Q.2 Flexural Formula In a reinforced concrete section, the stress at the extreme fibre is compression is 5.80 MPa. The depth of neutral axis in the section is 58 mm and the grade of concrete is M25. Assuming linear elastic behavior of the concrete, the effective curvature of the section (in per mm) is

Q.2 Flexural Formula In a reinforced concrete section, the stress at the extreme fibre is compression is 5.80 MPa. The depth of neutral axis in the section is 58 mm and the grade of concrete is M25. Assuming linear elastic behavior of the concrete, the effective curvature of the section (in per mm) is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectangular reinforced concrete beam has a width of 350 mm and an effective depth of 650 mm. The beam is reinforced with 8-28 mm diameter tension bars. Concrete strength is f'c = 20.70 MPa and steel yield strength is fy = 275 MPa. 1. Which of the following most nearly gives the steel ratio? A. 3.73% B. 2.79% C. 2.17% D. 1.62% the rectangular
Civil Engineering -Construction Material & Testing A block of concrete masonry unit is tested for compressive strength. The outside dimensions of the specimen are 200 mm X 400 mm X 100mm . The cross section contains three (3) hollow square, 75mm each side, with a wall thickness of 25mm. Is the CMU, considered solid or hollow. Discuss why.
A rectangular reinforced concrete beam has a width of 300mm and an effective depth of 400mm. Concrete strength is f'c = 28 mpa and steel yield strength is fy = 280 mpa. The modulus of elasticity of steel is 200,000 MPa Compute for the total compressive forceon concrete.
I want this please
In a reinforced concrete section, the stress at the extreme fibre is compression is 5.80 MPa. The depth of neutral axis in the section is 58 mm and the grade of concrete is M25. Assuming linear elastic behavior of the concrete, the effective curvature of the section (in per mm) is
A rectangular beam has a width of 380 mm, effective depth of 445 mm, and overall depth of 510 mm and is reinforced with four No.29 tension bars. The concrete modulus of rupture fr = 3.65 MPa. The elastic modulus of the concrete and steel are, respectively, Ec =27,800 MPa and Es= 200,000 MPa. Determine if the beam will show hairline cracks due to a bending moment M = 108 kN-m and compute the relevant stresses. Provide material properties for concrete and reinforcing steel used in your design.
Please try to solve only part 2 within 20 minute This is request
A rectangular reinforced concrete beam has a width of 300 mm and an effective depth of 400 mm. Concrete strength is f’c = 28 MPa and steel yield strength is fy = 280 MPa. a. What is the distance of the neutral axis from the top of the beam so that the strain in the concrete 0.003 will be attained at the same time with the yield strain of steel? b. What is the total compressive force on concrete? c. What is the balanced steel ratio?
2. Tensile strength of concrete is about: (20-35)% of compressive strength (45-70)% of compressive strength None of the above. Tension controlled section Balanced section Compression-controlled section 4- The reduction factor (0) is equal to 0.9 if the: Es 2 Ety + 0.003 Es S Ety + 0.003 Es Ety 5- The design method which use the factored loads is - Working stress method - Ultimate design Method - None of above 6- If p< Po therefore the section is - Under reinforced - Over reinforced - None of above