The following cross section has dimensions as indicated. The length of the right-hand vertical section is 4.0 cm and the thickness is 4.3 mm. The axes origin is at the top right- hand corner as shown. 3 mm L cm 4 mm 5 ст t mm 5 сm What is the z value of the centroid, relative to the axes origin. Enter your answer in cm, to 2 dp, but without any units.

Q: A compound shaft consisting of a steel segment and an aluminum segment is acted upon by two torques…

A:

Q: The force of F = 55 lb acts along the edge DB of the tetrahedron shown in (Figure 1). Figure 8 ft 10…

A:

Q: Bar ABC has an outer diameter of 10 mm and is made of red brass for which E = 100 GPa. Section AB is…

A: Consider the BC portion of the beam:

Q: Figure 50 mm 150 mm 150 mm 300 mm 1 of 1 Locate the centroid y of the bea Express your answer to…

A:

Q: The piece of plastic is originally rectangular. Calculate the shear strain Yxy at corners A and B if…

A: For small angles.

Q: ID t X< Compute the area moment of intertia about the x and y axes shown in the figure (the origin…

A:

Q: Please solve this problem step by step so I can understand

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: 1.7 Find the primary dimensions of each of the following terms. pV2 dA, where p is fluid density, V…

A:

Q: The material has a specific weight y = 85 lb/ft². (Eigure 1) Figure 0.25 ft 0.5 ft Zift 1 ft 1 of 1…

A: = 85 lb/ft3

Q: What is the nominal tensile strength of the member based on yielding a. 240 kN c. 150 kN b. 250 KN…

A:

Q: An aluminum plate is subjected to uniform stress along its boundaries, as shown in the figure.…

A: stresses on an element is given as followschange in length of diagonal BD=?

Q: Calculate the plastic modulus Sx of the section shown below. All dimensions are in mm. Note: The…

A: Determine the plastic modulus Sx of the section.

Q: The force of F = 50 lb acts along the edge DB of the tetrahedron shown in (Figure 1). Figure ▾ Part…

A:

Q: The area of the cross section of an airplane wing has the following properties about the and y axes…

A: Ix=450 in4Iy=1730 in4Ixy=138 in4To determine- Mohr circle

Q: Locate the centroid y of the cross section. Express your answer to three significant figures and…

A: Find out - 1) Centroid about Y axis .2) Moment of Inertia about the x' axis.

Q: Q1) Three bars each made of different materials are connected together and placed between two walls…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.