Q1: What are the roles of covalent bonds and weak bonds in physiology? Which type of chemical bond is most likely to be perturbed by shifts in the environment? Q2: Given what you have learned about membranes, diffusion and transport, what is the most fundamental physiological principle that sets a "living cell" apart from a phospholipid bilayer droplet with an aqueous center?

Q1: What are the roles of covalent bonds and weak bonds in physiology? Which type of chemical bond is most likely to be perturbed by shifts in the environment? Q2: Given what you have learned about membranes, diffusion and transport, what is the most fundamental physiological principle that sets a "living cell" apart from a phospholipid bilayer droplet with an aqueous center?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Explain how soaps or surfactants decrease the surface tension of a liquid. How does the meniscus of an aqueous solution in a capillary change if a surfactant is added? Illustrate your answer with a diagram.
In an experiment, a 0.001 (mole fraction) solution of polysaccharide in water is made and is placed in the compartment A (see Figure below). Compartment B is filled with pure water. The two compartments are separated by a porous semi-permeable membrane that allows the exchange of water molecules between the two compartments, but not that of the larger polysaccharide molecules Part 2: As a result of this chemical potential difference, water molecules will move from compartment B to compartment A. This causes the pressure in compartment A, relative to that in B, to increase. How would this affect the chemical potential of water in compartment B? When would the diffusion of water from B to A cease (i.e. equilibrium is achieved)?
Explain the molecular reason why the vapor pressure of an aqueous solution of sodium sulfate is lower than the vapor pressure of an aqueous solution of ethylene glycol (HOCH2CH2OH) of the same concentration.
A dry-cleaning plant used carbon tetrachloride (CCl4) as a cleaning solvent until it was shut down because CCl4 was found to cause cancer and had been leaking into the groundwater. The plant owner offered to switch to liquified carbon dioxide instead and was allowed to reopen. Within 6 months cancer cases returned to normal. Explain whether the use of liquified carbon dioxide is a long term, safer environmental alternative to CCl4.
Why can't water alone clean soiled clothes effectively? How does the detergent help in the cleaning or washing of clothes? How do surfactants affect the surface tension of tap water? What will be the effect of increasing its amount on a fixed volume of water?
A"U" shaped cylindirical tube was separated into two equal parts with a semi-permeablemembrane. One part of the tube was filled with pure water and the other part was filled up to the same level witti 6.52x10 M MBCI, solution (d= 1.08 g mL"). Assuming that the density of MgCl, solution did not change during the osmosis, calculate the difference between the liquid levels in cm, after equilibrium had been obtained at 21 °C. R = 0.08206 L atm mol-1 K-1= 8.314 J mol-1 K-1 g = 9.81 m s-2 1 J = 1 kg m? s-2 34.6 cm 55.8 cm 45.1 cm
What is the solubility of Cd₃(PO₄)₂ in water? (Ksp of Cd₃(PO₄)₂ is 2.5 × 10⁻³³)
2. Using the data in Appendix A of Benjamin's Water Chemistry, answer the following questions a. What is the Henry's law constant (KH) at 25 °C for the exchange of hydrogen sulfide between the gas and aqueous phases? H₂S (g) H₂S (aq) b. What is the Henry's law constant for the reaction in part a) at a temperature of 5 °C?
What is the molarity of a solution of a polypeptide which has an osmotic pressure of 0.221 atm at 37.0 °C?
Determine the Ksp of J3(PO4)2 if its molar solubility in H2O is 7.78 x 10–10 M. 5.04 x 10–39 5.91 x 10–3 3.08 x 10–44 3.63 x 10–18 1.14 x 10–5
The colloidal solution was prepared by reaction: CaCl2 + K2CO3 = CaCO3 + 2KCl CaCl2 was taken a big excess, and lack of K2CO3. Write the structure of micella. Name its parts. What is the charge of colloid particles?
What is the osmotic pressure of a solution prepared by adding 13.65 g of sucrose (C₁₂H₂O₁) 12 22 11 (m.w. 342) to enough water to make 250 mL of solution at 25 °C?