Question 2 A single phase 50 Hz core type transformer has rectangular cores 30 × 20 cm. and the maximum allowable density is 1.05 tesla. Find the number of turns per limb on the high and low voltage sides for a voltage ratio of 3300/200 V. Take iron factor as 0.93. Question 3 [10]

Q: Whether a transformer shifts an ac waveform by 0° or 180° depends on the phasing of the waveform…

A: Shifts of ac waveform by 0 to 180 degree is depending on

Q: When the turns ratio of a transformer is 10 and the primary ac voltage is 6 V. the secondary voltage…

A: Given, Transformer turns ratio a=N1N2=10 Primary voltage V1=6 V

Q: Which of the following voltage (V), current (1), ar turns (N) characteristics apply for a step-up…

A: In this question we will define step up transformer....

Q: A single-phase transformer is required to step down the voltage from 1100 V to 230 V at 50 Hz. The…

A:

Q: Three Phase Transformer 3 Three Phase Transformer 4 Transformer 2 Transformer 4 Transformer 1…

A: Four circuit connections are given in the question.Note: For all the transformers the primary side…

Q: Look at the following figure and answer the following questions based on the fact the transformer is…

A: Given: The transformer is 240/480V to 120/240V 4kVA single phase:

Q: In a step-up transformer, the turn ratio is 1: 20. The resistance of 100 2 connected across the…

A: Given information is shown below:To find:

Q: In transformer, the hysteresis loss depends on, load current only frequency only flux density both…

A: