A welded cylindrical pressure vessel is shown in the figure. The inner diameter is 600 mm. The wall thickness is 10 mm. Given the gage pressure of 5 MPa, determine (1) the normal stress perpendicular to the weld line and (2) the shear stress parallel to the weld line.

Q: Q4) The plate is supported by a 1.5-in. diameter steel bar and is subjected to two forces as shown.…

A:

Q: The two steel members are joined together using a 30° scarf weld. Forces of F = 13.5 kN are applied…

A: Given DataForce is : oLength is : Width is : Area on which force is acting

Q: A cylindrical pressure tank is fabricated by butt-welding 19 mm-thick plate with spiral seam shown…

A: For solution refer below images.

Q: Determine the maximum shear stress in the shaft (Figure 1). Given the torsional shear stress is 45…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: 150 18 F = 25 KN 25 200 25 25 $ -25 100- 25 50 ↑ Calculate the maximum combined stress in the throat…

A: To Find : The maximum combined stress in the throat Given : The load is The free body diagram is,

Q: 8) The pressure tank shown in the next figure is fabricated from spirally wrapped metal plates that…

A: Step 1: Step 2:

Q: A typical aluminum-alloy scuba diving tank is shown in the figure. The outside diameter of the tank…

A:

Q: The pressure tank shown is fabricated from spirally-wrapped metal plates that are welded at the…

A: Given that, Inside diameter of tank, d1=500 mm,Wall thickness, t=6 mm,Allowable shear stress…

Q: 2 m 10 m

A: As this question is multipart, I will be solving only one question. Diameter of the cylinder is 2…