Problem 5: A fluid flows by gravity down an 8-cm galvanized ironpipe. The pressures at the higher and lower locations are 120 kPaand 140 kPa, respectively. The horizontal distance between thetwo locations is 30 m, and the pipe has a slope of 1-m rise per10 m of run (horizontal distance). For a fluid with a kinematicviscosity of 10-6 m2/s and a density of 900 kg/m3, determinethe flow rate (in m3/s).

Q: asoline at 77°F flows from a pressurized upper tank to a vented lower tank as shown in the figure…

A: Givenh2=52.8ftTemp=77°Fρgasoline=45lb/ft3

Q: Q3:- A liquid whose coefficient of viscosity is µ flows below the critical velocity for laminar flow…

A: The loss of pressure in a length of 120 m is 11520 N/m2.

Q: Problem 2: Control volume and Bernoulli Water drains from a tank through two r = 0.01 m diameter…

A: Given  1)  2)  3)  Please Rate if this solution helps youThank You

Q: 1. A hydraulic pump is shown in Figure 1, flow rate is 25 L/min, the diameter of suction pipe is…

A: Given Data Flow rate, =25 L/min Diameter of suction pipe, =25 mm Suction port of pump is higher…

Q: slug ) flows through the pipe system below. Data is given below: ft³ Pipe 1: V₁=1.8 ft, D₁=2.4…

A:

Q: Problem 5.46 The flow of oil through the pipe is 0.041 m³/s. Take Po = 875 kg/m³ Pw 1000 kg/m³.…

A:

Q: Pressure loss along a pipe pumping water is 6.6Pa. If the pipe is 2.1m long, what angle (in degrees)…

A: To overcome the pressure drop along the pipe, we need to consider the effect of gravity on the water…

Q: As part of a processing of biofuels, water is pumped into a circular tank with a diameter D₁, as…

A: For the solution refer below images.

Q: Water is filled into a circular tank (inner diameter 1 m) from two inlet pipes as shown. The…

A: Inner diameter of the tank, Volumetric flow rate at inlet 1, Let the volumetric flow rate at inlet 2…

Q: Crude oil of specific gravity 0.81 and kinematic viscosity of 4.28 stoke is flowing through a pipe…

A:

Q: Water flows at a rate of 12 L/s in an 80 mm diameter of galvanized pipe installed in a vertical…

A:

Q: On a single plot, plot three curves that show the relationship between the pressure generated by the…

A:

Q: Q3/ Hydraulic oil ISO 68 is flowing through a hydraulic line with an inside diameter of 1.4 inches…

A:

Q: 4. The system in Fig. consists of 1200 m (length) of 0.05 m (diameter) cast iron pipe, two 45°…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.