OPPO Reno3 - ©Marie Phone Using the image and using the rated values of the single phase transformer compute for the following: Primary side terminal 8-4 induced voltage 14, compute for the voltage across terminal 5-9

OPPO Reno3 - ©Marie Phone Using the image and using the rated values of the single phase transformer compute for the following: Primary side terminal 8-4 induced voltage 14, compute for the voltage across terminal 5-9

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 18. In single phase transformer, if the secondary turns N2 is greater than the primary turns N1,…

Q: Question 2 A single phase 50 Hz core type transformer has rectangular cores 30 × 20 cm. and the…

A: The objective of the question is to find the number of turns per limb on the high and low voltage…

Q: 2 A 1000 kVA 11 kV/400 V ONAF cooled transformer works on a cycle of 3 hours heavy load and 21 hours…

A: Given that the peak load is 140% and can only be maintained for 0.5 hours per hour of time constant,…

Q: A 25 KVA single phase transformer has turns ratio of 100/29. If low voltage side is connected to 250…

A: Solution: Given data; KVA =25 KVA, single phase transformer ; turns ratio=N1N2…

Q: Q/A single-phase transformer with a capacity of 100 kVA and a voltage of 2000/400 and the equivalent…

Q: A 3-phase 100OKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: Consider a single phase transformer with primary and secondary turns of 1000 and 200 respectively…

A: Given:R1=10.5ΩR2=2.5ΩX1=12.5ΩX2=2.5ΩRm=15.55KΩXm=10KΩK=1000200=5

Q: 2-6. A 1000-VA, 230/115-V transformer has been tested to determine its equivalent cir- cuit. The…

A: Transformer of 1000 VA,230/115-v

Q: Explain the Different connections of Three Phase Transformer including the working principle

A: Electrical machines can be either generator, motors or transformers. They can be either Ac machines…

Q: The test results on a 100 KVA, 10000/1000 V, Y-Y 3-4 transfo

Q: 2/A single-phase transformer with a capacity of 100 kVA and a voltage of 2000/400 and the equivalent…

Q: Draw the equivalent circuit of a 10 KVA, 1860 / 400 V 1-phase transformer with R1=0.4 ohms, R2=0.03…

A: primary referred resistance=R1+R2' R2' is the secondary resistance referred to primary. Similarly…

Q: A 15-KVA, 2400/240-V transformer is to be tested to determine its excitation branch components, its…

A: The rated KVA of the transformer, S=15 KVA The voltage ratio, 2400/240 V, Results of open circuit…

Q: Q/A single-phase transformer with a capacity of 100 kVA and a voltage of 2000/400 and the equivalent…

Q: 10. Draw a neat diagram of a practical transform on load, with winding resistance and leakage…

A: Introduction: Transformer is a device that converts level of voltage, (increases or decreases)…

Q: B- the eddy current losses of 400V, 50 Hz transformer is 1600W and the total iron losses i 2500W.…

A: Transformer Transformer is a static electrical device which transfers power from one circuit to…

Q: A 3-phase 10OOKVA, 11000/416 transformer is delta-connected on the primary and star connected on the…

A: A transformer is an electrical machine which is used in AC circuit to either step up or step down…

Q: A single phase transformer is rat 2,424 V / 206 V. 60 Hz The eau

Q: Am 11 KV /33 KV 220 MVA, 60 Hz transformer is wooded at sy. with resistive to ad Ratio 21 KW at…

A: In this question we need to find a copper loss at 50% and 75% loading

Q: A 3-phase transformer is assembled by connecting three 720 -VA, 360/120 V single phase transformers…

A: A 3-phase, Y−Δ connected transformer is assembled by connecting three 720 VA, 360/120 V single-phase…

Q: A 100VA single-phase transformer inside a refrigerator has 100 turns in its primary coil and 20…

Q: A H.W.R. uses 4 : 1 transformer and a diode of internal resistance 100. If load resistance is 5000…

A: Given a half wave rectifier uses, Transformer with turns ratio, Np : Ns= 4 : 1 Internal resistance…

Q: What way the two electrical circuits are linked in transformer to change the values of alternating…

Q: Given this transformer with load, what is the expected phase of the primary and secondary voltage?…

A: The solution is provided in the following section.

Q: In single phase transformer, if the primary turns N1 is greater than the secondary turns N2, then…

A: N1>N2 Then V1>V2 C option are correct

Q: Q10) For the transformer shown in Figure below, determine (i) The turns ratio of the transformer…

A: A transformer has two windings - the primary and the secondary. The ratio of the number of turns in…

Q: 7- A 5KVA, 220/110v, SOHZ 1-phase transformer has Regt and Xeqt of 0.968Q and 1.9630 respectively.…

A: Solution - Given data, 5 KVA, 220/110V 1-phase transformer f = 50 Hz Req1 = 0.968 ohm Xeq1 = 1.963…

Q: Answer the following based on the 3-phase transformer configuration in figure: A- voltmeter V4 is…

A: Given circuit is of three phase transformer made by three single phase transformer

Q: B1(i) For the given circuit, find (i) the ammeter reading and (ii) R2 value. 8A R1=50 R2 R3 = 202…

A: Let ammeter reading as I3 current Then by using circuits Ohms law

Q: 6-Writ the procedure of no load test of Single phase transformer and draw the connection diagram of…

Concept explainers

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.

Question

TRANSFORMER
120 V
0.5 A
1
2
104 V
7
76 V
0.3 A
28 V
0.3A
0.3 A
60 V
0.5 A
60 V
0.5A
EE
RATING
J3
0 VA - 120/208/120 V
Lob-Velt
ARORATORY
8341-00
OPPO Reno3 · ©Marie Phone
Using the image and using the rated values of the single phase transformer
compute for the following:
Primary side terminal 8-4 induced voltage 14, compute for the voltage across
terminal 5-9
90

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Winding and Construction of the Rotor and Stator

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 120 kVA, 1350/330 V single phase transformer has the following parameters: R1 = 0.34 Q, X1 = 0.59 0, R2 = 0.014 Q, X1 = 0.029 Q, Rc = 380 and Xm = 320 Q. The no load current is 4.7 A at a power factor of 0.36 lagging and the no load losses are 4.6 kW. For a full load and 0.9 power factor lagging with 300 V load terminal voltage, determine (a) equivalent circuit parameters referred to primary side, (b) percentage regulation and (c) full load efficiency. O:01 AM
What is transformer di not use chatgpt
30-kVA, 2200/220-V, 50-Hz distribution transformer is tested for efficiencyand regulation as follows :O.C. test( Low voltage side ) : 220 V 4.2 A, 148 W S.C. test ( Low voltage side ) : 86 V 10.5 A, 360 W 1-The working current and resistance component of no-load are.........amper , .........ohm * 2-Efficiency at full-load and half the full-load at 0.8 p.f. lagging current. * 3-Equivalent resistance referred to primary & referred to secondary..........ohm , ..........ohm * 4-Regulation of transformer at 0.5 p.f. lagging current * 5-Equivalent reactance referred to primary & referred to secondary..........ohm , ..........ohm * 6-The magnetizing current and reactance component of no-load are.........amper , .........ohm *
I need the answer as soon as possible
A single-phase transformer has the following resistances: R1 = 3 ohms, X1 = 6 ohms, R2 = 6 ohms and X2 = 10 ohms. Find the turns ratio (N1/N2) if the sum of the equivalent resistances (Re1 + Re2) is 46.98 ohms.
Q/A single-phase transformer with a capacity of 100 kVA and a voltage of 2000/400 and the equivalent circuit elements are: As follows R1 = 0.1 02 x1 = 0.2 2 R2 = 0.25 2 X2 = 0.75 2 RO = 500 XO = 150 Q and feeds a load of 90 kVA at a voltage of 2000 volts and a power factor of 8.0 in delay. Calculate voltage and current Primary Royl ww JX eql
4. 100 kVA, 6800-240 V, 50 Hz single phase step down transformer has the following parameters: RLs-0.008Ω RHs-2.6Ω Ri-HS-500 0Ω XLS-0.015Ω XHs=5.22 Xm,HS=88002 Transformer is delivering 80% of rated load at rated voltage and 0.95 lagging power factor. Determine the following: a) The equivalent impedance of the transformer referred to primary. b) Input impedance of the combined transformer and load. c) Actual input voltage at HV side. d) Input impedance if load is disconnected. e) Exciting current at no load.
transformrs
Help me to solve this problem step by step. Don't copy from Chegg else I'll dislike.
Q4 Figure Q4 below shows the simplified per phase equivalent circuit of a 220 V star connected transformer. The parameters for the equivalent circuit is listed as follows: R1= 1.780 Ohm, R2 = 2.400 Ohm, Re = 0 Xi = 1.255 Ohm, X2 = 0.410 Ohm, XM = 15.000 Ohm Stray loss = 200 W, Core loss = 100 W RI jXi I2 jX2 IM Rc jXm R2 Figure Q4 (a) Find the line current of the transformer. Find the copper loss associated with the primary winding and secondary winding. (b) (c) Calculate the efficiency of the 3 phase transformer.
Under short circuit test, the short circuit voltage of transformer is O a. Equal to the rated voltage ОБ. O b. (3-5) % V rated O c. Maximum O d. Zero