(10) The figure shows a welded steel bracket loaded by a static force F. Estimate the factor of safety if the allowable shear stress in the weld throat is 120 MPa. (nr./3.57) ✓ 45 -120- 120 F=7.5 KN 67 Dimensions in millimeters 164 O

Q: A rectangular plate (0 =21°) is formed by welding two triangular plates shown in figure. The plate…

A:

Q: A static load of 30 kN is applied at the cantilevered beam as shown in the Figure 3.1 The cantilever…

A:

Q: A fillet welded joint is subjected to transverse loading Fas shown in figure. Both legs of the…

A:

Q: 9-25 The weldment shown in the figure is subjected to an alternating force F. The hot-rolled steel…

A:

Q: The beam shown is 1000 mm long with cross section of 50 mm by 100 mm, and is subjected to a load of…

A: Beamlong=1000mm50X100 mm cross-sectionload=500 kgWeld size =12 mm b=100 mmd=100mmh=12mm due to…

Q: Q4) The plate is supported by a 1.5-in. diameter steel bar and is subjected to two forces as shown.…

A:

Q: The shaft in (Figure 1) is used to transmit 32 hp while turning at 600 rpm. Figure 2 in. 2.5 in. 1…

A:

Q: For the following configurations shown in figure below, determine the ratio of the maximum shear…

A: Solution: Maximum shear stress is given by, Solid tube,…

Q: Required information A steel bar of thickness h, to be used as a beam, is welded to a vertical…

A: The allowable shear stress is the dimensions of the parameter is

Q: Q2. A plate 120 mm wide and 8 mm thick is to be welded to another plate where the applied static…

A:

Q: A welded joint, as shown in Fig. 8.77, is subjected to an eccentric load of 2500 N. Find the size of…

A:

Q: Find the primary, secondary and resultant shear stress of following welding. b=2", d=2", h= 1/4".…

A: To find The primary, secondary and resultant shear stress. Given  The force F is 1000 lbf. The…

Q: Find the position and the value of the maximum stress for the weld joint shown in the figure. Assume…

A: Introduction: The load-bearing capability of a weld relates to how much load it can withstand before…

Q: (5) A 3/4-in-thick steel bar, to be used as a beam, is welded to a vertical support by two fillet…

A:

Q: (1) The figure shows a horizontal steel bar 3/8 in thick loaded in steady tension and welded to a…

A: Given data: b=2ind=2 inh=516int=38 inτallow=20 kpsi Need to determine the allowable force.

Q: For the following configurations shown in figure below, determine the ratio of the maximum shear…

A:

Q: The Figure shows a 0.75-in-thick AISI 1020 HR steel bar subjected to a load of (F = 1.4 kip) and…

A: Given: σy=30kpsi b=d=2in h=5/16in Load (F)=1.4kip Solution: Due to the symmetry of the weld joints,…