Q1: For the Dual cycle (Limited pressure cycle) shown in figure above show that :-17th = 1ap-1(r-)7-1ay (p-1)+ (a -1).(p)= Cut-off ratio.(a) = Pressure ratio.Where:(77) Thermal efficiencyof the cycle.(y) Adiabatic index.=()Compression ratio.

Answered: Image /qna-images/answer/e31721df-bdc8-4f22-8b60-cf9a63ee4ad4.jpg

Answered: Q1: For the Dual cycle (Limited…

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. Operate at lower condenser of a Rankine Engine. P1=50 bar (saturated) P2=½bar=0.5 bar. Calculate the efficiency of cycle and engine using Mollier chart. Can you show step by steps solution using the formula given?
The Fifth Question: A six-cylinder, 4-stroke petrol engine develops 62 H.P at 3000 r.p.m. The volumetric efficiency at N.T.P. is 85%. The bore is equal to the stroke and thermal efficiency of 25 % may be assumed. Calorific value of petrol is 44100 kj/kg. Air-fuel ratio is to be 15:1. Calculate the cylinder bore and stroke.
Provide a clear and complete solution as well as a diagram. A Rankine cycle has a steam throttle condition of 5Mpa and 420oC. The turbine exhaust is 1 atm, find the cycle efficiency. At 5Mpa and 420oC: h= 3244.7, s= 6.7172 At 1 atm: sf= 1.3069, sfg = 6.7172 hf= 419.04, hfg = 2257, v= 0.0010435m3/kg A. 27.06% B. 29.44% C. 35.55% D. 28.41%
A four-cylinder spark-ignition engine with a compression ratio of 8 has a pistonswith a bore of 9 cm and a stroke of 10 cm. The air pressure at the beginning of thecompression is 98 kPa, and the temperature is 37 oC. The engine may be modeled by theair-standard Otto cycle. The maximum cycle temperature is 1700 oK. If the engineproduces 75 kW of power, determine a) the heat supplied per cylinder; b) the thermalefficiency; and c) the rpm required.
Diesel cycle releases 1750 J/mol ofheat. The pressure and temperature at the begin-ning of the compression step are 1 bar and 50°C,and the pressure at the beginning of the expansionis 5 bar. The working fluid is an ideal gas for whichcP= 7R/2 andcV= 5R/2. (a) What is the tem-perature at the end of the adiabatic expansion? (b)What is the heat absorbed by the engine? (c) Whatis the compression ratio? (d) What is the work doneduring the compression step?
1.) The ratio of the pressures in an Ericsson Cycle is 8. Determine the Thermal Efficiency in % 2.) The compression ratio of a Stirling Cycle is 11. What is the thermal efficiency in %? 3.) The compression ratio of a Stirling Cycle is 4. Heat is rejected at 90C. What is the highest temperature in the cycle in Celcius? ANSWER SHOULD BE ROUND OFF IN SIX SIGNIFICANT FIGURES
Please show how to solve the following : Cycle pump power requirement ,Turbine power production ,Cycle efficiency
Steam is the working fluid in the ideal Rankine cycle 1-2-3-4-1 and in the Carnot cycle 1-2-3-4'-1 that both operate between pressures of 1 bar and 20 bar as shown in the T-s diagram in the figure below. Both cycles incorporate the steady flow devices. 20 bar 1 bar Stude P (hur) e (mAg) 20 2799 2295 0.8318 844.3 0.1889 417.9 0.001043 20 419.9 -- 20 908.9 For each cycle determine: (a) the net power developed per unit mass of steam flowing, in kJ/kg. (b) the percent thermal efficiency. 1.
A diesel engine has a state before compression of 95 kPa, 290 K, a peak pressure of 6000 kPa, and a maximum temperature of 2400 K. Find the cyclic state points, the volumetric compression ratio and the thermal efficiency. WITH ILLUSTRATIONS
If the Rankine cycle shown in the figure is an "Ideal Rankine cycle", what assumptions do you typically make? Select all that apply: Turbine Boiler Condenser - Qout (KL: 45 sec) (Chien-Ming: 1 min) RR: up to 1min NT = 100% O Wr > Wp O State 4 is a saturated liquid O X3 = 1
Get the following values for each stage using NIST tables: Stage 5: T5, H5 Explain how to get values please.
High-P turbine Low-P turbine Reheater 4 Boiler P4 = P3 = Prcheat Pump Condenser The following data was given for a steam Click Save and Submit to save and submit. Click Save All Answers to save all answers. The following data was given for a steam power plant operating on the ideal reheat Rankine cycle. 3-4: Inlet steam at 17.5 MPa and 600 6-1: inlet steam at a pressure of 11.16 kPa at a wetness fraction of 0.1. At state 1, the specific volume is 0.00101 m³/kg 3 Find the dryness fraction of steam at state 6 to 1 decimal places.

SEE MORE QUESTIONS

Recommended textbooks for you

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Elements Of Electromagnetics

Mechanical Engineering

ISBN:

9780190698614

Author:

Sadiku, Matthew N. O.

Publisher:

Oxford University Press

Mechanics of Materials (10th Edition)

Mechanical Engineering

ISBN:

9780134319650

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Thermodynamics: An Engineering Approach

Mechanical Engineering

ISBN:

9781259822674

Author:

Yunus A. Cengel Dr., Michael A. Boles

Publisher:

McGraw-Hill Education

Control Systems Engineering

Mechanical Engineering

ISBN:

9781118170519

Author:

Norman S. Nise

Publisher:

WILEY

Mechanics of Materials (MindTap Course List)

Mechanical Engineering

ISBN:

9781337093347

Author:

Barry J. Goodno, James M. Gere

Publisher:

Cengage Learning

Engineering Mechanics: Statics

Mechanical Engineering

ISBN:

9781118807330

Author:

James L. Meriam, L. G. Kraige, J. N. Bolton

Publisher:

WILEY

SEE MORE TEXTBOOKS

Q1: For the Dual cycle (Limited pressure cycle) shown in figure above show that :- 1 7th = 1 ap-1 (r-)7-1 ay (p-1)+ (a -1). (p) = Cut-off ratio. (a) = Pressure ratio. Where: (77) Thermal efficiency of the cycle. (y) Adiabatic index. = ()Compression ratio.