Answered: Please show all steps Given the…

Please show all steps Given the following Information, what is the Elevation of Point B? STA A HI 1.572 STA HCR VCR SD HR DESC B 0:00:00 87:06:55 87.006 0.700 NAIL Point Elevation A 1180.525

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: -PVI 607.00' 9 22 BUC -12 20100 OUTH elev @ PVI = 608.00' Determine the elevation at the initial…

Q: Q3: Calculate the true differenc between points (A&B), then correct the staff reading at point (B)…

Q: Please draw the steps in doing profile leveling using the date given. Please provide proper…

A: Given Data, Bm ---bench mark Tp- Turning point Bs -- Back sight Is -- intermediate Sight…

Q: Gate (AB) is hinged at (B) with 8 = 53.3°, having (1.8m) wide and (92.5kN) weight, find water level…

Q: Using virtual wok k metho d. calculate the vertrcal cleflection at joint b B Im Im Im 10O0KM

Q: KN 4m 上 4m 100 t Kat 200

Q: b) The following readings were taken with a level and 4m staff. Draw up a level book page and reduce…

A: Given:- The height of the staff = 4 m The elevation of the benchmark = 58.250 m To determine:- The…

Q: . 17-6. Schematic arrangement of lines along the level route. 328 (FS) 3.08 (BS) 2.04 (FS) HI2 (Elev…

Q: find v and m

A: The given frame is shown below.

Q: A differential levelling circuit began on BM Mil and closed at BM Oak with the elevations indicated…

Q: Line Distance AB BC CD DE EF FG 62.56 29.49 65.07 41.14 43.70 26.74 Forward Bearing N 81-02-05 W N…

A: Given: LINE FB BB AB N 81-02-05 W S 79-26-30 E BC N 08-16-07 W S 13-18-15 E CD S 87-34-45 E…

Q: 2. 057 A. Convert the notes into a leveling notes of Rise and Fall and complete the data. B. Compute…

A: Formula If IFS2 - BS1 is positive then rise If IFS2 - BS1 is negative then fall

Q: 0 4: Anarea ļ* km20 jem is TO be surrered using acrial photogd Average scale photograph is !:10,000…

Q: The R.L. of the point 'A' which is on floor is 100m and back sight reading on 'A' is 2.445m. If the…

A: Introduction : In this question we have given back sight reading and foresight reading and reduce…

Q: Standard leveling field book format (HI method) Location Date Observer Weather Inst. No Station BS…

Q: All data are in feet. The elevation of BM-A is 1364.58 feet. Rod readings are as follows: +S on…

Q: LINE LAT DEP DPD 2A 1-2 -310.95 469.84 a 2-3 112.87 d -142,954.36 3-4 28.8 -1099.62 e f 4-5 -21.86 h…

A: DPD of a line = DPD of previous line + Lattitude of previous line + Lattitude of present line. 2A…

Q: 11. The R.L, of the point 'A' which is on the floor is 100 m and back sight reading on 'A' is 2.455…

A: Draw the rough sketch of the given problem. Then using the principles of levelling the RL of point B…

Q: 1 15m 1.05 2 25m 1.20 3 30 M 1.32

A: Station A Stadia rod 1 = D = Ks1 + c 15 = 1.05 K + c Stadia rod 2…

Q: 5/18 Determine the x-coordinate of the centroid of the shaded area. y 2a 0 r = k₁+ k₂0 a Problem…

A: A shaded area is given:- The value of r = k1 + k2 ×θ r = a when θ = 0 r = 2a when θ=π2 To…

Q: Find intermidiate elevation

A: ###Finding Elevation of Intermediate Point C ###

Q: How is measuring DBH with a biltmore stick different than measuring DBH with a D-tape?

Q: (a) Locate the centroid andỹ of the shaded area. Given, h (20+ last digit of your ID) cm y 40 cm h

A: Consider the free body diagram; Calculate centroid of area BCD from y-axis x1=23×80x1=1603cm…

Q: Q3: The following consecutive staff readings were taken with a level: 1.895, 1.500, 1.865, 2.570m…

Q: STATION BS HI FS ELEVATION REMARKS BM1 1.40 100 TP1 6.50 3.23 TP2 4.42 0.04 TP3 3.43 0.42 TP4 3.02…

A: *Multiple questions* As per our guidelines we are supposed to answer?️ only one question. Kindly…

Q: Check the correct statements regarding the picture. * ALT HDG MDA 310 10 ▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬▬ 10 10…

A: The picture displaying shows, Air craft is perfectly aligned with the centre of the runway

Q: help me plot the horizontal and vertical distance using free hand

Q: 12. Given the following tabulated data for a closed tra- verse in which the lengths of sides CD and…

A: to find- length CD and DE for given traverse data.

Q: The technical description of a six-corner lot is tabulated in the table below. BEARING DIST LAT…

A: Latitude: The projection of a line on the north-south meridian which is equal to the multiplication…

Q: P-400 of 2005

Q: 3. Complete the calculations tabulated below. Perform a check on the ending elevation of BM 3055.…

A: Solution:- The complete calculation is shown below in the table.

Q: Use the following set of field notes to determine the average zenith angle of the set. Instrument @…

A: Average of Zenith angle = Sum of all angle/ no. Of angle

Q: Profile Level Notes: The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus…

A: Given The elevation of BM A = 343.43' BS (plus sight) on BM A = 9.43' IFS (minus sight) on STA 0+00…

Q: Tabulate the computed values accordingly. Length, Calculated Bearing LATITUDE DEPARTURE UNE +N -S +E…

Q: Determine the y-coordinate of the centroid of the shaded area. 0.37h 51° V 51° Answer:y = i

Q: figure, Draw up a level book page and reduce the levels by the height of instrument method.

Q: A transit with stadia interval factor of 100.8 was set up at point C on the line between points A…

A: Given :- Stadia interval factor (K) = 100.8 set up at point C between A & B Distance from the…

Q: Find headlight sight distance and intermediate sight distance for V=70kmph. (Hint: f=0.36,t-2.5 s,…

Q: complete the leve1 the 5. DOUBLE-RODDED LEVELING. Set up and for a double-rodded line from BM45 to…

A: Solution Double rodded levelling result is given

Q: IV - Coordinate measurement Oa) 1, II, II, IV OB) I, II, IV OC) I and III OD) I and II O TO) II and…

A: Brief concept- The image shown is of auto-level. This is used commonly in surveying for leveling…

Q: a-What is the height of instrument between TP-1 and TP-2? b-What is the unadjusted elevation of…

A: Differential levelling: The process of measurement of vertical distances from the known elevation…

Q: Löveling. Rod Hl4 Levoling Rod 90 68 Hi 78s) 3,75 (FS) 3.73 (BS) Hlg1.64 (FS) 0.98 Hl2 3.52 BM. Elev…

Q: Station A (10+040) 9.50 11 +3.00 +2.00 +4.00 Station B (10+060) 6.50 8.00 +1.00 1.20 +2.00

Q: Find the area of all and then convert to square feet

Question

Please show all steps

Given the following Information, what is the Elevation of Point B?

STA	A	HI	1.572
STA	HCR	VCR	SD	HR	DESC
B	0:00:00	87:06:55	87.006	0.700	NAIL
Point	Elevation
A	1180.525

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Can you draw graphical method ?
200 soON 200N 3m 3m IR, "yat point C
T 4500mm 4000mm 5500mm Beg TO only estimate volume of beam 1 -5500mm -4500mm- 6000mm www 1 Straight bottom bat $12 #300rur Offset but 0300mm חוין912 additional top ba #12min #3X0rm Concrete Column 500x500mm 100mm 5020mm # 5020mm- dttd ㅏ ban --5020mm **** *-500mm* Sec 0-0 || || 11 500mm Sec d-d et H -5020mm 1400mm 150mm 5020mm TU 6 C Opening !! || 150mm 5020mm- -500mm Sec b-b 2020mm. Uffect ba P12mm)- 0250mm -500mm Sec e-e B -2020mm ww 2 150mm 2020mm- 16 ۱۱۱۱۱۲۲۲ 2020mm t Additional top bar 12mm 4 Straight bottom bar *120m 0250mm *-500mm- Sec c-c +Beam 1 +Beam 1 +Beam 1 -5020mm Y am 1 500mm Sec f-f 5*20mm
What is the set-up of the integral in finding the area of the shaded region below? V2 y-sec 0 tan 0 4. 4. LGec O tande 1,(sec e tan 6)de 2- sec@tan@)de L-sec e tane)de
DIFFERENTIAL LEVELING. The accompanying schematic arrangement of lines portray a differentiallevel route. The values indicated represent backsight and foresight readings taken at different points aslabelled. Prepare and complete level notes for the information shown and perform the customaryarithmetic check.
kindly help me with this 2 questions, thankyou! its in the surveying subject
I need detailed explanation of how to determine the stations and elevations of the BVC and EVC. BTW I don't understand how you get in there and what is the (10+19.25/2). Please I need details of every step, thank you in advance
Answer fast please Will upvote
I will rate immediatley thank you.
(plus sights) BS (+) Station HI BMA 6.87' 1031.19' TP1 4.98' TP2 7.43' TP3 0.98' TP4 4.57' TP5 8.20' трь 3.65' TBMX 8.52' TP7 2.22' TP8 7.04' TP9 4.74' TPID 3.68' ΤΡΙ 5.90' BMA Σ = (minus sights) (minus sights) FS (-) IFS (-) 5.32' 6.27' 2.84' 8.34' 3.76 6.52' 5.97' 5.89¹ 4.63' 2.39' 6.00⁰ 8.27 2.60' Check: Misclosure: Permissible Misclosure: Adjustment: Elevation 1024.32 102398 Published Information for BM 303- elevation = 1024.32' (NAVD88) Fieldnote information: BS on BM 303 = 6.87' FS on TP1= 5.32' BS on TP1 = 4.98' FS on TP2 = 6.27' BS on TP2= 7.43' FS on TP3= 2.84' BS on TP3= 0.98' FS on TP4 = 8.34' BS on TP4 = 4.57' FS on TP5= 3.76' BS on TP5= 8.20' FS on TP6= 6.52' BS on Tp6= 3.65' FS on TBM R22 = 5.97' BS on TBM R22 = 8.52' FS on TP7 5.89' BS on TP7= 2.22' FS on TP8= 4.63' BS on TP8 7.04' FS on TP9 = 2.39' BS on TP9 = 4.74' FS on TP10= 6.00' BS on TP10 = 3.68' FS on TP11 = 8.27' BS on TP11= 5.90' FS on BM 303 = 2.60'
complete and check the level notes. Note: SS designates a side-shot.
Quèstion 6 Staff reading taken on a benchmark or a point of known elevation is called O A. Any one of these B. Intermediate sight C. Back sight reading D. Fore sight reading