31. Given the following elements of an irrigation canal: base of 4 meters, depth ofwater is 2 meters, height of embankment above the canal bottom is 3 meters,width of top of embankment is 2 meters, side slope of the left side is 1:1, sideslope of the right side is 1.5:1, grade slope is 0.0002, and coefficient ofroughness n = 0.025. Compute the discharge of the canal in cubic meter persecond using Kutter's formula.%3D32.Hydraulic jump occurs in the trapezoidal channel with side slope of 1:1 and abase width of 4m. If the upstream depth is 1.0m and the downstream depth is2.0 m, compute the power lost after the jump. 23. Water flows in a triangular channel at a depth of 0.90 m. A hydraulic jumpoccurs at a depth just downstream of the jump is measured to be 1.8 m. Theapex angle is 90°. Calculate the discharge of the triangular channel (apexdown).24.If water is flowing in a rectangular channel 30 ft wido Trith tho digoh

Answered: Image /qna-images/answer/39ed11e1-1db5-4c4f-ac1d-b433517bfa3a.jpg

| 31. Given the following elements of an irrigation canal: base of 4 meters, depth of water is 2 meters, height of embankment above the canal bottom is 3 meters, width of top of embankment is 2 meters, side slope of the left side is 1:1, side slope of the right side is 1.5:1, grade slope is 0.0002, and coefficient of roughness n 0.025. Compute the discharge of the canal in cubic meter per second using Kutter's formula.

| 31. Given the following elements of an irrigation canal: base of 4 meters, depth of water is 2 meters, height of embankment above the canal bottom is 3 meters, width of top of embankment is 2 meters, side slope of the left side is 1:1, side slope of the right side is 1.5:1, grade slope is 0.0002, and coefficient of roughness n 0.025. Compute the discharge of the canal in cubic meter per second using Kutter's formula.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A canal having side slope 1 to1 is proposed to be constructed in a cohesive soil to a depth of 5 m below ground surface. The soil properties are given below: Oa = 15°, C, = 12 kN/m², e = 1, G, = 2.65 Also for ¢, = 15°, ß = 45°, S̟ = 0.08, and for o = 6.8°, B = 45°, S̟ = 0.126 The factor of safety with respect to cohesion against failure of the bank slopes when there is a sudden drawdown of water in the canal will be
You must determine the normal depth for a flow in a rectangular canal. Presume flow to be uniform, the base of the canal to be 8m wide and the slope to be critical. The flow is 10 m3/s and the Manning coefficient is 0.012.
6. A 3.6 m wide rectangular channel carries water to a depth of 1.8 m. In order to measure the discharge, the channel width is reduces to 2.4 m and a hump of 0.30 m height is provided in the bottom. Calculate the discharge if water surface in the contracted section IQ-6.418 m/s] drops by 0.15 m. Assume no losses.
An irrigation canal has a rectangular cross section. At one point where the canal is 18.74 m wide and the water is 3.79 m deep, the water flows at 2.08 cm/s. At a second point downstream, but on the same level, the canal is 16.21 m wide, but the water flows at 10.8 cm/s. How deep is the water at this point? Express answers in meters (m).
A rectangular river channel 4.6 m wide carries water at a depth of 0.6 m. The slope of the channel is 1 in 400. As the channel has poor alignment and the bed is covered with stones about 75 mm to 150 mm in size, n is estimated to be between 0.04 and 0.08. Estimate the minimum and maximum discharge. What is the percentage difference in flow discharge?
8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage and outflow from the reservoir can be expressed as Storage: Outflow: where $=36000 - 18000 y (m²) Q=10y (m³/s) y = height of the reservoir level above the spillway crest in m. Route an inflow flood hydrograph which can be approximated by a triangle as I=0 at 1=0 h I-30 m³/s at 1 6 h (peak flow) I=0 at 1 26 h (end of inflow). Assume the reservoir elevation as 200.00 m at t=0 h. Use a time step of 2 h.
Given is the cross-section of a stream with uniform flow having a slope of 0.007 and the roughness coefficient of the stream bed is 0.025. Determine: a. Hydraulic radius b. Average velocity of the stream using Manning's coefficient and the corresponding discharge C. Average velocity of the stream using Kutter's coefficient and the corresponding discharge 5.5 m 6.0 m 6.0 m 6.0 m 5.5 m 2. 2.0 2.7 2.4
bottom width of trapezoid-shaped canal = 1.5 meters depth of flow = 1.5 meters side slopes = 3H : 2V channel slope = 3 meters/5000 meters n = 0.013 What is the discharge in this canal lined with concrete?
Manning's equation is Q = where Cm AR 2/3 1/2 n Q = Cm = = flow (m³/s) 1.49 USC system 1.00 SI system roughness factor for various boundary conditions area (m2) hydraulic radius (m) n = A = R == = S = slope of EGL (or HGL for steady uniform flow conditions) m/m area/wetted perimeter Transform the above equation to solve for pipe diameter (mm) expressed in terms of flow (L/s), pipe slope (%) and pipe roughness "n". The value of Cm 1s 1.00 for a metric equation. Express your answer in the simplest form mathematically. Check by assuming arbitrary values and comparing the results between the original equation and the transformed equation.
A trapezoidal channel is 6.0m wide and has side slope of 0.5 H: 1 V. If the bed slope of the channel is 0.0004 and the Manning's n=0.02, find the discharge which can make the channel a hydraulically efficient section.
An irrigation canal with a given cross-section is desired to be dimensioned hydraulically in the most appropriate way. The canal is made of concrete and has a slope of 1/m. The flow rate of the water passing through this canal is given in Q m^3/s, the Manning roughness coefficient n and the bottom slope of the canal in the data sheet. a) Find y and B values that give the most suitable cross section. b) If you want to pass this open canal with the help of circular pipes under a highway with the same inclination, how many D diameter pipes should be used? (pipe roughness: give in the table).
A channel carries irrigation water at an average velocity of 2 m/s. The channel is 650 m long, 2 m deep, and has a base width of 4.25 m. If the side slopes are 1:1. a. Determine the channel dimensions and area of a geometrically similar model constructed at 10:1 scale. b. Determine the discharge (flow rate) from the model required for kinematic similarity. 1 c. Determine the discharge (flow rate) from the model required for dynamic similarity using the Froude number.