power station has to meet the following demand: Group A: 200 kW between 8 A.M. and 6 P.M. Group B: 100 kW between 6 A.M and 10 A.M. Group C: 50 kW between 6 A.M. and 10 A.M. Group D: 100 kW between 10 AM and 6PM. and then between 6 P.M. and 6 A.M. Plot the daily load curve and determine (i) diversity factor (ii) units generated per day (iii) load factor.

power station has to meet the following demand: Group A: 200 kW between 8 A.M. and 6 P.M. Group B: 100 kW between 6 A.M and 10 A.M. Group C: 50 kW between 6 A.M. and 10 A.M. Group D: 100 kW between 10 AM and 6PM. and then between 6 P.M. and 6 A.M. Plot the daily load curve and determine (i) diversity factor (ii) units generated per day (iii) load factor.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.31P: Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in...

See similar textbooks

Similar questions

A generation station of 3 MW supply a two region A & B .The load variation of these regions is as follow: Region A (Time) From midnight from 4a.m to From 10a.m to From 5p.m to to 4a.m 10a.m 5p.m 7p.m From 7p.m to midnight Load(kw) 800 500 NO load 300 100 Region B (Time) From From From From From midnight 6a.m to 2p.m to 4p.m to 9p.m to Load(kw) to 6a.m 300 2p.m 4p.m 9p.m midnight 600 No load 800 1100 With neglect transmission line losses. Find the load factor, diversity factor, reserve capacity,plant use factor.
The indication of a lagged demand meter approaches the value of the actual load at a rate which is proportional to A. Quotient of the load and the meter indication. B. product of the load and the meter indication C. Difference between the load and the meter indication D. sum of the load and the meter indication
A generating station is to supply four regions of load whose peak loads are10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Then the installed capacity is (25 to26)MW. O (24 to25)MW. O (23 to24)MW. O
Consider the switching waveforms shown below, operating with a duty-cycle of 30%. Which statements correctly describe the switching circuit, load and circuit operation? (Multiple answers possible, but wrong answers will deduct marks) Voltage across load Voltage (V) 000 120 0000 100 80 60 40 20 30 Time (us) The load must be predominantly resistive. The average current in the load is 1.0A. The RMS current in the load is approximately 1.414A. The load must be predominantly inductive. The resistive part of the load is 200ohms. The average current in the load is 0.6A. O The resistive part of the load is 50ohms. 0 0 10 20 40 50 60 Current (A) 2 5 0.5 0 0 10 Current through load 20 W 30 Time (us) 40 50 60
Answer it i will thumbs up Dont copy paste..
2. When a large shunt capacitor is suddenly connected in parallel with the load bus in the distribution feeder, what would happen to this bus current? O A. Increase B. Decrease D. None of Above
Where did it come from?
8. Two 3-Ø synchronous mechanically-coupled generators operate in parallel on the same load. Determine the KW output and P.F. of each machine under the following conditions: Synchronous impedance of each generator 0.2+j2 ohm/phase, Equivalent impedance of the load 3+j4 ohm/phase Induced e.m.f. per phase, 2000+j0 volt for machine I and 2200+j100 volt for II. [Ans. output of GI: 399.2KW(3-Ø), 0.6062 & output of GII: 747KW(3-Ø), 0.596]
The peak load on a 50 MW power station is 39 MW. It supplies power through for transformers whose connected loads are 17, 12,9 and 10 MW. The maximum demands on these transformers are 15, 10, 8 and 9 MW respectively. The annual load factor is 50% and the plant is operating for 65% of the period in a year. 102. The average load on the station is (A) 50000 kW (C) 39000 kW (B) 19500 kW (D) 48000 kW. 103. The energy supplied per year is (A) 438 x 106 kWh (C) 170.82 x 106 kWh (B) 341.64 x 106 kWh (D) 420.48 x 106 kWh.
Show your detailed soln
two generators supplying a load. Generator I has a no-load frequency of 62.5 Hz and a slope Sp1 of I MW/Hz. Generator 2 has a no-load frequency of 62.0 Hz and a slope sp2 of I MW/Hz. The two generators are supplying a real load totaling 2.5 MW at 0.8 PF lagging. (a) At what frequency is this system operating, and how much power is supplied by each of the two generators? (b) Suppose an additional I-MW load were attached to this power system. What would the new system frequency be, and how much power would Gl and G2 supply now? Generator 1 VT V2 Generator 2 VTí KVAR KVAR
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.