plate coated with silica gel, with propanone, CH3COCH3, as the solvent for thin-layer chromatography. Suppose also that the mixture you were trying to identify contained benzaldehyde benzanilide phenol 1) rank the Rf value from large to small 2) name the IMF between each compound and the silica gel OH ● OH OH -0-si-0-Si-O-Si-O- main body of silica structure

plate coated with silica gel, with propanone, CH3COCH3, as the solvent for thin-layer chromatography. Suppose also that the mixture you were trying to identify contained benzaldehyde benzanilide phenol 1) rank the Rf value from large to small 2) name the IMF between each compound and the silica gel OH ● OH OH -0-si-0-Si-O-Si-O- main body of silica structure

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A single analysis using chromatography produced a chromatogram with three peaks. The peak for compound A has a retention time of 0.44 min, compound B of 5.86 min and compound C of 6.14 min. i) Compound A does not interact at all with the stationary phase. What information can be obtained from the retention time of A? ii) Calculate the retention factors for compounds B and C respectively. iii) Calculate the selectivity factor for compounds B and C. iv) The peaks for compounds B and C have respective widths of 0.32 min and 0.35 min. Calculate the resolution of compounds B and C, and comment on the significance of the magnitude of your answer.
To separate a mixture of compounds containing the following two compounds column chromatography was used by a student. Stationary phase was silica gel and mobile phase was 95 % ethyl acetate and 5 % Hexane mixture. Which compound elutes first through the column? Why
Write an objective for chromatographic separation of the components of spinach leaves
A series of nonpolar aromatic compounds were separated by isocratic HPLC on a nonpolar stationary phase containing octadecyl groups [−(CH2)17CH3] covalently attached to silica particles. The mobile phase was 60/40 methanol/water. How would the retention times be affected if 90/10 methanol/water were used instead and why? What type of chromatography?
9
Professor Forni has hired you as a research assistant and you need to make an X-gal staining solution for your sections containing 5mM potassium ferrocyanide, 5 mM potassium ferricyanide, 2 mM MgCl2, 0.1% Tween and 0.1% BCIP. You need 50 ml. As you are getting ready you discover that your colleague has used up all but 20 mg of the MgCl2.How much MgCl2 do you need to make 50 ml of X-gal staining solution? Do you have enough? Hint: we only care about MagnesiumChloride here. (MW MgCl2 is 95.21 g/mol)
Please don't provide handwriting solution
Why is it best to use a small amount of standard when performing mixed melting point analysis?
2
Thin‑layer chromatography (TLC) can be used as a preliminary identification method for many amphetamine‑type stimulants (ATS). Using a 0.25 mm thick silica gel stationary phase and a 98.5:1.5 methanol:concentrated ammonia mobile phase, a spot was observed to have traveled 3.52 cm when the solvent front traveled 8.81 cm. What is the retardation factor (?F)for the compound that composes this spot?
A gas chromatogram of a mixture of toluene and ethyl (a) Measure w1/2 for each peak to the nearest 0.1 mm. When the thickness of the pen trace is significant relative to the length being measured, it is important to take the pen width into account. It is best to measure from the edge of one trace to the corresponding edge of the other trace, as shown at the bottom of the left column. (b) Find the number of theoretical plates and the plate height for each peak.
Answer bank: salicylic acid, nicotine and acetophenone