table and network find the activity with maximum cost slope Activity Normal Crash Normal Crash Cost Cost slope duration Duration Cost 120 100 12000 14000 B 20 15 1800 2800 C 40 30 16000 22000 30 20 1400 2000 50 40 3600 4800 60 45 13500 18000 A 120 B F.

table and network find the activity with maximum cost slope Activity Normal Crash Normal Crash Cost Cost slope duration Duration Cost 120 100 12000 14000 B 20 15 1800 2800 C 40 30 16000 22000 30 20 1400 2000 50 40 3600 4800 60 45 13500 18000 A 120 B F.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: value of ES, EC, LS, LC, TF, and FF Define the critical pat

Q: The time estimates in days for optimistic, most likely and pessimistic times of various activities…

A: The methods of PERT and CPM help significantly in following through with the different tasks on…

Q: What

A: From the given table, the value of the first distribution at CB is -22.27

Q: Q. 3: needs A Traffic engineer urgently to determine The AADT on an urbon minor arterial highway. he…

A: Given data: Hourly volume observed during the 1st hour of Wednesday V1=560 v/hr Hourly volume…

Q: ∆VB answer is not correct. could u pls check again?

A: Given: Require: Additional load on wheel B correctly Note:The calculation done by previous expert…

Q: Based on the given, make a Network Diagram for the activities and compute for the Critical Path and…

A: Given: The following table is, Activity Preceded Time A - 5 B - 14 C A…

Q: Q3: Determine the time completion of project for the activities shown below: A-0-N Activity.…

Q: QUESTION 8 When describing operating conditions, a level of service C is better than a level of…

A: Solution:- Given:- It is asked when operating conditions a level of service C is better than a level…

Q: 1.5 1.7 2.3 3.0 2.5 1.4 2.0 1.0 1.1 2.6 1.8 2.0 3.2 1.4 0.9

A: ASKED: To determine the number of trucks (of given capacity) required to fill the given grid. Given,…

Q: If the signal phase designation shown below follows the NEMA convention, the value of “a" " and “e"…

A: Brief concept introduction- Signal phase- It is defined as the right-of-way, yellow change, and red…

Q: Explain the importance of vehicle trajectory data complementary to the vehicle count data.

A: Answer We know that vehicle trajectory data represents the time and space locations of vehicle as it…

Q: tivity Time Immediate predecessor 12 7 A 11 A 8 A 6 A 10 B 9 14 D,F 13 E,G 16 H,I ect one: a. 53 b.…

A: To find expected time to complete the project

Q: Question 19 The driving force for keeping a project on schedule is. Oproject manager O time Opeople…

A: Schedule- It is the time line that determines the order of completion of activities such that the…

Q: From the following data, develop an optimum time cost plan assuming that the indirect cost is…

Q: The chart of the numbers listed in the table below. Find the critical path and the duration of the…

A: to find ES , EC , LS , LC , TF ,FF

Q: Q)Briefly discuss TWO (2) aspects of sight distance that must be considered when the driver passing…

A: Given question is from traffic Engineering and belongs to Geometric design of roads.

Q: Integrate the following 2dx V100 – 4x²´

A: Using inverse formula

Q: Problem 1. A driver is traveling a 55 mph on a 2.5% down hill. a. What is the PRT distance (i.e.,…

Q: 32. An industrial park consists of 16 buildings. The corporations in the park are sharing the cost…

A: Given: An industrial park consists of 16 buildings. The corporations in the park are sharing the…

Q: Why is the appropriate calculation method for tank rupture Type 3 (Mission time) as opposed to Type…

A: Assuming the above mentioned tank to be a battle tank and the calculations to be load analysis and…

Q: ation. Indicate the Early Start a am. (Hand written) Immediate Expected Predecessors Duration…

Q: 3. One disadvantages of the Gantt chart is not showing : a) O The effect of activity duration The…

A: The different techniques used for scheduling the construction projects are Bar chart or Gantt…

Q: Current Year Future Yeare T[I] = 300e %3D T[II] =1000 %3D T[III] =800 %3D T[IV] = 300 %3D Distribute…

A: Given:

Q: Complete the table, solve for Completion date, Identify the Critical Path, Show Solutions and…

Q: Engineering Management ,i need solutions in 10 minutes please. MCQ/The delay time in starting or…

A: To determine: The delay time in starting or finishing an activity without affecting on the total…

Q: 5. The table shown below was taken from Jack's notes when he tried to determine the perimeter of his…

A: Trial Line No. of paces Paced factor Paced distance Perimeter 1 AB 125.25 0.81 2 BC 85…

Q: Determine the following: 90kN 30kw Jo baim o VA Mmay MB Vmap zm Tsow Ve Vo Mc MD

Q: Draw Gantt-Chart for the following activities, define the located activities on the critical path,…

Q: Situation 5: For the first three items, consider the following: A 20 km stretch of a highway had the…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: 4. Consider the network shown in the following figure. For each activity, the three time estimates…

A: Answer Expected Time(tE) of the activity is the mean of the β- distribution and is given by tE =…

Q: Using Enumeration Method - list all paths and total duration. Activity Predecessor Normal time…

Q: What is the probability that the simple project will be completed in 29 days? and How long will it…

Q: The difference between the early start date and the late start date for activities on the critical…

A: Brief concept- Early start date- It is the date on which any activity can be started as soon as…

Q: 8-10-14 6-8-11 3-7-10 7-12-18 H The expected completion time (in days) of the project is_

A: To find expected time of project

Q: Using the CPM , draw the CPM diagram and find the critical path analysis. Activity…

A: Given values: Consider the data given for activities and draw the CPM diagram. Then find Early…

Q: Part 2 - Solving: Observers stationed at two sections A-A and B-B, 200 m apart on a highway, record…

A: The given table showen below, Vechile Section A-A Section B-B A To To+7.6 sec B To +4.25 To +…

Q: The following cross-section notes of the road was examined to calculate volumes. The width of the…

Q: Road accident 'black spots' are locations that attract more accidents by comparison with other…

Q: Determine the number of lanes (both for upgrade direction and downgrade direction) required for a…

A: Transportation designing is a sub-discipline of structural designing which manages the utilization…

Q: Which of the following statements is INCORRECT. O Frequency analysis is defined as the investigation…

A: Frequency analysis is a methodology for prediction or finding probability of any events occurrence…

Q: Situation: A project has a critical path of 1-2-3-4-5. In the parentheses are the probabilistic…

A: To Find :- expected project duration and standard deviation of expected time.

Q: A Study area with four transportation analysis zones has the following information: Table 3: Trip…

Q: Q: For the figure and table above, find the time duration for the project and .the critical path

A: the path diagram is activity focused. in the critical path method we used deterministic approach…

Q: QUESTION 6 How is the critical headway determined from field observation data? O The smallest…

A: Critical headway is the minimal interval of time in the circulating flow that allows an approaching…

Question

Having the following table and network find
the activity with maximum cost slope
Activity Normal Crash
Normal Crash Cost
Cost slope
duration Duration Cost
120
100
12000 14000
B
20
15
1800
2800
40
30
16000 22000
30
20
1400
2000
50
40
3600
4800
F
60
45
13500 18000
A
120
B.
C
20
40
30
F.
60
E.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
A turning movement count and a saturation flow study were conducted at a major intersection on an expressway with configuration as presented in Fig.1. The peak-hour volumes and saturation flows obtained from the studies for each movement are presented in Tables 1 and 2, respectively. Using the Webster method, determine a suitable preset signal timing for the intersection using a phasing plan that will yield the minimum cycle length out of all possible phasing plans. Also provide a diagrammatic representation of the signal sequence at the intersection. Assume a yellow interval of 3s, all-red interval of 2s and a peak hour factor of 0.95 for all the approaches. Note: No two movements should conflict during the determination of the phasing plan. Tur F Fig.1: Traffic Movements at a Major Intersection N
Q1: Determine the duration of project for the activities shown below, and find the critical path by using (Arrow network) Activity A D E F H. K M R Duration 4 3. 7. 8. 11 3 8. 4 8. 9. (Weeks) Followed C,D D,F ,E J J,H К М I,K M R by 4) B
Problems 2. Solve for the best choice in terms of utility U=A-0.05X1 -0.02X2 3. For 300 trips, assign them using constant assignment ratio. Route 1 2 3 4 5 M Mode A Car -0.6 Jeep -0.3 Grab -0.4 Bus -0.5 Hours 1.1 1.2 1.3 1.4 1.5 X1 50 10 70 30 X2 30 45 20 35
For the overlapping precedence network whose data are given below draw the equivalent single relationship (FTS) network. Label each activity with its proper number, name, and duration. Exercises 395 Activity Duration Depends upon Type of Link Lead Time K L K FTF M K STS P L FTS Q L FTS M STF 2,3 4 P STS 4 P FTF 4 Q STS |~203까212 457 n66 YORRR
i need the answer quickly
(5) :- For the project data in Table below, answer the following questions: a) Draw an AON network of the project and Perform forward path and backward path calculations with critical path identification? b) What are the effect of delaying activities C by 1 days, D by 2 days and F by 1 days? Immediate Activity Duration (week) predecessor A В 7 A C A D 12 В E 15 В, С F 6. D, E
8.Transitional flow occurs 2700
Construction-Management: i need the answer quickly i need all the steps, i need the answer in Handwritten.
5
A Return Period or Recurrance Interval is equivalent to the inverse of the probability of the event ocurring?
Activity 2: Consider the following immediate preceding activity table. Draw the network and calculate the earliest start time, the earliest finish time, the latest start time and the latest finish time of each of the activity. Obtain the critical path. Activity Preceding Activity Estimated occurrence time A 11 A B 3. 7. B D. C,E 2 4. 6 G, I H. L. J.K.L 6365