Q2.Using LRFD procedure, investigate the shear rupture failure mode for the angle L 152*152*7.9, attached with 3 rivets 18mm diameter to 10mm gusset plate as shown in picture. 40 80 80 A 40

Q: *1-96. Determine the required cross-sectional area of member BC and the diameter of the pins at A…

A: Given Data: The allowable normal stress is σallow=3 ksi. The allowable shear stress is τallow=4 ksi.…

Q: 1) Compute the centroid y bar with respect to its base.

A:

Q: Im still confused since we didn't end up with the same final values as the photo. Its showing TA =…

A: Given problem related to "calculation regarding torque".

Q: The moment of inertia about the X-X axis of the shape below is most nearly: 4 cm 2 cm

A: The moment of inertia also called the second moment of area, about the x-x axis is a measure of an…

Q: 4.2 Suppose that P=91lbs. What will the force Q be in this case

A: Therefore, The Force Q when P= 91 lbs will be 1638 lbs.

Q: Why Nc=9 and Nq=1

A: Given question is based on static method of analysis bearing capacity of pile.

Q: How do I find the centrioid for this shape

A: Given TriangleSemi circle and circle To find out Centroid

Q: A circular stepped steel shaft has the dimensions and cross sections as shown in Figure Q1. It i…

A:

Q: Problem 10.6 - Locate the centroid of the section and determine the moment of inertia of the beam…

A:

Q: Calculate

A:

Q: The following cross section has dimensions as indicated. The length of the right-hand vertical…

A: Draw FBD:

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.