One way to think about the energy storedin an L-C circuit is to say that the circuit elements do positive or negative work on the charges thatmove back and forth through the circuit. What kind of force (electric or magnetic) does the inductor exert on the charges?

Q: Suppose that a rectangular toroid has 1500 windings and a self-inductance of 0.04 H. If the height…

A: Given : Number of turns, N= 1500 Self Inductance, L =0.04 H Height , h = 0.08 m  Energy stored , U=…

Q: Two coils are placed near each other and they have a mutual inductance of 879.1 mH. If the current…

A: mutual inductance(M)=879.1 mH=879.1×10-3H  current i(t)=0.5e-1,625.3t to find: induced emf at…

Q: A current of 4.25 A is going through a 7.5 mH inductor is switched off. It takes 8.09 ms for the…

A: Given: The current in the inductor is 4.25 A. The inductance of the inductor is 7.5 mH. The time…

Q: decrease the inductance

A: The factors in which inductance of a solenoid depends are to be discussed here.

Q: What percentage of the final current I0 flows through an inductor L in series with a resistor R ,…

A:

Q: If the current running through an inductor is increased by a factor of 3, by how much does the…

A: Given:- The  current running through an inductor is increased by a factor of 3 Find:- how much…

Q: The magniotude of the emf induced in an inductor is 1.5V when the current in the inductor is…

A:

Q: A solenoid with 500 turns and a length of 0.2 meters is carrying a current of 2.5 Amperes.…

A: Self-inductance (L) is a property of a coil or solenoid that quantifies its ability to induce an…

Q: Consider the circuit shown below. The circuit contains an inductor, 10.0 mH, a 60.0 V battery…

A:

Q: conducting rod with length of 20cm is pulled along the a rotated U-shaped (see the figure)…

A:

Q: At t=0 the open switch in figure is closed. By using kirchhoff's rule for the instantaneous currents…

A:

Q: Two resistors, R₁ = 47 k and R₂ = 50 k2, a 31.5 mH inductor, and a 47 V battery are used to form the…

A:

Q: A 10.7-V battery, a 4.92-2 resistor, and a 10.1-H inductor are connected in series. After the…

A: V = 10.7 Volts R = 4.92 ohm L = 10.1 H current = maximum

Q: The circuit in the figure below is located in a magnetic field whose magnitude varies with time…

A: By Faraday's law of electromagnetic induction. -dϕdt=ε=induced emf in loop.

Q: Tthe length of a moving conductor L=0.25m (you may assume that this is the distance from “rail to…

A: Given that:- Length of moving conductor=L=0.25m

Q: In and L-C circuit, C=3.19 microFarads and L=81.0 mH. During the oscillations the maximum current in…

A:

Q: The following picture shows a LONG conductor carrying current I. Nearby there is a conducting…

A: The expression for a magnetic field at a distance x due to a straight conductor carrying a current I…

Q: Two coils are placed near each other and they have a mutual inductance of 887.4 mH. If the current…

A:

Q: Inductors in series. Two inductors L1 = 1.06 H and L2 = 2.07 H are connected in series and are…

A:

Q: In the circuit shown in Fig. , switch S1 has beenclosed for a long enough time so that the current…

A: Given circuit:

Q: The voltage across an inductor is proportional to the inductor and the derivative of the current…

A: As we know that,          Voltage across Inductor is given by :…

Q: Consider the circuit shown below. а 12V 10тН 10Ω b- 200 What is the rate of change of the current in…

A:

Q: X ス メx ×

A:

Q: Inductors in series. Two inductors L1 = 1.13 H and L2 = 2.01 H are connected in series and are…

A: Expression for equivalent inductance when they are connected in series -  Leq = L1 + L2 Given values…

Q: The following picture shows a LONG conductor carrying current I. Nearby there is a conducting…

A: (a) The expression of the magnetic field (B) as a function of distance x is B→=μ0I2πx + (b) The…

Q: A long solenoid (cross-sectional area = 1.5 x 106 m², number of turns per unit length = 3587…

A: The cross-section area of the solenoid: The number of turns per unit length: The radius of the…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.