PARTIAL PRESSURE T03/S21 Unit conversion A gas sample containing only C2H2F4, C6H6 and C4Hg has the following mass percent K = C + 273 1 atm = 760 torr Molar Mass (g/mol) composition: 47.4% C2H2F4 and 46.3% C6H6. Calculate the partial pressure (torr) of C4H8 if the total pressure of the sample is 0.250 atm. 102.03 C2H2F4 78.054 C6H6 C4H8 56.068 the tolerance is +/-2%

Q: Table 2. Soil moisture content data Sample Moisture state 1 Field capacity (2 days after rain)…

A: Answer-1When a moist substance is heated, it loses the water present in it and becomes dry and mass…

Q: Solve the attached Problem.

A: Given reaction,

Q: Methods of Analysis Test #1: Polarity, or Effect of a charged rod on a stream of liquid: This test…

A: Given substances are: acetone, hydrogen monoxide, ethylene glycol, n-butanol, hexane, and toluene.…

Q: s that can be obtained non-invasively such as saliva, sweat, hair, nails, etc. The lab will analyze…

A: For the analysis of Cu in biological samples, both Atomic Absorption Spectrophotometer (AAS) and…

Q: During a routine check of the fluoride content of Gotham City's water supply, the given results were…

A: The replicate concentration values are: 0.815 mg/L, 0.789 mg/L, 0.811 mg/L, 0.789 mg/L, and 0.815…

Q: This question has multiple parts. Work all the parts to get the most points. For the reaction below:…

A: Cis-cyclohexan-1,2-diol reacts with acetone to form cyclic ketal whereas trans-cyclohexan-1,2-diol…

Q: We started with 20 mL 1 M acetic acid ~ 0.020 L acetic acid in a flask. (Ka acetic acid =…

A: Millimoles of acetic acid taken=Molar concentration of acid×mL of acid=1 M×20 mL=20 mmol

Q: 1. Provide a systematic name for each of the following compounds: Structure No. 1 IUPAC name

A:

Q: Construct a simulated ¹H NMR spectrum for 1,2-dichloroethane. Drag and drop the appropriate…

A: We have find out the answer.

Q: Arrange these compounds by their expected solubility in hexane, C6H₁4- C₂H H₂O C₂H₂OH Most soluble…

A: Remember, Like dissolve Like  It means polar substance dissolve in polar solvent and non-polar…

Q: LEARNING TASK 4!

A: Given,

Q: How many moles of CaCl2 are in 7.76 × 1024 formula units? 7.76 x 1024 formula units = mol

A: 1mole of substance = (6.023×10 23) formula units

Q: the formal charge on CI?

A:

Q: Hello I need help with this chemistry problem thank you

A: First H2SO4 is taken which is a source of H+ so when it treat with epoxy line pair of oxygen will…

Q: Line equation And R2 Constituents Total Average Peak Concentration Peak Height (mm) Area (ppm) 250…

A: R2, also known as the coefficient of determination, evaluates the data points of the regression…

Q: Please could someone explain this with terminology relevant to GCSE

A: Ethane is a saturated hydrocarbon while ethene is unsaturated hydrocarbon.

Q: Use the exponent (EE) functionality on your calculator to do these calculations (a & c should be…

A: Significant figures of the answer will be two significant figures as the questions have .

Q: 1) Determine the moles of KMnO4 required for each trial. 41.43 mL 0.45 mL = 40.98 mL of KMnO4 moles…

A: Given that, Molarity of KMnO4 solution is 0.1 M. For trial 1: Initial burette reading = 0.45 mL…

Q: 1. The crucible is not fired, as the procedure suggests. The mass of the dirty crucible is recorded.…

A: For proper experimental results, we have to carry out all the experiments as given in the procedure.…

Q: A student performed a chromatography experiment to determine the Rf value of an unknown amino acid.…

A: The Rf value ( retention factor) of a compound is defined as the ratio of distance travelled by the…

Q: name the two compounds shown in the image

A: The given reaction is an example of opening of epoxide in basic medium.The nomenclature of the given…

Q: Titration of HCI 22.6mL 5.34 mL 0,2 m/e 1. Volume of HCI 2. Volume of NaOH 3. Concentration of NaOH…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Hello! Thank you for your urgent answer.    Please continue answering the Learning Task 2.…

A: All true and false were correct. I will proceed with answering task 2.

Q: Absorbance (arb.units) 2: 04 NO B-Carotene Calibration Curve 2004 6503 UM O 3.26 mM 5,06 nM. y…

A:

Q: S (CQCL3) t σ 200 180 160 140 120 100 80 20 PPM 0 S (CDC13) 9 200 180 160 140 120 100 80 60 40 20…

A:

Q: After performing Part A of the experiment, a student obtained the following concentrations for…

A: Trial A Trial B Trial C Trial D Trial E Trial F 0.989 0.975 0.976 1.081 1.062 0.949 Unit of…

Q: 7. (4.3 х 10^8) x (2.0 х10^6) 3

A: While solving such problems, multiplication occur with the first terms and powers are added. It…

Q: Which of the following describes a gradient elution process?       stationary phase has varying…

A: In the given question, the nature of the stationary and mobile phase in the gradient process of…

Q: Can you please help me with 5

A: The question number 5 is  (8.41 x 10-5) - (7.9 x 10-6) this can be solved by converting one number…

Q: Balancing Act! Balance this equation! (Equation number 1 of 10) СаСОз + 2HСІ — CaCl2 + H20 + CO2 1 v…

A:

Q: Please help me calculate this: I have a protein sample that has the concentration of 0.30835 µg/ml.…

A: 1 milliliter is equal to 1000 microliters. In the question given that , initial concentration of a…

Q: At a physiological temperature of 37 °C, what is the probability of rhodopsin populating the first…

A: To calculate the probability of rhodopsin populating the first excited state. Temperature = 37oC…

Q: Q19 In order to find bactericidal antibiotics - substances that can selectively kill bacteria…

A: The given data of five compounds effect on the Bacterial cells and Human cells are shown below We…

Q: Based on the data given answer questions. 1,3, and 5 please ?? Question 2 is already answered to…

A: The question is based on the concept of experimental Chemistry.  we need to discuss precision and…

Q: 1a. Throughout the experiment, what are some possible sources of error that could have led to…

A: The objective of this question is to show the experiment involving the separation of table salt and…

Q: Explain Generalized Least Squares & its Assumptions?

A: The Least Squares Assumptions and its usage are mentioned below: Regression model is a linear model…

Q: 6. (1.33 x10^5) - (4.9 x 10^4) =

A: The values to be added or subtracted should have the same units or powers raise to base 10 value.…

Q: 3. Standard white vinegar you can buy in the grocery store is 5% concentration. That means 5% of the…

A:

Q: How does analytical chemistry help in forensic science?

A: The way how analytical chemistry help in forensic science has to be given,

Q: 3. Standard white vinegar you can buy in the grocery store is 5% concentration. That means 5% of the…

A:

Q: Construct a calibration curve based on the following data: Concentration Fe 0.100 0.500 2.00 4.00…

A: The beer’s law explain that the concentration of a solution is directly proportional to the…

Q: Three students (Saerom, Hayoung, and Jiwon) are asked to determine the ppm Ca in a drinking water…

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Which analytical separation method is best for recovering river bodies that are polluted by heavy…

A: Basically the river bodies are polluted by heavy metals like…

Q: If not just solve the first one

A:

Q: A gas OCcuiies 300cm? at uohat demierature of 47°c and Pressure of 700 mmtlg set P: is ts Uoleme at…

A: We have given that V1 = 300 cm3 = 300 mL = 0.3 L P1 = 1 atm T1 = 273.15 K And P2 = 700 mm of Hg =…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.