? choices: a. 51.67, b. 51.69, c. 51.71, d. none of the above -If the azimuth is 7°, the compass quadrant bearing is choices: a. N 7° E, b. N 7°W, c. S 7° W, d. S 7° E