Problem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity ofthe solid particle is 2.84.1. Determine the density of the clay in kg/m².2. Determine the total vertical stress at the bottom of the clay layer in kpa.3. Determine the effective vertical stress at the bottom of the clay layer in kpa.

Using relationρsat=G+wG1+wGρw

Problem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of the solid particle is 2.84. 1. Determine the density of the clay in kg/m'. 2. Determine the total vertical stress at the bottom of the clay layer in kpa. 3. Determine the effective vertical stress at the bottom of the clay layer in kpa.

Problem 4. A 20m thick submerged saturated clay layer has water content of 57%. The specific gravity of the solid particle is 2.84. 1. Determine the density of the clay in kg/m'. 2. Determine the total vertical stress at the bottom of the clay layer in kpa. 3. Determine the effective vertical stress at the bottom of the clay layer in kpa.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A soil profile consists of sand (5-m thick) which overlies a layer of clay (4-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.75, Degree of Saturation = 0.76 For clay layer: Void Ratio = 1.09, Specific gravity = 2.76
Dry Sand H, Groundwater Table Clay Refer to the soil profile shown. Given H1 = 8.85 m., and H2 4.01 m If the ground water table rises by 2.19 meters, determine the change in effective stress (numerical value only, in kPa) at the bottom of the clay layer Properties of dry sand Gs = 2.51, e = 0.65 Properties of clay. Gs = 2.72, e = 0.84. Round off to two decimal places. Activate Windows Go to Settings to activate Windows. < Question 18 of 20 2 A Moving to another question will save this response. ASUS C8O CD 80 5n E R- T Y H]
Problem 2 Plot the stress profile for total stress, effective stress and pore water pressure. Show all calculation. A Dry sand 0.61 G=266 Saturated sand. e=0,48 G=267 Clay
Q: For the soil profile shown in figure. Determine: The effective stress (o') at level (A). Soil 1 k = 0.2 cm/sec Y sat = 19 kN/m³ Soil 2 k = 0.4 cm/sec Y sat = 21 kN/m³ Datum D EL + 2.0 m EL 0.0 m EL - 1.0 m EL - 4.0 m EL - 10.0 m
si
. A soil profile is shown in figure below. Dry sand Yay- 165 KNm 6m Groundwater table Saturated sand 13m Yu 19.25 kN/m" Dry sand Saturated sand Clay Calculate the following: a. Effective stress at point A in kPa. b. Effective stress at point B in kPa. c. Effective stress at point C in kPa.
Please show me steps I am studying for exam
write all step is clearly pls you give me different solution why
Consider point P. If the groundwater drops 1m to the top of the clay layer, what would the change in Total Stress and Pore Water Pressure change? 1 m 1m 2m 2m P Sand Clay Sand Pd = 1.35 Mg/m³ Psat 1.85 Mg/m³ H Psat = 2.0 Mg/m³ Psat = 1.9 Mg/m³
A soil profile consisting of three soil layers is shown. Assume: layer 1 as drysoil. Characteristics of the layers are: a=4 b=7 c=5 d=1 Determine:a.) The effective stress at Point Cb.) The maximum Neutral Stress at Point D