Q1. A plate b mm wide and t mm thick is joined with another plate by a single transverse and a double parallel fillet weld as shown in Fig. if the permissible tensile and shear stresses in the weld material are otw MPa and TW MPa respectively and the permissible tensile stress in the plate material is otp MPa, Find the length L2 of a double parallel fillet weld, Consider the joint first under static loading and then under fatigue loading. All dimensions in mm. otp otw TW b L1 t Мра Мра Мра Мра mm mm mm 56 127 52 97 87 13

Q1. A plate b mm wide and t mm thick is joined with another plate by a single transverse and a double parallel fillet weld as shown in Fig. if the permissible tensile and shear stresses in the weld material are otw MPa and TW MPa respectively and the permissible tensile stress in the plate material is otp MPa, Find the length L2 of a double parallel fillet weld, Consider the joint first under static loading and then under fatigue loading. All dimensions in mm. otp otw TW b L1 t Мра Мра Мра Мра mm mm mm 56 127 52 97 87 13

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

design of machine elements solve according to R.S. Khurmi, J.K.
i need the answer quickly
Design of machine elements solve according to Khurmi
A steel plate, 80 mm wide and 10 mm thick, is joined toanother steel plate by means of a single transverse anddouble parallel fillet welds, as shown in figure. The strengthof the welded joint should be equal to the strength of theplates to be joined. The permissible tensile and shearstresses for the weld material and the plates are 100 and 70N/mm2 respectively. Find the length of each parallel filletweld. Assume that the tensile force passes through the centre of gravity of three welds.
Q2. A plate 120 mm wide and 8 mm thick is to be welded to another plate where the applied static load to the plates is 120 kN. The permissible ultimate and yield stresses are 640 MPa and 390 MPa respectively, find the length of weld when (a) a double transverse welds (b) a double parallel fillet welds are used, use factor of safety (2).
Design of machine elements solve according to Khurmi
3. A tie bar is welded to a plate and it is subjected to axial load, P. The length of the fillet weld L= 200 mm, and the size of fillet s= 6 mm. If the stress of the fillet weld is 100 MPa, the maximum load applied is;
A 40mm thick steel bar that is fabricated by welding two parts together is shown below. Being concerned for the strength of the weld, you need to find the state of stress (normal stress and shear stress) in the plane of the weld for an applied load of 400kN. Draw your result on a stress element. 57° 400 kN 400 kN 100 mm
I am in a hurry, I need the answer as soon as possible, please help.
design of machine elements solve according to R.S. Khurmi, J.K.
i need the answer quickly
Q2: A cirrular shaft. (50 mm) in diameter, is weldad to support by means ofcirrumferential fillet weld as shown in figure It is subjected to rorsional moment of (2500 Nimm) Determine the size of the wald, if the permissible shew stress ia the weld is limited to (140 N mm)