Consider the prestressed concrete beam and prestressing steel stress-strain diagram given below. The concrete is assumed to have an ultimate strain capacity of 0.003 in/in. Determine the nominal strength of the member using the strain compatibility method. It should be noted that the stress-strain diagram below allows virtually "exact" calculation of stresses and strains in the prestressing steel.

Consider the prestressed concrete beam and prestressing steel stress-strain diagram given below. The concrete is assumed to have an ultimate strain capacity of 0.003 in/in. Determine the nominal strength of the member using the strain compatibility method. It should be noted that the stress-strain diagram below allows virtually "exact" calculation of stresses and strains in the prestressing steel.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

At what percent of compressive strength of concrete the stress in beam changes from directly proportional to varying with respect to depth.
2 please include scketch
Only compute the I, where the formula is; I=bh² / 12
A beam of the cross section shown is made of a steel that is assumed to be elastoplastic with E=29×106psi and σY= 42 ksi. A bending couple is applied to the beam about the z axis, causing plasticzones 2 in. thick to develop at the top and bottom of the beam. After the couple has been removed, determine (a) the residual stress at y=2 in., (b) the points where the residual stress is zero, (c) the radius of curvature corresponding to the permanent deformation of the beam.
Question prestress.
Please try to solve only part 2 within 20 minute This is request
Situation 5: The compound bar, composed of the three segments shown, is initially stress free. Compute the stress in each material if the temperature drops 25°C. Assume that the walls do not yield and use the following data: A (mm²) a (/*C) E (GPa) Bronze segment 2000 19.0 x 10-6 83 Aluminum segrnent 1400 23.0 x 10-6 70 Steel segment 800 11.7 x 10- 200 - 500 mm→- 400 mm- 800 mm Aluminum Steel Bronze 17. Compute the stress in the bronze bar a. 31.6 MPa (T) b. 31.6 MPа (С) 18. Compute the stress in the aluminum bar. а. 45.1 MPа (Т) b. 45.1 MPa (C) 19. Compute the stress in the steel bar. 79.0MPA (T) 79.0MPA (C) 13.6 MPa (T) 13.6 MPa (C) c. d. 54.1 MPа (Т) 54.1 MPa (C) с. d. a. C. 97.0 MPa (T) b. d. 97.0 MPa (C)
beam, For a pre-tensioned Young's Modulus of steel and concrete are 200 GPa and 35.35 GPa, respectively. Pra If the ultimate shrinkage strain and Ultimate Creep Coefficient are 200 microns and 1.6, respectively, what is the level of sustained stress in concrete at the level of 'steel' if the loss due to creep is three times the loss due to shrinkage.
What is unconfined compressive strength test, which triaxial compression test is similar to shows? If the maximum compressive stress value obtained from this test is qu, this test Show the shear strength of the specimen using the Mohr tensile circle. Also, short Why is the unconfined compressive strength of the Comment on its use. I will understand better if you type the answers with the keyboard thank you.
4
Help
Please solve this question and provide solution