Part a of the drawing shows a resistor and a charged capacitor wired in series. When the switch is closed, the capacitor discharges ascharge moves from one plate to the other. Part b shows the amount q of charge remaining on each plate of the capacitor as a functionof time. In part c of the drawing, the switch has been removed and an ac generator has been inserted into the circuit. The circuitelements in the drawing have the following values: R=24.00, Vrms = 24.0 V for the generator, and f = 370 Hz for the generator. Thetime constant for the circuit in part a is 7 = 3x10-4 s. What is the rms current in the circuit in part c?Irms =Rwwwi(a)SwitchRCww(b)(c)

Proper solution is provided given below with step by step.Explanation:Step 1: Step 2:

Answered: Part a of the drawing shows a resistor…

Similar questions

A circuit has a 27 millifarad capacitor in a loop with a 127 ohm resistor and nothing else. At t = 0 the potential across the capacitor is 46 volts. What would the potential (in volts) across the capacitor be 6 seconds later?
A DC circuit consists of a 30.5 V battery connected in series to two components. The first component is a variable resistor set to 1.7 Ohms. The second component is a set of four fixed resistors connected in parallel. The first fixed resistor is 7.9 Ohms, the second fixed resistor is 6.5 Ohms, the third fixed resistor is 5.3 Ohms and the fourth fixed resistor is 7.9 Ohms. What is the total current supplied by the battery to the circuit? Use standard abbreviations for MKS units. Your Answer: Answer units
An open circuit containing five resistors starts at point a and ends at point b. The circuit extends to the right from point a and splits into two parallel horizontal branches. There is a 12.0 Ω resistor on the top branch and a 6.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right to a 5.00 Ω resistor. To the right of the 5.00 Ω resistor, the circuit again splits into two parallel horizontal branches. There is a 4.00 Ω resistor on the top branch and an 8.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right until it reaches point b. (b) If a voltage of 50 V is applied between points a and b, find the current in each resistor. 12 Ω ?A 6 Ω ?A 5 Ω ? A 4 Ω ? A 8 Ω ? A
In the circuit shown the capacitor starts discharged. The switch S is closed to theupper position at t = 0.(a) What is the voltage in the capacitor at t = 2 seconds?(b) How much time does it take the capacitor to reach 99% of its maximum voltage.
A fully charged RC circuit is set up using R = 15.0 Ω and C = 8.20 μF with the switch initially open, as shown in the figure. At a certain time after the switch is closed, the current in the circuit has magnitude 3.00 A and the charge on the capacitor is 30.0 μC. At this time, what is the rate at which energy is being stored in the capacitor (in W)?
The capacitor in the circuit shown is fully charged by a 24 V battery. The switch is closed at t = 0. At sometime after the switch is closed, the voltage across the capacitor is measured to be 10 V. What is the current in the circuit at this time, in Ampere? C = 3.0 µF, and R = 2.0 02. Your answer needs to have 2 significant figures, including the negative sign in your answer if needed. Do not include the positive sign if the answer is positive. No unit is needed in your answer, it is already given in the question statement. Cil
The graph shows variation in current, I ( dark line) and voltage, V (dashed green line) over time in an ac circuit. Which one is the correct phasor for the current and voltage? V 05 25 35 4.5 A В V I V I V I C more information is needed to answer this question A В
In the analogy between an RLC circuit and a mass on a spring moving through a viscous fluid, which element in the RLC circuit represents the spring? O the resistor O the capacitor O the inductor O the power supply
Consider the combined parallel-series capacitance circuit shown below. C1 C2 60 μ 30 μ C3 40 µF + 6 V
A series RC circuit with C = 48 mF and R = 50 Ω is driven by a 24 V source. With the capacitor initially uncharged, an open switch in the circuit is closed to complete the circuit. What is the voltage across the capacitor immediately after the switch is closed? What is the voltage across the resistor immediately after the switch is closed? What is the current in the resistor immediately after the switch is closed? What is the voltage across the capacitor after the switch has been closed for 1 s? What is the voltage across the resistor after the switch has been closed for 1 s? What is the current in the resistor after the switch has been closed for 1 s?
An open circuit containing five resistors starts at point a and ends at point b. The circuit extends to the right from point a and splits into two parallel horizontal branches. There is a 12.0 Ω resistor on the top branch and a 6.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right to a 5.00 Ω resistor. To the right of the 5.00 Ω resistor, the circuit again splits into two parallel horizontal branches. There is a 4.00 Ω resistor on the top branch and an 8.00 Ω resistor on the bottom branch. The branches then recombine and the circuit extends to the right until it reaches point b.